service indicator Ram 3500 Chassis Cab 2016 User Guide

Page 563 of 669

(EVIC)” or “Driver Information Display (DID)” in “Un-
derstanding Your Instrument Panel” for further informa-
tion. Tighten the fuel filler cap properly and push the
SELECT button to turn off the message. If the problem
continues, the message will appear the next time the
vehicle is started.
A loose, improperly installed, or damaged fuel filler cap
may also turn on the Malfunction Indicator Light (MIL).
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction Indicator Light (MIL)” is functioning and is not on when
the engine is running, and that the OBD II system is
ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may
notbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not
ready for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition actuated test, which
you can use prior to going to the test station. To check if
your vehicle’s OBD II system is ready, you must do the
following:
1. Cycle the ignition switch to the ON position, but do not crank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over.7
MAINTAINING YOUR VEHICLE 561

Page 564 of 669

2. As soon as you cycle the ignition switch to the ONposition, you will see the Malfunction Indicator Light
(MIL) symbol come on as part of a normal bulb check.
3. Approximately 15 seconds later, one of two things will happen:
• The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle’s OBD II system is not readyand you should
not proceed to the I/M station.
• The MIL will not flash at all and will remain fully
illuminated until you place the ignition in the off
position or start the engine. This means that your
vehicle’s OBD II system is readyand you can proceed
to the I/M station.
If your OBD II system is not ready,you should see your
authorized dealer or repair facility. If your vehicle was recently serviced or had a battery failure or replacement,
you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
system to update. A recheck with the above test routine
may then indicate that the system is
now ready.
Regardless of whether your vehicle’s OBD II system is
ready or not, if the MIL is illuminated during normal
vehicle operation you should have your vehicle serviced
before going to the I/M station. The I/M station can fail
your vehicle because the MIL is on with the engine
running.
REPLACEMENT PARTS
Use of genuine MOPAR parts for normal/scheduled
maintenance and repairs is highly recommended to en-
sure the designed performance. Damage or failures
caused by the use of non-MOPAR parts for maintenance
and repairs will not be covered by the New Vehicle
Limited Warranty.
562 MAINTAINING YOUR VEHICLE

Page 628 of 669

MAINTENANCE SCHEDULE
Your vehicle is equipped with an automatic oil change
indicator system. The oil change indicator system will
remind you that it is time to take your vehicle in for
scheduled maintenance.
Based on engine operation conditions, the oil change
indicator message will illuminate. This means that ser-
vice is required for your vehicle. Operating conditions
such as frequent short-trips, trailer tow, extremely hot or
cold ambient temperatures, and E85 fuel usage will
influence when the “Oil Change Required” message is
displayed. Severe Operating Conditions can cause the
change oil message to illuminate as early as 3,500 miles
(5,600 km) since last reset. Have your vehicle serviced as
soon as possible, within the next 500 miles (805 km).
Your authorized dealer will reset the oil change indicator
message after completing the scheduled oil change. If a
scheduled oil change is performed by someone otherthan your authorized dealer, the message can be reset by
referring to the steps described under “Electronic Vehicle
Information Center (EVIC)/Driver Information Display
(DID)” in “Understanding Your Instrument Panel” for
further information.
Gasoline Engines:
Under no circumstances should oil change intervals
exceed 8,000 miles (13,000 km), twelve months or 350
hours of engine run time, whichever comes first. The 350
hours of engine run or idle time is generally only a
concern for fleet customers.
Severe Duty:
Change Engine Oil at 4,000 miles (6,500 km) if the vehicle
is operated in a dusty and off road environment or is
operated predominately at idle or very low engine
RPM’s. This type of vehicle use is considered Severe Duty
626 MAINTENANCE SCHEDULES

