ABS RENAULT ESPACE 2000 J66 / 3.G Technical Note 3426A Workshop Manual

Downloaded from www.Manualslib.com manuals search engine ENGINE AND PERIPHERALS
Engine and transmission assembly
10
10-3
Engine and transmission assembly
Parts to order: high pressure circuit plugs kit
Part No.: 77 01 206 381. SPECIAL TOOLING REQUIRED
Mot. 1390 Universal mounting
Mot. 1410 Tool for unlocking the snap
couplings in the refrigerant
circuit
Dir. 1282 -01 Spanner for undoing the
steering rack union
Dir. 1282 -02 Spanner for undoing the
steering rack union
ESSENTIAL SPECIAL TOOLING
Two-post lift
Safety pad or belts
TIGHTENING TORQUES (in daN.m)
Shock absorber base mounting bolts
Ø M16 x 200 20
Driveshaft gaiter mounting bolt 2.5
Wheel bolts 10
Engine tie-bar bolts 10
Suspended mounting bolt to gearbox 5.5 to 6.5
Rubber suspended mounting nut to
the front left side member 5.5 to 8
Mounting bolt for front right
suspended mounting cover to engine 6.2
Mounting bolt for the movement
limiter of the upper front right hand
suspended engine mounting 10.5
Mounting nut for the rubber pad on
the front right suspended engine
mounting cover 3 to 4.5

Downloaded from www.Manualslib.com manuals search engine COOLING SYSTEM
Suspended mountings
19
19-4
Suspended mountings
The right-hand suspended mounting is fitted with a
rear travel limiter linkage.
When removing the cover, linkage or cast iron
mounting attached to the cage, respect the tightening
procedure below which has been adapted for removed
parts.
Fit in the following order:
–the cast iron linkage mounting (1) on the shock
absorber cage and tighten the bolts (A) to 3 daN.m,
–the linkage (2) on the mounting (1) without tightening
it,
–the rubber pad (3) on the cage and tighten the bolts
(C) by 5 to 6.5 daN.m,
–the suspended engine mounting cover (4) on the
rubber pad (3) and fix to the linkage (2). Tighten the
linkage (2) mounting bolt (B) on the mounting (1) to
10.5 daN.m.Offer up the engine and tighten the cover mounting
bolts (D) on the engine to 6.2 daN.m.
Tighten the cover mounting bolt (E) on the rubber pad
(3) to 6.2 daN.m and the linkage connecting bolts (F)
on the cover (4) to 10.5 daN.m.