instrument panel SATURN AURA 2007 Owner's Guide

Page 160 of 406

Outlet Adjustment
There are four main air outlets on the instrument
panel. Use the lever located in the center of
each outlet by moving it either side-to-side or up
and down, to change the direction and amount
of airow in the vehicle. The center thumbwheel
does not control the main outlets.
Dedicated Rear Seat Air Outlet
For vehicles with this feature, the dedicated rear
seat air outlet is located in the center of the
instrument panel above the two main center
outlets. This outlet is aimed to provide comfort to
the rear seat passengers, especially while
using air conditioning in warm weather.
Use the thumbwheel in the center of the outlet to
turn the airow on or off. This can be adjusted
to improve front seat passenger comfort if
there are no rear seat passengers. The direction
of airow cannot be adjusted since it is directed
towards the rear seat passengers.
Do not attempt to move the horizontal vent vane,
as breakage can occur.
Operation Tips
Clear away any ice, snow, or leaves from the
air inlets at the base of the windshield that
can block the ow of air into your vehicle.
Do not use non-GM approved hood deectors
as they could adversely affect the performance
of the system.
Keep the path under the front seats clear of
objects to help circulate the air inside of
your vehicle more effectively.
When an objectionable odor outside the
vehicle is encountered, use the recirculation
mode, with the temperature knob at a
comfortable setting to prevent the odor from
entering the vehicle through the ventilation
system. This can be helpful when driving
through a long tunnel with poor ventilation.
However, extended usage of this mode in cold
or cool weather can cause window fogging.
160
ProCarManuals.com

Page 162 of 406

Instrument Panel Cluster
Your instrument panel cluster is designed to let you know at a glance how your vehicle is running. You
will know how fast you are going, how much fuel you are using, and many other things you will need
to drive safely and economically.
Your vehicle has this instrument panel cluster, which includes indicator warning lights and gages that are
explained on the following pages.
United States version shown, Canada Similar
162
ProCarManuals.com

Page 164 of 406

Passenger Safety Belt Reminder
Light
Several seconds after the key is turned to ON or
START, a chime will sound for several seconds to
remind the front passenger to buckle their safety
belt. This would only occur if the passenger airbag
is enabled. SeePassenger Sensing System on
page 77for more information. The passenger
safety belt light will also come on and stay on for
several seconds, then it will ash for several more.
This chime and light are
repeated if the
passenger remains
unbuckled and
the vehicle is in motion.
If the passenger’s safety belt is buckled, neither
the chime nor the light will come on.
Airbag Readiness Light
There is an airbag readiness light on the
instrument panel cluster, which shows the airbag
symbol. The system checks the airbag’s
electrical system for malfunctions. The light tells
you if there is an electrical problem. The
system check includes the airbag sensor, the
pretensioners, the airbag modules, the wiring and
the crash sensing and diagnostic module. For
more information on the airbag system, seeAirbag
System on page 67.
This light will come on
when you start your
vehicle, and it will ash
for a few seconds.
Then the light should go
out. This means the
system is ready.
If the airbag readiness light stays on after you
start the vehicle or comes on when you are driving,
your airbag system may not work properly.
Have your vehicle serviced right away.
164
ProCarManuals.com

Page 165 of 406

{CAUTION:
If the airbag readiness light stays on after
you start your vehicle, it means the airbag
system may not be working properly. The
airbags in your vehicle may not inate in
a crash, or they could even inate without
a crash. To help avoid injury to yourself
or others, have your vehicle serviced right
away if the airbag readiness light stays on
after you start your vehicle.
The airbag readiness light should ash for a few
seconds when you turn the ignition key to ON.
If the light does not come on then, have it xed so
it will be ready to warn you if there is a problem.
Passenger Airbag Status Indicator
Your vehicle has the passenger sensing system.
Your instrument panel has a passenger airbag
status indicator.
When the ignition key is turned to ON or START,
the passenger airbag status indicator will light
ON and OFF, or the symbol for on and off,
for several seconds as a system check. Then,
after several more seconds, the status indicator
will light either ON or OFF, or either the on
or off symbol to let you know the status of the
right front passenger’s frontal airbag and
seat-mounted side impact airbag.
United StatesCanada
165
ProCarManuals.com

