ignition Seat Arona 2020 Owner's Manual

Fuses and bulbs
No. Consumer/Amps
19 Radio, Multimedia System 25
20 Heated rear window 30
21 SCR Control Unit 30
23 Rear View Camera 7.5
24 Connectivity Box, external audio
source wiring (Double USB-Aux IN),
MIB display 5
25 St
eering column electronics (MFL) 7.5
26 Gateway 7.5
27 Active suspension control unit 7.5
28 DWA Sensor 7.5
29 DWA Horn 7.5
31 9AA/9AB climate control unit 7.5
9AK Climatronic control unit
15
32 Steering Column LSS, without Kessy 7.5
33 Left Door Window Control 30
35 Left lights power supply 40
36 Signal Horn 20
37 Heated seats control unit 30
38 BCM Power C63 30
39 BSD, PDC, MRR, PLA 10 No. Consumer/Amps
40 Light switch, diagnosis input, head-
lamp range regul
at

or, LSS steering
column: lamps, halogen lamps,
switch, reverse gear, electrochromic
mirror, RKA without radio. 7.5
41 Regulation of unfolded exterior mir-
rors, 7.5
42 Clutch pedal
, ignition r

elays, CNG
relay coil, AC pr essur

e sensor7.5
43 DWP relay coil, rear window wiper motor, heated no zzl

es 15
44 Airbag 7.5
45 Left full LED headlight 7.5
46 Right full LED headlight 7.5
48 Steering column lock, Kessy Control
Unit 7.5
49 SCR relay 7.5
53 Automatic gearbox lever, ZSS 7.5
58 Windscreen washer pump 7.5
59 Heated rear view mirrors 10
60 Tow hook 30
61 Tow hook 30 Fuse arrangement in engine compartment
No. Consumer/Amps
1 MPI Engine Injection Module
10
TSI Engine Injection Module 15
Diesel Engine Injection Module 30
2 Fuel metering valve (TJ4/T6P/TJ7),
Low temper
at

ure coolant pump
(TJ4/T6P/TJ7); Oil pressure regulat-
ing valve (TJ1), AGR coolant valve
(TJ1), High and low pressure water
pumps (TJ1), SCR relay coil, cylin-
der head water valve 7.5
3 Lambda probes 15
4 Engine petrol pump relay (MPI),
Gauge control unit (TSI and diesel) 15
5 Electric f
an (EC), LDR v

alve, canni-
ster and variable distribution val
ve,
oil pressure regulating valve, cylin-
der disconnection valves, WIV sen-
sor and CNG pressure regulator 10
6 Spark plugs (MPI and TSI)
20
Glow plug relay, Suction hose resis-
t or (diesel) 7.5
7 Vacuum pump (TSI, CNG) 15
8 Inject

ors and EKP relay coil (MPI),
Fuel metering valve (diesel) 10
9

Servo sensor 7.5

Instruments and warning/control lamps
Engine coolant temperature indica-
t or Fig. 76
Analogue instrument panel: engine
cool ant t emper
atur
e indicator. Fig. 77
Digital instrument panel: engine cool-
ant t emper at
ure indicat

or.Cool zone. The engine has not r
eached
oper ating t emper
at

ure yet. Avoid high
speeds and stressing the engine if it has
not reached operating temperature.
A Normal zone. At high outside t
emper
a-
t ur
es and when making the engine w

ork
hard, the diodes may continue lighting up
and reach the upper zone. This is no
cause for concern, provided the control
lamp does not light up 
Warning area. When the engine is work-
ing hard, especially at high outside tem-
peratures, the diodes may light up in the
warning area.
The coolant temperature gauge only works
when the ignition is switched on.
Control and warning lamp 
It lights up red

Visibility
Interior and reading lights Fig. 111
Detail of roof lining: front lighting of
the passenger compartment. Knob Function
 Turning the interior lights on or off.

 The interior lights come on automati-
cally when you unlock the vehicle
,
open a door or r
emove the key from
the ignition.
The light goes out a few seconds after
closing all the doors, when locking the
vehicle or connecting the ignition.
* /
 Turning the reading light on and off The light controls may vary depending on the
v
ehicl
e version.
L uggage compar

tment lighting
The light is activated when the rear lid is
open, even when the ignition and lights are turned off. For this reason, ensure that the
rear lid is always closed.
Ambient light*
The ambient light lights up the ar

ea of the
centre console and the footwell area and,
depending on the version, the front door pan-
els as well.
It will be switched on at full brightness when
the doors are opened and the lights will be
dimmed during driving, when the light selec-
tor is set to ,  or .
The brightness of the ambient light can be
adjusted through the Easy Connect menu, as
can colour, in versions with lighting on the
front door panel (button    > SETTINGS
> Ambient lighting

