lock RAM CHASSIS CAB 2012 Owners Manual

NOTE: Use only manufacturer approved A/C System
Sealers, Stop Leak Products, Seal Conditioners, Compres-
sor Oil, or Refrigerants.
Refrigerant Recovery And Recycling
R-134a Air Conditioning Refrigerant is a hydrofluoro-
carbon (HFC) that is endorsed by the Environmental
Protection Agency (EPA) and is an ozone-saving product.
However, the manufacturer recommends that air condi-
tioning service be performed by authorized dealers or
other service facilities using recovery and recycling
equipment.
Front Prop Shaft Lubrication – Four-Wheel Drive
Models
Lubricate the front driveshaft grease fitting at each oil
change. Refer to the “Maintenance Schedule” for the
proper maintenance intervals. Use MOPAR  Type MS-
6560 (lithium-based grease), or equivalent. Body Lubrication
Locks and all body pivot points, including such items as
seat tracks, door hinge pivot points and rollers, liftgate,
tailgate, sliding doors and hood hinges, should be lubri-
cated periodically with a lithium based grease, such as
MOPAR  Spray White Lube or equivalent, to assure
quiet, easy operation and to protect against rust and
wear. Prior to the application of any lubricant, the parts
concerned should be wiped clean to remove dust and
grit. After lubricating, excess oil and grease should be
removed. Particular attention should also be given to
hood latching components to ensure proper function.
When performing other underhood services, the hood
latch, release mechanism and safety catch should be
cleaned and lubricated.412 MAINTAINING YOUR VEHICLE

The external lock cylinders should be lubricated twice a
year, preferably in the Fall and Spring. Apply a small
amount of a high quality lubricant such as MOPAR 
Lock Cylinder Lubricant or equivalent directly into the
lock cylinder.
Windshield Wiper Blades
Clean the rubber edges of the wiper blades and the
windshield periodically with a sponge or soft cloth and a
mild nonabrasive cleaner. This will remove accumula-
tions of salt or road film.
Operation of the wipers on dry glass for long periods
may cause deterioration of the wiper blades. Always use
washer fluid when using the wipers to remove salt or dirt
from a dry windshield.
Avoid using the wiper blades to remove frost or ice from
the windshield. Keep the blade rubber out of contact with
petroleum products such as engine oil, gasoline, etc. NOTE: Life expectancy of wiper blades varies depend-
ing on geographical area and frequency of use. Poor
performance of blades may be present with chattering,
marks, water lines or wet spots. If any condition is
present please proceed to clean wiper blades with humid
cloth removing any debris that may be affecting its
function.
Adding Washer Fluid
The fluid reservoir is located under the hood and should
be checked for fluid level at regular intervals. Fill the
reservoir with windshield washer solvent only (not ra-
diator antifreeze). When refilling the washer fluid reser-
voir, take some washer fluid and apply it to a cloth or
towel and wipe the wiper blades clean. This will help
blade performance.
To prevent freeze-up of your windshield washer system
in cold weather, select a solution or mixture that meets or
7 MAINTAINING YOUR VEHICLE 413

otherwise the cavity number of each fuse is stamped on
the inside cover that corresponds to the following chart. Cavity Cartridge
Fuse Mini
Fuse Description
J01 40 Amp
Green Trailer Tow
J02 30 Amp
Pink Electric Brake
J03 30 Amp
Pink Diesel Powertrain
Control Module – If
Equipped
J04 25 Amp
Natural Driver Door Node
J05 25 Amp
Natural Passenger Door Node
J06 40 Amp
Green Antilock Brakes
Pump/Stability
Control SystemTotally Integrated Power Module436 MAINTAINING YOUR VEHICLE

Cavity Cartridge
Fuse Mini
Fuse Description
J07 30 Amp
Pink Antilock Brakes
Valve/Stability Con-
trol System
J08 40 Amp
Green Power Seat
J10 30 Amp
Pink Sway Bar Module – If
Equipped
J11 30 Amp
Pink Transfer Case Module
J12 30 Amp
Pink Rear Defroster
J13 60 Amp
Yellow Main Ignition Off
Draw (IOD) Fuse
J14 20 Amp
Blue Trailer Tow Lamps/
Park Lamps
J15 40 Amp
Green Front Blower Cavity Cartridge
Fuse Mini
Fuse Description
J17 40 Amp
Green Starter Motor Sole-
noid
J18 20 Amp
Blue Powertrain Control
Module Transmission
Range
J19 60 Amp
Yellow Rad Fan Motor HI/
Rad Fan Motor Low
J20 30 Amp
Pink Front Wiper Ground/
Low/High
J21 20 Amp
Blue Washer Control
J22 25 Amp
Natural Sunroof Module
M1 15 Amp
Blue Stop Switch Lamp
M5 25 Amp
Natural 115V AC Inverter
7 MAINTAINING YOUR VEHICLE 437

Cavity Cartridge
Fuse Mini
Fuse Description
M33 10 Amp
Red Powertrain Control
Module
M34 10 Amp
Red Park Assist Module/
Climate Control Sys-
tem Module/IR
Sensor/Compass
Module
M35 15 Amp
Blue Left Front & Rear
Parklamps
M36 20 Amp
Yellow Power Outlet (Instru-
ment Panel or Center
Console) Cavity Cartridge
Fuse Mini
Fuse Description
M37 10 Amp
Red Antilock Brakes/
Stability Control Sys-
tem Module/
Stoplamp Switch
M38 25 Amp
Natural All Door Lock &Un-
lock
CAUTION!• When installing the totally integrated power mod-
ule cover, it is important to ensure the cover is
properly positioned and fully latched. Failure to
do so may allow water to get into the totally
integrated power module and possibly result in a
electrical system failure.
(Continued)440 MAINTAINING YOUR VEHICLE

