lights Seat Alhambra 2019 User Guide

Lights and visibility
headlight adjustment (automatic lights al-
so), for e
x
ample, if additional headlight are
fitted. Note
Main beam and flashed headlights can be
t urned on and off manually at any time with
the t urn signal and main beam l

ever

Operation
When being towed with the hazard warning
lights on, a change in dir ection or tr
affic l
ane
can be indicated as usual using the turn sig-
nal lever. The hazard lights will be interrupted
temporarily.
If your vehicle breaks down:
Park the vehicle a safe distance from
traffic and on suitable ground

Lights and visibility
Note
Use of the Tourist light option and the
adhesives on the headlights is only all o
wed
if they are to be used for a short period of
time. To modify the direction of the head-
lights permanently, please take the vehicle
to a specialised workshop. SEAT recom-
mends visiting a technical service centre. Headlight range control, lighting of
the instrument panel and control
sFig. 145
On the side of the steering wheel: in-
strument and s wit
ch lighting contr

ol 1 and
headlight r ange contr ol 2 1
Instrument and switch lighting
When the headlights ar e s
wit

ched on, the
brightness of the instruments and switch
lighting can be regulated by turning the
switch

Operation
Note
The reading lights go out when the vehicle
is lock ed, or a f
ew minutes after the key is
removed from the ignition. This prevents
the vehicle

Lights and visibility
Windscreen wiper and win-
do w wiper syst
ems
Contr
ol lamp 
It lights up
Windscreen wiper level too low.
Top up the windscreen wiper r
eservoir as soon as
possible

Operation
Headlight wash/wipe system
The headlight w ashers/wipers cl
ean the
headlight l
enses.
After the ignition is switched on, the first and
every fifth time the windscreen washer is
switched on, the headlights are also washed.
Therefore, the windscreen wiper lever should
be pulled towards the steering wheel when
the dipped beam or main beam are on. Any
encrusted dirt (such as insects) should be
cleaned regularly (e.g. when refuelling).
To ensure the headlight washers work cor-
rectly in winter, any snow which has got into
the bumper jet supports should be cleaned
away. If necessary, remove snow with an an-
ti-icing spray. Note
The wiper will try to wipe away any obsta-
cles that ar e on the windscr

een. The wiper
will stop moving if the obstacle blocks its
path. Remove the obstacle and switch the
wiper back on again. Rain sensor*
Fig. 148
Windscreen wipers lever: adjust the
r ain sensor A .
Fig. 149
Rain sensor sensitive surface The rain sensor controls the frequency of the
windscr
een wiper int erv

als, depending on the
amount of rain

Lights and visibility
reduce the effectiveness of the rain sensor or
mak e it r
eact mor
e slowly, later or not at all.

Lights and visibility
Synchronised mirror adjustment

Air conditioning
The LED on each control lights up to indicate
that the r espectiv
e function of a contr
ol has
been switched on.
Some Climatronic controls may also be on
the air conditioner control panel located in
the rear centre console. These controls are
used to make the appropriate settings for the
rear seats. Note

Air conditioning
burn any fuel remaining in the auxiliary heat-
er . The e
xhaust gases ar
e also extracted from
the system.
Remote control Fig. 201
Independent heater: remote control. Fig. 201 Meaning
 Switch the auxiliary heater on.
 Switch the auxiliary heater off:
A Aerial.
B Light.
The auxiliary heater may accidentally switch
on if a butt
on is pr
essed on the r

emote control
by mistake. This may also occur outside the
range of the remote control or if the light
flashes. Remote control light
The remote contr

ol light provides users with
different information at the push of a button: Battery light
Fig. 201
B Meaning
Lights up green for
around tw o seconds. The auxiliary heat

er has
been switched on using the

 button.
Lights up red for
around tw o seconds. The auxiliary heat

er has
been switched off using the

button.
Slowly flashes green
for ar ound tw

o sec-
onds. No on
a)
signal has been re-
ceived.
Quickly fl
ashes
green f or ar

ound two
seconds. The independent heating is
block
ed.
P

ossible causes: the fuel tank
is almost empty, the battery
charge is very low or there is
a fault.
Flashes red for
around two seconds. No off
a)
signal has been r
e-
ceived.
Lights up or
ange for
around two seconds,
then gr

een or red. The remote control battery is
almost flat. How
ever, the on
or off signal has been re-
ceived, respectively.
Lights up orange for
around two seconds,
then fl

ashes green
or red. The remote control battery is
almost flat. The on or off sig-
nal has not been receiv
ed,
respectively. Battery light
Fig. 201
B Meaning
Flashes orange for
around five seconds. The r

emote control battery is
flat. The on or off signal has
not been r eceiv
ed, respec-
tively. a)
Within its range, the remote control might not re-
ceive the signal sent by the v ehicl

e receiver. In this
case, the remote control will send an error message
whether the auxiliary heater is on or off. Come closer
to the vehicle and press the corresponding button on
the remote control once again.
Replace the battery of the remote control
If the light