Operation
More the lever to the required position:
4 v
Short wipe. Brief press, short clean.
Hold the lev
er do
wn for more time to in-
crease the wipe frequency.
5 W
Windscreen washer. The windscreen
washer function is activated by push-
ing the le

ver towards the steering
wheel, and the wipers operate simulta-
neously.
6 
Interval wipe for rear window. The wip-
er will wipe the window approximat
ely
e

very six seconds.
7 \
The rear window wash function is acti-
vated by pressing the l
e

ver, and the
rear wiper starts simultaneously. WARNING
In cold conditions you should not use the
wash/wipe system unless you hav e
w

armed the windscreen with the heating
and ventilation system. The windscreen
washer fluid could otherwise freeze on the
windscreen and obscure your view of the
road. CAUTION
If the ignition is switched off with the wind-
screen wipers active, they compl et

e their
wipe before returning to the rest position.
When switching the ignition back on, the
windscreen wiper will continue to operate
at the same wiping level. Ice, snow and oth- er obstacles on the windscreen may dam-
age the wiper and the windscreen wiper
motor.

Visibility
sequence will begin without performing the
last wipe. For the “drip” function t
o w
ork
again, you have to turn the ignition off and
then on again. Rain sensor*
Fig. 113
Wiper lever: adjust the rain sensor A.Fig. 114
Rain sensor sensitive surface The rain sensor controls the frequency of the
windscr
een wiper int erv
als, depending on the
amount of r
ain

Operation
Mirrors Int erior mirr
or anti-dazzl e functionRear view mirror with automatic anti-daz-
zle function*
The anti-dazzle function is activat
ed e
very
time the ignition is switched on.
When the anti-dazzle function is enabled, the
interior rear vision mirror will darken auto-
matically according to the amount of light it
receives. The anti-dazzle function is cancel-
led if reverse gear is engaged. WARNING
In the event that an automatic anti-dazzle
rear vision mirror breaks, an el ectr

olyte flu-
id may leak. This could cause irritation to
the skin, eyes and respiratory organs. If you
come into contact with this liquid, it must
be rinsed with large quantities of water. If
necessary, get medial help. CAUTION
In the event that an automatic anti-dazzle
rear vision mirror breaks, an el ectr

olyte flu-
id may leak. This liquid attacks plastic sur-
faces. Clean it with a wet sponge as soon
as possible. Note

Driving
Driving
St ar
t and driving
St ar
ting and st
opping the
engine
Ignition lock Fig. 208
Ignition key positions. Key positions

Start and driving
Ignition and start button* Fig. 209
In the lower part of the centre con-
sol e: st art butt
on. The engine can be started with a start button
(Pr
ess & Driv
e). To do so
, ther
e must be a valid
key inside the vehicle in the area of the front
or rear seats, or on the centre console.
In vehicles with the Keyless Access

Driving
approximately two minutes in neutral be-
fore swit
ching it off
.Note
After the engine is switched off the radiator
f an may run on for up to 10 minut es, e

ven if
the ignition is switched off. It is also possi-
ble that the fan turns itself on once more if
the coolant temperature increases due to
the heat accumulated in the engine com-
partment or due to its prolonged exposure
to solar radiation. Electronic immobilizer
The electronic immobiliser prevents unau-
thorised persons fr
om driving the v
ehicle
.
Inside the k

ey there is a chip that deactivates
the electronic immobiliser automatically
when the key is inserted into the ignition.
The electronic immobiliser will be activated
again automatically as soon as you pull the
key out of the ignition lock. For vehicles with
the “Keyless Access” system, the key has to
be outside the vehicle.
If the following message is shown on the in-
strument panel display: SAFE , the vehicle
cannot be started.
The engine can only be started using a genu-
ine SEAT key with its correct code. Note
A perfect operation of the vehicle is ensur-
ed if genuine SEAT keys are used. Emergency starting function
Fig. 210
On the right of the steering column:
emer gency st art. If no valid key is detected inside the vehicle,
an emer
gency st
art-up will be r
equir

ed. The
relevant message will appear in the dash
panel display. This may happen when, for ex-
ample, the vehicle key battery is very low:

Start and driving
needs to be started manually, the start but-
t on fl
ashes t o indicat
e this sit
uation.
Start-Stop system* Control lamps 
It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is active. i
It lights up
The Start-Stop system is not available or has been
disconnected. Instructions for the driver on the instru-
ment panel displ
ay
Start-Stop system deactivated.
Start the engine manually
This indication f or the driver sho
ws that the
St

art-Stop system cannot start the engine
again.
Start-Stop system Fault! Function
not available There is a fault in the Start-Stop system. Take
the vehicle to a workshop t

o have the fault re-
paired.
Description and operation Fig. 211
Related video The Start-Stop system helps you to save fuel
and r
educe CO
2 emissions.
In St art-St
op mode

, the engine will automati-
cally switch off when the vehicle stops or is
stopping. The ignition remains switched on.
The engine automatically switches back on
when required.
In this scenario, the light of the    button stays lit
1)
.
When the ignition is s wit
ched on, the St art
-
St

op function is automatically activated.
In the Easy Connect system you can find
more information about the Start-Stop sys-
tem: press the button    > View > Ve- hicle status . Vehicles with a manual gearbox