CAUTION! (Continued)• When replacing a blown fuse, it is important to
use only a fuse having the correct amperage rating.
The use of a fuse with a rating other than indicated
may result in a dangerous electrical system over-
load. If a properly rated fuse continues to blow, it
indicates a problem in the circuit that must be
corrected.
VEHICLE STORAGE
If you are storing your vehicle for more than 21 days, we
recommend that you take the following steps to mini-
mize the drain on your vehicle’s battery:
• Disconnect the Ignition-Off Draw (IOD) fuse located in
the Integrated Power Module, located in the engine
compartment. The IOD cavity includes a snap-in re-
tainer that allows the fuse to be disconnected without
removing it from the fuse block. • As an alternative to the above steps you may discon-
nect the negative cables from both batteries.
• Any time you store your vehicle or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
NOTE:
• When reinstalling the IOD fuse push firmly until fully
seated; the gauges in the instrument cluster will do a
full sweep when the ignition switch is turned to the
RUN position. This is a normal condition.
• When the vehicle is shipped from the factory, the IOD
fuse is in the up or extracted position. If the radio,
interior lamps, keyless entry or other features do not
work with the key OFF, check the position of the fuse
7 MAINTAINING YOUR VEHICLE 441

8. Reach through the access hole of the wheel house
splash shield and lift the slide lock upward far enough to
disengage it from the lock post on the back of the front
lamp unit housing.
9. Remove the headlamp assembly. Grasp the outboard
edge of the lamp and pull it straight forward to disen-
gage the ball stud from the plastic grommet. 10. Disconnect electrical connectors.
11. Replace bulb(s) as necessary.
CAUTION!• Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
• Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the bulb
socket, or the lamp wiring.
NOTE: There are access covers over both headlamp
bulb access holes in the quad front lamp unit housing (if
equipped). These covers MUST be reinstalled after the
bulb has been replaced.444 MAINTAINING YOUR VEHICLE

Fog Lamps – If Equipped
1. Reach under and behind the front bumper to access
the back of the front fog lamp housing.
2. Disconnect the fog lamp wiring harness connector
from the fog lamp bulb.
3. Rotate the bulb counterclockwise 1
4
turn to unlock the
bulb from the housing.
4. Pull the bulb straight out from the housing.
CAUTION!Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result. Center High-Mounted Stoplamp (CHMSL) With
Cargo Lamp
1. Remove the two screws holding the housing/lens to
the body as shown.
7 MAINTAINING YOUR VEHICLE 445

Adding Engine Coolant (Antifreeze) .......... 418
Adding Fuel ........................... 340
Adjustable Pedals ....................... 158
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 408
Air Conditioner Maintenance ............... 411
Air Conditioning ........................ 256
Air Conditioning Controls ................. 256
Air Conditioning Refrigerant ............. 41 1,412
Air Conditioning System ............. 256,260,411
Air Conditioning, Operating Tips ............ 267
Air Pressure, Tires .................... 319,330
Airbag ................................ 52
Airbag Deployment ....................... 60
Airbag Light ..................... 58,62,79,200
Airbag Maintenance ....................... 61
Airbag, Side ............................ 57
Airbag, Window (Side Curtain) ............... 57
Alarm (Security Alarm) .................... 19
Alarm Light ........................... 192 Alarm System (Security Alarm) ............... 19
Alarm, Panic ............................ 24
Alterations/Modifications, Vehicle ............. 7
Antenna, Satellite Radio ................... 243
Anti-Lock Warning Light ............... 200,308
Anti-Theft Security Alarm (Theft Alarm) ........ 19
Anti-Theft System ........................ 19
Antifreeze (Engine Coolant) ................ 418
Capacities .......................... 449
Disposal ........................... 420
Appearance Care ........................ 430
Ashtray ............................... 169
Assistance Towing ....................... 107
Auto Down Power Windows ................ 35
Automatic Dimming Mirror ................. 87
Automatic Door Locks ..................... 32
Automatic Headlights .................... 148
Automatic Temperature Control (ATC) ......... 260482 INDEX

Automatic Transmission
Adding Fluid ....................... 429
Fluid and Filter Changes ............... 430
Fluid Level Check ................. 427,428
Fluid Type ...................... 427,451
Shifting ........................... 278
Special Additives ..................... 428
Axle Fluid ....................... 425,426,451
Axle Lubrication (Axle Fluid) ............ 425,426
B-Pillar Location ........................ 314
Battery ............................... 409
Keyless Transmitter Replacement (RKE) ..... 25
Saving Feature (Protection) .............. 152
Belts, Seat ............................ 39,79
Body Builders Guide ....................... 6
Body Mechanism Lubrication ............... 412
Brake Fluid ......................... 423,451 Brake System ........................ 306,423
Anti-Lock (ABS) ..................... 307
Fluid Check ........................ 423
Master Cylinder ..................... 423
Parking ........................... 304
Warning Light ....................... 197
Brake/Transmission Interlock ............... 278
Bulb Replacement ....................... 443
Bulbs, Light .......................... 81,442
Cab Top Clearance Lights .................. 447
Calibration, Compass ..................... 215
Capacities, Antifreeze (Engine Coolant) ........ 449
Capacities, Fluid ........................ 449
Caps, Filler
Oil (Engine) ........................ 407
Power Steering ...................... 303
Radiator (Coolant Pressure) ............. 419
Car Washes ............................ 431
10 INDEX 483