battery capacity RENAULT MEGANE 2000 X64 / 1.G Owners Manual

Downloaded from www.Manualslib.com manuals search engine QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T5.WIN 24/2/2001 14:44-page19
5.19
BATTERY(breakdown) (continued)
When a large number of accessories
are fitted to the vehicle, have them
connected to+ after ignition feed.
In this case, it is advisable to have
your vehicle fitted with a battery
which has an increased nominal
capacity. Consult your Renault
Dealer.
If your vehicle is to be left stationary
for a relatively long time,
disconnect the battery or have it
recharged regularly, in particular
during cold weather. The
equipment with a memory, radio
andtripcomputerwillthenhaveto
be reprogrammed. The battery must
be stored in a cool dry place,
protected from frost.
Specific procedures may be
required to charge some
batteries. Consult your
Dealer.
Avoid all risk of sparks which may
cause an immediate explosion and
charge the battery in a
well-ventilated area. Risk of
serious injury.

Downloaded from www.Manualslib.com manuals search engine 41
A
2
3
B
QXBIUDB*T[G      3DJH 
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T5.WIN 24/2/2001 14:44-page20
5.20
BATTERY: breakdown(continued)
Starting the vehicle using the
battery from another vehicle
Proceed as follows when starting
your vehicle from another vehicle’s
battery:
Obtain suitable jump leads (with a
large cross section) from a Renault
Dealer or, if you already have jump
leads, ensure that they are in perfect
condition.
The two batteries must have an
identical nominal voltage: 12 volts.
The battery supplying the current
should have a capacity (amp-hours,
Ah) which is at least the same as
that of the discharged battery.
An iced-up battery must be thawed
out before current is supplied to it.
Ensure that there is no risk of
contact between the two vehicles
(risk of short circuiting when the
positive terminals are connected)
and that the discharged battery is
properly connected.
Switch off your vehicle ignition.
Start the engine of the vehicle
supplying the current and run it at
an average speed.Secure the positive cable (+)Ato
the (+) terminal1of the discharged
battery, then to (+) terminal2of the
battery supplying the current.
Secure the negative cable (–)Bto
the (–) terminal3of the battery
supplying the current and then to
the (–) terminal4of the discharged
battery.Check that there is no contact
between cablesAandBand that
cableA(+) is not touching any
metal parts on the vehicle
supplying the current.
Start the engine as you would
normally. As soon as it starts,
disconnect cablesAandBin
reverse order (4-3-2-1).