engine RENAULT KANGOO 2013 X61 / 2.G Wipers And Washers Workshop Manual

85A-10V1 MR-376-X76-85A000$040.mif
WIPERS - WASHERS
Fault finding – Function85A
UCH
Vdiag No.: 0F
Heated rear screen time delay
This output controls a diode relay which is external to the UCH, delivering the power to supply the heated rear
screen.
The de-icing time delay is activated by pressing the heated rear screen button located on the central console front
panel.
The heated rear screen time delay is deactivated:
– by pressing the button again if the time delay between activation and deactivation is less than 50 seconds,
– automatically if the time delay has elapsed,
– directly if there is a cut in the + after ignition feed or engine speed signal.
The minimum time delay between two presses of the button so that the command is taken into account, should not
be less than 200 ms.

85A-15V1 MR-376-X76-85A000$080.mif
85A
UCH
Vdiag No.: 0F
NOTESOnly perform this conformity check after a complete check with the diagnostic tool.
The values indicated in this conformity check are given as examples.
Test conditions: Engine stopped, ignition on.
FunctionParameter or status
Checked or actionDisplay
and notesFault finding
Windscreen
wiperET027:Windscreen wiper
park positionActive when the wiper
control is in the
intermittent speed
position at each wiper
stop.In the event of a fault,
apply the interpretation of
the fault DF097
Windscreen wiper park
position.
ET097:Rear screen wiper
park positionActive when the wiper
control is in the
intermittent speed
position at each wiper
stop.In the event of a fault,
apply the interpretation of
fault DF040 Rear screen
wiper park position.
ET558:Windscreen wiper
speed setting
selectionYes when the wiper
control is in the
intermittent speed
position.In the event of a fault,
apply the interpretation of
status ET558.
ET555:Rear screen wiper
signalPresent during the rear
screen wiper command.In the event of a fault,
apply the interpretation of
status ET555
Windscreen
washerET492:Windscreen
washer signalPresent during the
windscreen washer/wiper
command.In the event of a fault,
apply the interpretation of
status ET492
ET557:Rear screen
washer signalPresent during the rear
screen washer/wiper
command.In the event of a fault,
apply the interpretation of
status ET557
UCH_V0F_CCONF
WIPERS - WASHERS
Fault finding – Conformity check