Page 657 of 669

Center Mounted Stop....................618
Courtesy/Reading ................166, 167, 204
Cruise ........................... .264, 265
Daytime Running ...................... .160
Engine Temperature Warning ...............241
Exterior ..............................117
Fog ......................... .163, 257, 617
Four-Wheel Drive Indicator ................423
Hazard Warning Flasher ..................532
Headlights ........................... .159
High Beam ........................... .169
High Beam/Low Beam Select ...............169
Hill Descent Control Indicator ..............452
Illuminated Entry ........................23
Interior ....................165, 166, 167, 204
Low Fuel ............................ .254
Malfunction Indicator (Check Engine) .........248
Park ............................... .262
Passing ............................. .169Seat Belt Reminder
..................... .236
Security Alarm ........................ .240
Service .......................... .614, 615
Tire Pressure Monitoring (TPMS) .........252, 484
Traction Control ....................... .449
Transfer Case ......................... .423
Turn Signal ..................117, 168, 263, 615
Warning (Instrument Cluster Description) . . .241, 263
Limited-Slip Differential .................430, 592
Loading Vehicle ......................... .500
Tires ............................... .462
Locks ..................................36
Automatic Door .........................38
Child Protection .........................39
Door .................................36
Power Door ............................38
Low Tire Pressure System ...................484
Lubrication, Body ........................ .576
10
INDEX 655

Page 658 of 669

Lug Nuts....................... .533, 541, 543
Maintenance Free Battery ....................572
Maintenance Procedures ....................563
Maintenance Schedule ..................... .626
Malfunction Indicator Light (Check Engine) . . .248, 561
Manual, Service ......................... .640
Manual Transmission Fluid Level Check ...................... .593
Memory Seat ........................... .151
Methanol .............................. .495
Mirrors ............................... .124
Electric Powered ....................... .134
Heated .............................. .136
Memory ............................. .151
Outside ............................. .132
Rearview ......................... .124, 132
Trailer Towing ........................ .137
Modifications/Alterations, Vehicle ...............7Monitor, Tire Pressure System
................484
MOPAR Parts ........................ .562, 639
MTBE/ETBE ........................... .495
Multi-Function Control Lever .................168
Navigation System (Uconnect GPS) .............201
New Vehicle Break-In Period ..............112,113
Occupant Restraints ........................49
Octane Rating, Gasoline (Fuel) ................494
Oil, Engine ......................... .564, 622
Capacity ............................ .621
Change Interval ....................... .565
Dipstick ............................. .564
Disposal ............................. .566
Filter ............................ .566, 622
Filter Disposal ........................ .566
Identification Logo ..................... .565
Pressure Warning Light ...................243
656 INDEX

Page 665 of 669

Traction............................... .430
Traction Control ......................... .445
Trailer Sway Control (TSC) ..................451
Trailer Towing .......................... .502
Cooling System Tips .....................519
Hitches ............................. .507
Minimum Requirements ..................509
Mirrors ............................. .137
Trailer And Tongue Weight ................508
Wiring .............................. .517
Trailer Towing Guide ...................... .508
Trailer Weight ........................... .508
Transfer Case ........................... .593
Electronically Shifted .....................423
Fluid ............................... .624
Transmission ........................... .593
Automatic ........................ .404, 593
Fluid ............................... .624
Shifting ............................. .401Transmitter Battery Service (Remote Keyless Entry) . .29
Transmitter Programming (Remote Keyless Entry) . . .24
Transmitter, Remote Keyless Entry (RKE)
.........24
Transporting Pets .........................112
Tread Wear Indicators ..................... .477
Turn Signals ..................... .168, 263, 615
Uconnect Customer Programmable Features ........317, 335
Operation ............................ .339
Uconnect Settings ...................... .307
Uconnect Settings ....................317, 335
Uconnect 8.4A/8.4AN Voice Recognition Additional Information ...................390
Do Not Disturb ....................... .389
General Information .....................390
Siri Eyes Free ......................... .389
Uconnect 8.4 Settings Customer Programmable Features — Units .....326
10
INDEX 663

Page:   < prev 1-10 11-20