wiring RENAULT TWINGO RS 2009 2.G Electrical Equipment - Wipers, Washers Workshop Manual

85A-2
MR-413-X44-85A000$100_eng.mif
V1
85A
WIPERS - WASHERS
Fault finding - Introduction
1. SCOPE OF THIS DOCUMENT
This document presents the fault finding procedure applicable to all computers with the following specifications:
2. PREREQUISITES FOR FAULT FINDING
Documentation type
Fault finding procedures (this manual):
–Assisted fault finding (integrated into the diagnostic tool), Dialogys.
Wiring Diagrams:
–Visu-Schéma (CD-ROM), paper.
Types of diagnostic tools
–CLIP
Special tooling required
3. REMINDERS
To run fault finding on the vehicle's computers, switch on the ignition in fault finding mode (+ after ignition feed).Vehicle(s): New Twingo
Function concerned: Wipers/washers
Special tooling required
Multimeter
Elé. 1681 Universal bornier
MR-413-X44-85A000$100_eng.mif

85A-5
MR-413-X44-85A000$100_eng.mif
V1
WIPERS - WASHERS
Fault finding - Introduction85A
4. FAULT FINDING PROCEDURE (CONTINUED)
Wiring check
Fault finding problems
Disconnecting the connectors and/or manipulating the wiring harness may temporarily remove the cause of a fault.
Electrical measurements of voltage, resistance and insulation are generally correct, especially if the fault is not
present when the analysis is made (stored fault).
Visual inspection
Look for damage under the bonnet and in the passenger compartment.
Carefully check the fuses, insulators and wiring harness routing.
Look for signs of oxidation.
Tactile inspection
While manipulating the wiring harness, use the diagnostic tool to note any change in fault status from stored to
present.
Make sure that the connectors are properly locked.
Apply light pressure to the connectors.
Twist the wiring harness.
If there is a change in status, try to locate the source of the fault.
Inspection of each component
Disconnect the connectors and check the appearance of the clips and tabs, as well as the crimping (no crimping on
the insulating section).
Make sure that the clips and tabs are properly locked in the sockets.
Check that no clips or tabs have been dislodged during connection.
Check the clip contact pressure using an appropriate model of tab.
Resistance check
Check the continuity of entire lines, then section by section.
Look for a short circuit to earth, to + 12 V or to another wire.
If a fault is detected, repair or replace the wiring harness.

85A-7
MR-413-X44-85A000$200_eng.mif
V1
85A
WIPERS - WASHERS
Fault finding - List and location of components
1UCH
2Passenger compartment fuse and relay box
3Combined wiper-washer
4Windscreen wiper motor
5Rear screen wiper motor
6Front and rear screen washer pump
7Light and rain sensor
8Exterior temperature sensorENGINE HARNESS
FRONT ENGINE HARNESS & PROJADD
DOOR WIRING
CEILING WIRING
PASSENGER COMPARTMENT WIRING
REAR BUMPER WIRING
TAILGATE WIRING
0000000033
MR-413-X44-85A000$200_eng.mif