sensor SATURN VUE HYBRID 2007 Owners Manual

Page 82 of 438

Frontal airbags (driver and right front passenger)
are not intended to inate during vehicle
rollovers, rear impacts, or in many side impacts.
Your vehicle may or may not have roof-mounted
side impact airbags and a rollover sensor.
SeeAirbag System on page 75. These
roof-mounted “rollover capable” side impact
airbags are intended to inate in moderate to
severe side crashes, and during a rollover.
They may also inate in some frontal crashes.
Both rollover capable side impact airbags
will inate if the crash severity is above the
system’s designed “threshold level.” The threshold
level can vary with specic vehicle design.
Side impact airbags are not intended to inate
in rear impacts.Both side impact airbags will deploy when either
side of the vehicle is struck. If your vehicle
does not have a right front passenger seat and a
rear seat, only the driver’s frontal airbag will
deploy in a frontal impact.
In any particular crash, no one can say whether
an airbag should have inated simply because
of the damage to a vehicle or because of what
the repair costs were. For frontal airbags,
ination is determined by what the vehicle hits,
the angle of the impact, and how quickly the
vehicle slows down. For side impact airbags,
ination is determined by the location and severity
of the impact.
82
ProCarManuals.com

Page 86 of 438

Passenger Sensing System
Your vehicle has a passenger sensing system.
The passenger airbag status indicator on the
instrument panel will be visible when you turn your
ignition key to RUN or START.
The words ON and OFF or the symbol for on and
off, will be visible during the system check.
When the system check is complete, either the
word ON or the word OFF, or the symbol for on or
the symbol for off will be visible. SeePassenger
Airbag Status Indicator on page 166. The
passenger sensing system will turn off the right
front passenger’s frontal airbag under certain
conditions. The driver’s airbags are not part of the
passenger sensing system.The passenger sensing system works with
sensors that are part of the right front passenger’s
seat. The sensors are designed to detect the
presence of a properly-seated occupant and
determine if the passenger’s frontal airbag should
be enabled (may inate) or not.
Accident statistics show that children are safer if
they are restrained in the rear rather than the front
seat. We recommend that child restraints be
secured in a rear seat, including an infant riding in
a rear-facing infant seat, a child riding in a
forward-facing child seat, and an older child riding
in a booster seat.
United StatesCanada
86
ProCarManuals.com

Page 93 of 438

Adding Equipment to Your
Airbag-Equipped Vehicle
Q:Is there anything I might add to the front
or sides of the vehicle that could keep the
airbags from working properly?
A:Yes. If you add things that change your
vehicle’s frame, bumper system, height,
front end or side sheet metal, they may keep
the airbag system from working properly.
Also, the airbag system may not work properly
if you relocate any of the airbag sensors.
If you have any questions about this,
you should contact Customer Assistance
before you modify your vehicle. The phone
numbers and addresses for Customer
Assistance are in Step Two of the Customer
Satisfaction Procedure in this manual.
SeeCustomer Satisfaction Procedure on
page 408.
Q:Because I have a disability, I have to get
my vehicle modied. How can I nd out
whether this will affect my airbag system?
A:Changing or moving any parts of the
front seats, safety belts, the airbag sensing
and diagnostic module, steering wheel,
instrument panel, ceiling headliner, ceiling and
pillar garnish trim, roof-mounted airbag
modules, or airbag wiring can affect the
operation of the airbag system. If you have
questions, call Customer Assistance.
The phone numbers and addresses for
Customer Assistance are in Step Two of the
Customer Satisfaction Procedure in this
manual. SeeCustomer Satisfaction Procedure
on page 408.
93
ProCarManuals.com

