ABS Ram 1500 2014 User Guide

brake of the spinning wheel. This will allow more engine
torque to be applied to the wheel that is not spinning.
This feature remains active even if TCS and ESC are in
the “Partial Off” mode. Refer to “Electronic Stability
Control (ESC)” in this section of this manual. This brake
pressure modulation transfers drive torque from slipping
to non-slipping wheels to provide optimal forward trac-
tion.
Brake Assist System (BAS) — If Equipped
The BAS is designed to optimize the vehicle’s braking
capability during emergency braking maneuvers. The
BAS detects an emergency braking situation by sensing
the rate and amount of brake application and then
applies optimum pressure to the brakes. The system
applies optimum pressure to the brakes in emergency
braking conditions. This can help reduce braking dis-
tances. The BAS complements the ABS. Applying the
brakes very quickly results in the best BAS assistance. Toreceive the benefit of BAS, you must apply continuous
braking pressure during the stopping sequence. Do not
reduce brake pedal pressure unless braking is no longer
desired.
Once the brake pedal is released, the BAS is deactivated.
WARNING!
•
The BAS cannot prevent the natural laws of phys-
ics from acting on the vehicle, nor can it increase
braking efficiency beyond that afforded by the
condition of the vehicle brakes and tires or the
traction afforded.
• The BAS cannot prevent collisions, including those
resulting from excessive speed in turns, following
another vehicle too closely, or hydroplaning.
(Continued)
528 STARTING AND OPERATING

TIRE SAFETY INFORMATION
Tire MarkingsNOTE:
•P (Passenger) - Metric tire sizing is based on U.S.
design standards. P-Metric tires have the letter “P”
molded into the sidewall preceding the size designa-
tion. Example: P215/65R15 95H.
• European-Metric tire sizing is based on European
design standards. Tires designed to this standard have
the tire size molded into the sidewall beginning with
the section width. The letter Pis absent from this tire
size designation. Example: 215/65R15 96H.
• LT (Light Truck) - Metric tire sizing is based on U.S.
design standards. The size designation for LT-Metric
tires is the same as for P-Metric tires except for the
letters “LT” that are molded into the sidewall preced-
ing the size designation. Example: LT235/85R16.
1 — U.S. DOT Safety Standards
Code (TIN) 4 — Maximum Load
2 — Size Designation 5 — Maximum Pressure
3 — Service Description 6 — Treadwear, Traction and Temperature Grades
5
STARTING AND OPERATING 539

EXAMPLE:
Load Identification: ....blank.... = Absence of any text on the sidewall of the tire indicates a Standard Load (SL) tire
Extra Load (XL) = Extra load (or reinforced) tire
Light Load (LL) = Light load tire
C, D, E, F, G = Load range associated with the maximum load a tire can carry at a specified pressure
Maximum Load – Maximum load indicates the maximum load this tire is designed to carry
Maximum Pressure – Maximum pressure indicates the maximum permissible cold tire inflation pressure for
this tire
Tire Identification Number (TIN)
The TIN may be found on one or both sides of the tire,
however, the date code may only be on one side. Tires
with white sidewalls will have the full TIN, including the
date code, located on the white sidewall side of the tire. Look for the TIN on the outboard side of black sidewall
tires as mounted on the vehicle. If the TIN is not found on
the outboard side, then you will find it on the inboard
side of the tire.
542 STARTING AND OPERATING

connect the drive tube to the extension tube. Place the
jack under the axle as close to the tire as possible with the
drive tubes extending to the front. Connect the jack tube
extension and wheel wrench.4x2 and 4x4 Rear Jacking Location
For 4x2 and 4x4 trucks, when changing a rear wheel,
assemble the jack drive tube to the jack and connect the
drive tube to the extension tube. Place the jack under the
axle between the spring and the shock absorber with the
drive tubes extending to the rear.
4x4 Front Jacking Location
Rear Jacking Location (All)
662 WHAT TO DO IN EMERGENCIES

WARNING!
•Use only manufacturer’s recommended brake
fluid. Refer to “Fluids, Lubricants, and Genuine
Parts” in “Maintaining Your Vehicle” for further
information. Using the wrong type of brake fluid
can severely damage your brake system and/or
impair its performance. The proper type of brake
fluid for your vehicle is also identified on the
original factory installed hydraulic master cylinder
reservoir.
(Continued)
WARNING! (Continued)
•To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that has
been in a tightly closed container. Keep the master
cylinder reservoir cap secured at all times. Brake
fluid in a open container absorbs moisture from the
air resulting in a lower boiling point. This may
cause it to boil unexpectedly during hard or pro-
longed braking, resulting in sudden brake failure.
This could result in a collision.
• Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts, causing
the brake fluid to catch fire. Brake fluid can also
damage painted and vinyl surfaces, care should be
taken to avoid its contact with these surfaces.
(Continued)
718 MAINTAINING YOUR VEHICLE

