charging RENAULT SCENIC 2010 J95 / 3.G Engine Compartment Connection Unit Workshop Manual

Page 16 of 56

87G - 16
ENGINE COMPARTMENT CONNECTION UNIT
Fault finding - Conformity check
87G
V6 MR-372-J84-87G000$528_eng.mif
UPC
Vdiag No.: 44ENGINE COMPARTMENT CONNECTION UNIT
Fault finding - Conformity check
MAIN SCREEN
NOTESOnly check conformity after a complete check using the diagnostic tool.
Test conditions: Engine stopped, ignition on.
Order FunctionParameter or Status
checked or Action Display and notes Fault finding
1Charging circuitET001:Battery warning
lightLIT
In the event of a fault, refer to
the relevant fault finding
method. 2Oil pressure
contactET027:Oil pressure
contactCLOSED
3GearboxET004:Reverse gear
engagedYES
NO
MR-372-J84-87G000$528_eng.mif

Page 21 of 56

87G - 21
ENGINE COMPARTMENT CONNECTION UNIT
Fault finding - Conformity check
87G
V6 MR-372-J84-87G000$528_eng.mif
UPC
Vdiag No.: 44
MAIN SCREEN
NOTESOnly check conformity after a complete check using the diagnostic tool.
Condition for carrying out this operation: the engine must be running.
Order FunctionParameter or Status
checked or Action Display and notes Fault finding
1Charging circuitET001:Battery warning
lightOFF
Refer to the relevant fault
finding procedure in the
event of a fault. 2Oil pressure
contactET027:Oil pressure
contactOPEN
3GearboxET004:Reverse gear
engagedYES
NO

Page 35 of 56

87G - 35
ENGINE COMPARTMENT CONNECTION UNIT
87G
V6 MR-372-J84-87G000$726_eng.mif
UPC
Vdiag No.: 44
Fault finding - Interpretation of parameters
PR010
ALTERNATOR CHARGE
NOTESCheck in the configuration readings that the alternator type has been configured
correctly.
When the engine has stopped, the value must be constant and greater than 98 %.
With the engine running, the value varies according to the electricity consumption. The
value must not be constant.
Carry out fault finding on the charging circuit.
Disconnect the 2 track connector from the alternator.
With the ignition on, check the presence of + 12 V on track 2 of the alternator.
With the ignition off, check the presence of a voltage below 6 V on track 2 of the alternator.
Repair if necessary.
AFTER REPAIRDeal with any other possible faults.
Switch off the ignition and carry out a road test followed by a test with the diagnostic
tool.
MR-372-J84-87G000$726_eng.mif