airbag RENAULT KANGOO 2013 X61 / 2.G Passenger Comparment Connection Unit Workshop Manual
Page 5 of 33
87B-5V1 MR-376-X76-87B000$040.mif
87B
UCH
VDiag No.: 0F
UCH CONFIGURATIONS
The configuration options for the UCH are:
*RAID: Renault Anti-Intruder Device.
*CPE: Electric central door locking.
SDO*: Single Door Opening.Title and position on the diagnostic tool Configuration
Illumination of hazard warning lights upon impact (LC009)
SC008 UCH type Timed courtesy light (LC047)
Courtesy light timer (LC168)
Key type (LC097)
Airbag (LC113)
Automatic relocking (LC012)
Authorisation of RAID* function by diagnostic tool (LC170)
Radio frequency function (LC171)
Type of CPE* button (LC172)
Rear screen wiper (LC064)SC008 UCH type
SDO* (LC186)CF272 "SDO*"
PASSENGER COMPARTMENT CONNECTION UNIT
Fault finding – Configuration
Page 9 of 33
87B-9
AFTER REPAIRFollow the instructions.
Deal with any other faults.
Clear the stored faults.
V1 MR-376-X76-87B000$070.mif
87B
UCH
VDiag No.: 0F
DF184
STOREDIMPACT DETECTED SIGNAL
NOTESThe fault is declared stored after an impact is detected.
Perform fault finding on the airbag function (see 88C, Airbags and pretensioners).
If the fault is still present, contact the Techline
UCH_V0F_DF184M
PASSENGER COMPARTMENT CONNECTION UNIT
Fault finding – Interpretation of faults
Page 11 of 33
87B-11
AFTER REPAIRFollow the instructions.
Deal with any other faults.
Clear the stored faults.
V1 MR-376-X76-87B000$070.mif
PASSENGER COMPARTMENT CONNECTION UNIT
Fault finding – Interpretation of faults87B
UCH
VDiag No.: 0F
DF273
PRESENT
OR
STOREDIMPACT CONNECTION
NOTESSpecial notes:
The fault is present 8 seconds after the ignition is switched on and becomes stored
after the ignition is switched off.
Note:
If this fault is present, the door locking function while driving is inhibited.
Special note:
Use Wiring Diagrams Technical Note for Kangoo VLL.
Perform fault finding on the airbag function (see 88C, Airbags and pretensioners).
Check the connection and condition of the UCH connectors, component code 645.
If the connector or connectors are faulty and there is a repair procedure (see Technical Note 6015A, Electrical
wiring repair, Wiring: Precautions for repair), repair the connector, otherwise replace the wiring.
Check the insulation, continuity and absence of interference resistance on the following connection:
●60BR between components 645 and 756.
If the connection is faulty and there is a repair procedure (see Technical Note 6015A, Electrical wiring repair,
Wiring: Precautions for repair), repair the wiring, otherwise replace it.
If the fault is still present, contact the Techline
UCH_V0F_DF273