lights RENAULT KANGOO 1997 KC / 1.G Foult Finding - Injection Workshop Manual

JF5111.0
INJECTION
Fault finding - Status and parameter checks
17
E7J 780
engine
Engine stopped, ignition on.NOTES
Order of
operationsFunction to be
checkedAction Bargraph Display and notes Fault finding
6Throttle
position
potentiometer
.No load
# 17
Accelerator
pedal
slightly
depressed
Full load
# 1716 < X < 50
185 < X < 243
DIAG 2
7Pressure sensor
# 01X =Atmospheric pressureDIAG 9
8Coolant
temperature
sensor# 02X = Engine temperature
± 5 °CDIAG 3
9Air
temperature
sensor# 03X = Temperature under
bonnet ± 5 °CDIAG 4
10 Fan assemblyG17*Fan must operateDIAG 17
11Fault warning
lightSwitch
ignition onFault warning light must
illuminate then
extinguishDIAG 19
2
2
2
17-31

JSA052.0
INJECTION
Fault finding - Status and parameter checks
17
D7F 710
engine -
55 tracks
Engine stopped, ignition on.NOTES
Order of
operationsFunction to be
checkedAction Bargraph Display and notes Fault finding
6Throttle
position
potentiometer
.No load
# 17
Accelerator
pedal
slightly
depressed
Full load
# 1710 < X < 50
185 < X < 245
DIAG 2
7Pressure sensor
# 01X = Atmospheric
pressureDIAG 9
8Coolant
temperature
sensor# 02X = Engine temperature
± 5 °CDIAG 3
9Air
temperature
sensor# 03X = Temperature under
bonnet ± 5 °CDIAG 4
10 Fan assemblyG17*The fan must operateDIAG 17
11 Fault warning
lightSwitch
ignition onThe fault warning light
must illuminate then
extinguishDIAG 19
2
2
2
17-176

B76531.0
ELECTRONICALLY CONTROLLED HYDRAULIC SYSTEMS
Fault finding - Interpretation of XR25 bargraphs
38
ABS BOSCH
5.3
AFTER REPAIR
13Fiche n° 53
Bargraph 13 left hand side extinguished, brake pedal depressed
Carry out checks only if illumination of the bargraph is not consistent with the
pedal position. NOTES
Bargraph 13 right and left
Brake pedalIlluminated on left hand side if pedal depressed.
Illuminated on right hand side if pedal not depressed.

BG 13 right remains permanently illuminated.
If brake lights are operating
:
- Ensure continuity between dashboard / rear left R2 connector on track 7 and track 14 of the ABS
computer connector .
Dashboard / ABS R36 intermediate connector (track 8).
If brake lights are not operating
:
- Check condition and adjustment of brake light switch as well as the 15A fuse for the brake lights (in
the passenger compartment connection unit). Replace if necessary.
- Disconnect the brake light switch, then check / ensure presence of + after ignition feed on track A3
of the connector
- Check operation of brake light switch (closed contact between tracks A3 and B1).
- Check and ensure continuity between track B1 of the brake light switch connector and the dashboard
/ rear left hand side R2 connector on track 7.
Bargraph 13 permanently illuminated on left hand side
- Check the condition and adjustment of the brake light switch. Replace if necessary.
- Check the operation of the brake light switch contact (closed contact between tracks A3 and B1).
Replace the brake light switch if there is permanent continuity between the two tracks.
- Check and ensure insulation from 12 volts of the connection between track B1 of the brake light
switch connector and track 14 of the ABS computer connector .
Intermediate connectors : Dashboard / ABS R36 on track 8.
Dashboard / rear left hand side R2 on track 7.
Carry out a road test followed by a check with the XR25 kit.
38-17