bulb RENAULT SCENIC 2011 J95 / 3.G Air Bag RC5 - Seat Belt Pretensioners Workshop Manual

Page 3 of 88

88C-3
MR-372-J84-88C100$059.mif
V5
AIRBAG RC5
Vdiag: 14AIRBAGS AND PRETENSIONERS
Fault finding – Introduction88C
3. REMINDERS
To run fault finding on the vehicle's computers, switch on the ignition in fault finding mode (forced + after
ignition feed).
Proceed as follows:
– with the vehicle card in the RENAULT card reader,
– press and hold the Start button (for more than 5 seconds) with start-up conditions not fulfilled,
– connect the diagnostic tool and perform the required operations.
To cut off the + after ignition feed, proceed as follows:
– disconnect the diagnostic tool,
– press the Start button twice briefly (less than 3 seconds),
ensure that the + after ignition feed has been cut off by checking that the computer indicator lights on the instrument
panel have gone out.Note:

The left-hand and right-hand xenon bulb computers are powered when the dipped headlights are lit. Therefore
fault finding can only be carried out on them after the ignition has been switched on in fault finding mode (forced
+ after ignition feed) and the dipped headlights have been switched on.