Page 179 of 406

Fuel Economy Light
If enabled, this light will
come on briey when
the vehicle is started.
This light will also come on when the vehicle is
operating at a fuel efficient point.
This light can be disabled by using the Driver
Information Center (DIC) buttons. With the engine
off and the key turned to accessory, set the
DIC to the outside air temperature and odometer
mode. Press and hold the reset button for
several seconds. The light will come on solid and
then ash several times and turn off to indicate
it is disabled. Repeat the procedure to enable the
light. SeeDIC Warnings and Messages on
page 182for more information.
Driver Information Center (DIC)
Your vehicle has a Driver Information Center (DIC).
The DIC display gives you the status of many of
your vehicle’s systems. The DIC is also used to
display driver personalization menu modes and
warning/status messages. All messages will appear
in the DIC display, located at the bottom of the
instrument panel cluster.
The DIC buttons are located on the left side of the
steering wheel. Your vehicle will have one of
the buttons shown above.
q/INFO (Information):Press this button to
scroll through the vehicle information mode
displays.
179
ProCarManuals.com

Page 183 of 406

AUTO (Automatic) LIGHTS ON
This message displays if the automatic headlamp
system is enabled with the headlamp switch.
SeeAutomatic Headlamp System on page 150for
more information.
BRAKE FLUID
This message displays, while the ignition is on,
when the brake uid level is low. The brake system
warning light on the instrument panel cluster
also comes on. SeeBrake System Warning Light
on page 168for more information. Have the
brake system serviced by your retailer as soon as
possible.
CHANGE OIL SOON
This message displays when the life of the engine
oil has expired and it should be changed.
When this message is acknowledged and cleared
from the display, the engine oil life system
must still be reset separately. SeeEngine Oil Life
System on page 268andScheduled Maintenance
on page 356for more information.
CHECK GAS CAP
This message displays if the fuel cap has not
been fully tightened. Recheck the fuel cap to make
sure that it is on properly. A few driving trips
with the cap properly installed should turn
the message off.
CHECK TIRE PRESS (Pressure)
This message displays when the tire pressure in
one or more of the tires needs to be checked. If a
tire pressure message appears on the DIC, stop as
soon as you can. Have the tire pressures checked
and set to those shown on the Tire Loading
Information label. SeeTires on page 298,Loading
Your Vehicle on page 242, andInation - Tire
Pressure on page 304. If the tire pressure is low,
the low tire pressure warning light comes on. See
Low Tire Pressure Warning Light on page 170.
CRUISE ENGAGED
This message displays when the cruise control
system is active. SeeCruise Control on page 145
for more information.
183
ProCarManuals.com

Page 184 of 406

DOOR AJAR
This message displays if one or more of the
vehicle’s doors are not closed properly. Make sure
that the door(s) are closed completely.
ENGINE DISABLED
This message displays if the starting of the engine
is disabled. Have your vehicle serviced by your
retailer immediately.
ENG (Engine) PWR (Power) REDUCED
This message displays when the vehicle’s engine
power is reduced. Reduced engine power can
affect the vehicle’s ability to accelerate. If
this message is on, but there is no reduction in
performance, proceed to your destination.
The performance may be reduced the next time
the vehicle is driven. The vehicle may be driven at
a reduced speed while this message is on, but
acceleration and speed may be reduced. Anytime
this message stays on, the vehicle should be
taken to your retailer for service as soon as
possible.
ESC (Electronic Stability Control) ACTIVE
If your vehicle has Electronic Stability Control
(ESC), this message displays when ESC is
assisting you with directional control of the vehicle.
You may feel or hear the system working and
see this message displayed in the DIC. Slippery
road conditions may exist when this message
is displayed, so adjust your driving accordingly.
This message may stay on for a few seconds after
ESC stops assisting you with directional control
of the vehicle. This is normal when the system is
operating. SeeElectronic Stability Control on
page 219for more information.
ESC (Electronic Stability Control) OFF
If your vehicle has Electronic Stability Control
(ESC), this message displays and the ESC light
on the instrument panel cluster comes on
solid when ESC is turned off. Adjust your driving
accordingly. SeeElectronic Stability Control
on page 219andElectronic Stability Control
Indicator Light on page 171for more information.
184
ProCarManuals.com