Page 152 of 438

Daytime Running Lamps (DRL)
Daytime Running Lamps (DRL) can make it easier
for others to see the front of your vehicle during
the day. DRL can be helpful in many different
driving conditions, but they can be especially
helpful in the short periods after dawn and before
sunset. Fully functional daytime running lamps
are required on all vehicles rst sold in Canada.
The DRL system will make your low-beam
headlamps come on at a reduced brightness in
daylight when the following conditions are met:
The ignition is on,
the exterior lamp band is in AUTO,
the transaxle is not in PARK (P),
the light sensor determines it is daytime, and
the parking brake is released.When the DRL are on, the low-beam headlamps
will be on at a reduced brightness. The taillamps,
sidemarker and other lamps will not be on.
The instrument panel will not be lit up either.
When you turn the exterior lamp band to
the headlamp position, your regular headlamps
will come on. The other lamps that come on with
your headlamps will also come on.
When you turn off the headlamps, the regular
lamps will go off, and your low-beam headlamps
will come on to the reduced brightness.
To idle your vehicle with the DRL off, move the
shift lever to PARK (P). The DRL will stay off
until you move the shift lever out of PARK (P).
To override the DRL on manual transaxle vehicles,
you must set the parking brake while the ignition
is off and then start your vehicle. The DRL will stay
off until you release the parking brake.
As with any vehicle, you should turn on the
regular headlamp system when you need it.
152
ProCarManuals.com

Page 153 of 438

Automatic Headlamp System
When it is dark enough outside, the headlamps
will come on automatically.
Your vehicle has a light
sensor located on top of
the instrument panel.
Make sure it is not
covered, or the
headlamps will be on
when you don’t
need them.
The system may also turn on the headlamps when
driving through a parking garage or tunnel.
Interior Lamps
The liftgate lamps are located on the bottom left
and right corner of the liftgate. They will come
on when the liftgate or any door is opened. The
liftgate lamps can be controlled by the dome lamp
switch. SeeDome Lamp on page 154.
Instrument Panel Brightness
This feature controls the brightness of the
instrument panel lights.
The thumbwheel for this
feature is located on the
center of the instrument
panel.
Turn the thumbwheel to the right to brighten the
lights or to the left to dim them.
153
ProCarManuals.com

Page 165 of 438

Airbag Readiness Light
There is an airbag readiness light on the
instrument panel cluster, which shows the airbag
symbol. The system checks the airbag’s
electrical system for malfunctions. The light tells
you if there is an electrical problem. The system
check includes the airbag sensor, the airbag
modules, the wiring and the crash sensing and
diagnostic module. For more information on
the airbag system, seeAirbag System on page 75.
This light will come on
when you start your
vehicle, and it will ash
for a few seconds.
Then the light should go
out. This means the
system is ready.
If the airbag readiness light stays on after you
start the vehicle or comes on when you are driving,
your airbag system may not work properly.
Have your vehicle serviced right away.{CAUTION:
If the airbag readiness light stays on after
you start your vehicle, it means the airbag
system may not be working properly.
The airbags in your vehicle may not
inate in a crash, or they could even
inate without a crash. To help avoid
injury to yourself or others, have your
vehicle serviced right away if the airbag
readiness light stays on after you start
your vehicle.
The airbag readiness light should ash for a
few seconds when you turn the ignition key to
RUN. If the light does not come on then, have it
xed so it will be ready to warn you if there is
a problem.
165
ProCarManuals.com

Page 384 of 438

Fuses Usage
REAR DEFOG Rear Defogger
COOL HI Cooling Fan High
LH HDLP Driver’s Side Headlamp
RR WIPER Rear Wiper
ABS Anti-lock Brake System Module
IGN/INJEngine Ignition Module,
Fuel Injectors
PWR WDW Power Window Relay and Sunroof
CIGAR LITER Cigarette Lighter
HVAC
BLOWERClimate Control System
Blower Motor
RH HDLP Passenger’s Side Headlamp
FRT WIPER Front Wiper
ETC Electronic Throttle Control
SUNROOF Sunroof Module
BRAKE StoplampsFuses Usage
PWR TRAINEngine Control Module, Transaxle
Control Module, Powertrain Control
Module
BACKUPLow Coolant Switch, Back-up
Lamps, Vehicle Speed Sensor
(Manual), Transaxle Range Switch
HTD SEATS Heated Seats
IGN Ignition Switch
COOL LO Cooling Fan Low
A/C CLUTCH Air Conditioning Clutch
FUEL PUMP Fuel Pump
AUX OUTLETS Auxiliary Power Outlets
ESCM/CANV Electric Storage Control Module
ABS Anti-lock Brake System Ignition
PWR SEAT Power Seats
384
ProCarManuals.com