clock SATURN AURA 2007 User Guide

Page 295 of 406

To replace a sidemarker lamp, turn signal lamp, or
a back-up lamp:
1. Open the trunk. SeeTrunk on page 97for
more information.
2. Remove the convenience net, if the vehicle
has one.
3. Remove the wing nuts holding the trunk trim.
4. Remove the three wing nuts, which hold the
taillamp assembly, from inside the vehicle.5. Remove the taillamp assembly.
6. Remove the wiring harness from the taillamp
assembly by lifting the release tab.
7. Turn the bulb socket counterclockwise to
remove it.
8. Pull the bulb from the socket.
9. Install a new bulb.
10. Reverse Steps 2 through 6 to reinstall the
taillamp assembly.
295
ProCarManuals.com

Page 296 of 406

License Plate Lamp
To replace the license plate lamp bulb:
1. Remove the two screws holding the license
plate lamp assembly to the fascia.
2. Turn and pull the license plate lamp forward
through the fascia opening.3. Turn the bulb socket counterclockwise and
pull the bulb straight out of the socket.
4. Install the new bulb.
5. Reverse Steps 1 through 3 to reinstall the
lamp assembly.
Replacement Bulbs
Exterior Lamp Bulb Number
Back-up Lamp 921
License Plate Lamp and Rear
Sidemarker Lamp168
Turn Signal Lamp 3156
For replacement bulbs not listed here, contact
your dealer/retailer.
296
ProCarManuals.com

Page 322 of 406

Accessing the Tire Inator Kit
To access the tire inator kit:
1. Open the trunk. SeeTrunk on page 97for
more information.
2. Remove the tire inator kit strap by turning
the wing nut counterclockwise.
3. Remove the inator kit from its foam container.
Tire Sealant
The kit contains a liquid sealant that when injected
into a at tire, can temporarily repair nail holes
or cuts in the tread area of the tire. The tire sealant
cannot repair tire damage caused while driving
on a at tire or a tire that has had a “blow out”, or
a tire that has punctures in the sidewall areas.
The tire sealant solution is to be used for a single
tire and can only be used once.
Check the tire sealant expiration date on the
sealant canister. The sealant might not be as
effective beyond the expiration date. If needed, see
your dealer/retailer for a replacement canister.
322
ProCarManuals.com

Page 323 of 406

Using the Tire Inator Kit
To use the tire inator kit:
1. Place the inator kit on the ground and
unwrap the sealant lling hose from the
compressor.
2. Remove the air compressor accessory plug
from the unit. To do this, pull the top portion
of the wrapped cord out rst, then the bottom,
and then unsnap the plug. Do not insert the
plug into an accessory outlet yet.
3. Remove the valve stem cap from the at tire
by turning it counterclockwise.
If an object, such as a nail, has penetrated
the tire, do not remove it.
4. Attach the sealant lling hose (A) onto the tire
valve stem. Turn it clockwise until it is tight.
Make sure the inator kit on/off switch (B) is in
the O (off) position.
5. Plug the air compressor accessory plug (C)
into an accessory power outlet in the vehicle.
SeeAccessory Power Outlet(s) on page 153
for more information.
323
ProCarManuals.com

Page 326 of 406

12. Unplug the air compressor accessory plug
from the accessory power outlet in the
vehicle.
13. Disconnect the sealant lling hose from the
tire valve stem, by turning it counterclockwise,
and replace the tire valve stem cap.
Be careful when handling the tire inator
components as they could be hot after usage.
14. Wrap the sealant lling hose around the air
compressor channel to stow it in its original
location.
15. Stow the air compressor accessory plug back
in the air compressor. To do this, wrap the air
compressor accessory plug, snap in the
plug, and then push in the bottom and then
the top of the wrapped air compressor
accessory plug.16. If the at tire was
able to inate to the
recommended
ination pressure,
remove the
maximum speed
label from the
sealant canister.
Place it in a highly visible location such as the
inside of the upper left corner of the
windshield or to the face of the radio/clock.
The maximum speed label reminds you
to drive cautiously and not to exceed 55 mph
(90 km/h) until you have the damaged tire
inspected and repaired.
326
ProCarManuals.com

Page 327 of 406

17. Return the equipment to the proper storage
location in the trunk of your vehicle. Turn
the wing nut clockwise to secure the
tire inator kit.
{CAUTION:
Storing the tire inator kit or other
equipment in the passenger compartment
of the vehicle could cause injury. In a
sudden stop or collision, loose equipment
could strike someone. Store the tire
inator kit in the proper place.
18. Immediately drive the vehicle 5 miles (8 km)
to distribute the sealant evenly in the tire.
Stop at a safe location and check the
tire pressure, refer to Steps 1 through 8 under
“Using the Air Compressor without Sealant”
next in this section. If the tire pressure
has fallen more then 10 psi (68 kPa), below
the recommended ination pressure, stop
driving the vehicle. The tire is too damaged for
the sealant to work. SeeRoadside Assistance
Program on page 377.
327
ProCarManuals.com

Page 331 of 406

4. Turn the sealant canister so the inator lling
hose is aligned with the slot in the
compressor.
5. Lift the sealant canister from the compressor
and replace with a new sealant canister. See
your dealer/retailer for more information.To install a new sealant canister:
1. Align the sealant lling hose with the slot in
the air compressor.
2. Push the sealant canister down and turn it
clockwise.
3. Wrap the sealant lling hose around the air
compressor channel to stow it in its original
location.
4. Push the air compressor inator hose onto the
sealant canister inlet and push the lever down.
331
ProCarManuals.com

Page 395 of 406

Child Restraints
Child Restraint Systems............................. 45
Infants and Young Children........................ 42
Lower Anchors and Tethers for Children..... 52
Older Children........................................... 39
Securing a Child Restraint in a
Rear Seat Position................................. 60
Securing a Child Restraint in the
Right Front Seat Position........................ 62
Where to Put the Restraint........................ 49
Cleaning
Aluminum Wheels.................................... 337
Exterior Lamps/Lenses............................. 336
Fabric/Carpet........................................... 333
Finish Care.............................................. 336
Instrument Panel, Vinyl, and
Other Plastic Surfaces.......................... 334
Interior..................................................... 332
Tires........................................................ 338
Underbody Maintenance........................... 339
Washing Your Vehicle.............................. 335
Weatherstrips........................................... 335
Windshield and Wiper Blades................... 337
Climate Control System
Automatic................................................. 154
Outlet Adjustment..................................... 160Clock.......................................................... 194
Collision Damage Repair............................. 382
Comfort Guides, Rear Safety Belt................. 35
Content Theft-Deterrent............................... 103
Control of a Vehicle..................................... 214
Convenience Net......................................... 132
Coolant
Engine Temperature Warning Light........... 171
Heater, Engine......................................... 114
Surge Tank Pressure Cap........................ 275
Cooling System........................................... 278
Cruise Control............................................. 145
Cruise Control Light.................................... 176
Cupholder(s)................................................ 131
Customer Assistance Information
Courtesy Transportation........................... 380
Customer Assistance for Text
Telephone (TTY) Users......................... 376
Customer Assistance Offices.................... 376
Customer Satisfaction Procedure.............. 372
GM Mobility Reimbursement Program...... 377
Reporting Safety Defects to Saturn.......... 387
Reporting Safety Defects to the
Canadian Government.......................... 386
Reporting Safety Defects to the
United States Government.................... 386
395
ProCarManuals.com

Page:   < prev 1-10 11-20