Page 186 of 406

SERVICE AIR BAG
This message displays when there is a problem
with the airbag system. Have your vehicle serviced
by your retailer immediately.
SERVICE ESC (ELECTRONIC STABILITY
CONTROL)
If your vehicle has Electronic Stability Control
(ESC), this message displays and a chime sounds
if there has been a problem detected with ESC.
The ESC light also appears on the instrument
panel cluster. This light stays on solid as long as
the detected problem remains present. When
this message displays, the system is not working.
Adjust your driving accordingly. SeeElectronic
Stability Control on page 219andElectronic
Stability Control Indicator Light on page 171for
more information.
If this message turns on while you are driving, pull
off the road as soon as possible and stop
carefully. Try resetting the system by turning the
ignition off and then back on. If this message
still stays on or turns back on again while you are
driving, your vehicle needs service. Have the
ESC inspected by your retailer as soon as
possible.
SERVICE HYBRID
This message displays if the hybrid components
need to be serviced. Have your vehicle serviced by
your retailer.
SERVICE TRACTION
If your vehicle has the Traction Control System
(TCS), this message displays and a chime sounds
when the system is not functioning properly.
The TCS light also appears on the instrument
panel cluster. This light stays on solid as long as
the detected problem remains present. When
this message displays, the system is not working.
Adjust your driving accordingly. SeeTraction
Control System (TCS) on page 217andTraction
Control System (TCS) Warning Light on page 170
for more information. Have the system serviced
by your retailer as soon as possible.
SRVC (Service) HILL START
This message displays if there is a problem with
the hill start assist function. Have your vehicle
serviced by your retailer.
186
ProCarManuals.com

Page 187 of 406

TRACTION OFF
If your vehicle has the Traction Control System
(TCS), this message displays and the TCS light on
the instrument panel cluster comes on solid when
the system is turned off. Adjust your driving
accordingly. SeeTraction Control System (TCS) on
page 217andTraction Control System (TCS)
Warning Light on page 170for more information.
TRUNK AJAR
This message displays when the trunk is not
closed completely. Make sure that the trunk is
closed completely. SeeTrunk on page 97for more
information.
DIC Vehicle Personalization
Your vehicle has personalization capabilities that
allow you to program certain features to a
preferred setting. All of the features listed may not
be available on your vehicle. Only the features
available will be displayed on the DIC.
The default settings for the features were set
when your vehicle left the factory, but may have
been changed from their default state since
that time.To change feature settings, use the following
procedure:
Entering Personalization Menu
1. Turn the ignition on while the vehicle is
stopped.
To avoid excessive drain on the battery, it is
recommended that the headlamps are
turned off.
2. Press and hold the information and reset
buttons at the same time for one second, then
release to enter the personalization menu.
If the vehicle speed is greater than 2 mph
(3 km/h), only the UNITS menu will be
accessible.
3. Press the information button to scroll through
the available personalization menu modes.
Press the reset button to scroll through
the available settings for each mode.
If you do not make a selection within ten
seconds, the display will go back to the
previous information displayed.
187
ProCarManuals.com

Page 218 of 406

The TCS operates in all transmission shift lever
positions except PARK (P), NEUTRAL (N) or
REVERSE (R). But the system can upshift
the transmission only as high as the shift lever
position you’ve chosen, so you should use
the lower gears only when necessary. See
Automatic Transaxle Operation on page 116.
This light is located on
the instrument panel
cluster.
When the system is on, this warning light will
come on to let you know if there’s a problem, or if
the system has been turned off. When this light
is on, the system will not limit wheel spin.
Adjust your driving accordingly.
To limit wheel spin, especially in slippery road
conditions, you should always leave the TCS on.
But you can turn the system off if you prefer.To turn the system on or off, press the traction
control button (TC) located on the center console.
In order to effectively “rock” the vehicle, you
will need to turn off TCS.
If you press the TC button once, the TCS will turn
off, the TRACTION OFF message will display and
the TCS warning light will come on. The
StabiliTrak
®system will stay on. Press the TC
button again to turn the system back on. The TCS
warning light will go off. If you press and hold the
TC button, the StabiliTrak
®system and the traction
control system will turn off. Press the TC button
again to turn StabiliTrak
®and the traction control
system back on. For more information, see
Electronic Stability Control on page 219.
When you turn the system off, the TCS warning
light will come on and stay on. If the Traction
Control System is limiting wheel spin when you
press the button to turn the system off, the warning
light will come on – but the system won’t turn off
right away. It will wait until there’s no longer a
current need to limit wheel spin.
Adding non-dealer/non-retailer accessories can
affect your vehicle’s performance. SeeAccessories
and Modications on page 253for more
information.
218
ProCarManuals.com

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 next >