The manufacturer will not stand behind any service
contract that is not the manufacturer’s service contract. It
is not responsible for any service contract other than the
manufacturer’s service contract. If you purchased a ser-
vice contract that is not a manufacturer’s service contract,
and you require service after the manufacturer’s New
Vehicle Limited Warranty expires, please refer to the
contract documents, and contact the person listed in
those documents.
We appreciate that you have made a major investment
when you purchased the vehicle. An authorized dealer
has also made a major investment in facilities, tools, and
training to assure that you are absolutely delighted with
the ownership experience. You will be pleased with their
sincere efforts to resolve any warranty issues or related
concerns.WARNING!
Engine exhaust, some of its constituents, and certain
vehicle components contain, or emit, chemicals
known to the State of California to cause cancer and
birth defects, or other reproductive harm. In addi-
tion, certain fluids contained in vehicles and certain
products of component wear contain, or emit, chemi-
cals known to the State of California to cause cancer
and birth defects, or other reproductive harm.
WARRANTY INFORMATION
See the Warranty Information Booklet, located on the
DVD, for the terms and provisions of Chrysler Group
LLC warranties applicable to this vehicle and market.
778 IF YOU NEED CONSUMER ASSISTANCE

Adding Engine Coolant (Antifreeze)............711
Adding Fuel ............................ .586
Additives, Fuel .......................... .580
Adjustable Pedals ........................ .187
Airbag ..................................68
Airbag Deployment ........................79
Airbag Light .............................76
Airbag Maintenance ........................81
Airbag, Side ..............................72
Airbag, Window (Side Curtain) ................72
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .701
Air Conditioner Maintenance .................702
Air Conditioning ......................... .361
Air Conditioning Controls ...................361
Air Conditioning Refrigerant .................702
Air Conditioning System ....................361
Air Pressure, Tires ........................ .552
Air Suspension .......................... .459
Alarm Light ............................ .289Alarm, Panic
.............................28
Alarm (Security Alarm) ......................22
Alarm System (Security Alarm) ................22
Alterations/Modifications, Vehicle ...............7
Antifreeze (Engine Coolant) ..................710
Disposal ............................. .713
Anti-Lock Brake System (ABS) ................527
Anti-Lock Warning Light ....................284
Appearance Care ........................ .725
Ashtray ............................... .231
Auto Down Power Windows ..................47
Automatic Door Locks ......................39
Automatic Headlights ..................... .170
Automatic High Beams .....................173
Automatic Transmission ....................403
Adding Fluid ......................... .723
Fluid and Filter Changes ..................724
Fluid Change ......................... .724
Fluid Level Check ...................... .721
784 INDEX

Fluid Type........................... .721
Shifting ............................. .412
Special Additives ...................... .721
Axle Fluid ............................. .719
Axle Lubrication (Axle Fluid) .................719
Back-Up Camera ......................... .210
Bar, Stabilizer/Sway System ..................472
Battery ................................ .701
Keyless Transmitter Replacement (RKE) ........30
Belts, Seat ...............................54
Body Builders Guide ........................6
Body Mechanism Lubrication .................704
B-Pillar Location ......................... .545
Brake Assist System ...................... .528
Brake Control System, Electronic ..............526
Brake Fluid ............................ .717
Brake System ........................... .524
Anti-Lock (ABS) ....................... .524Fluid Check
.......................... .717
Master Cylinder ....................... .717
Parking ............................. .521
Warning Light ........................ .286
Brake/Transmission Interlock .................403
Bulb Replacement ........................ .743
Bulbs, Light ............................ .124
Cab Top Clearance Lights ...................752
Camera, Rear ........................... .210
Camper ............................... .264
Capacities, Fluid ......................... .755
Caps, Filler Oil (Engine) .......................... .699
Power Steering ........................ .520
Radiator (Coolant Pressure) ................712
Carbon Monoxide Warning ..................121
Cargo Light ............................ .178
Car Washes ............................ .726
10
INDEX 785