Seat Ateca 2019 Owner's Manual

Driver assistance systems
Driver assistance systems
St ar
t
-Stop system*
Control lamps 
It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is activ
e.i
It lights up
The Start-Stop system is not available. Instructions for the driver on the instru-
ment panel displ
ay
Start-Stop system deactivated.
Start the engine manually
This driv er message is displ

ayed when cer-
tain conditions are not met during the stop-
ping phase and the Start-Stop system can-
not restart the engine. The engine must be
started manually.
Start-Stop system: Fault! Function
not available
There is a fault in the Start-Stop system. Take
the vehicle to a workshop to have the fault re-
paired. Description and operation The Start-Stop system helps save fuel and
reduce CO
2 emissions.
In St art

-Stop mode, the engine will automati-
cally switch off when the vehicle stops or is
stopping; for example when stopping at traf-
fic lights. The ignition remains switched on
during the stopping phase. The engine auto-
matically switches back on when required. In
this situation, the light of the START ENGINE STOP button stays on
1)
.
As soon as the ignition is swit ched on, the
St

art-Stop function is automatically activa-
ted.
Further information about the Start-Stop sys-
tem can be found on the Easy Connect sys-
tem: by pressing the button  in the Vehi-
cle status menu.
V ehicl
es with a manual gearbo

x

Driving

Driver assistance systems
Note

Driving
speed without slowing the engine below its
idling speed.
Aft er st
arting the descent of a sl
ope below
30 km/h (18 mph), speed is limited to a mini-
mum of 2 km/h (1 mph) and a maximum of
30 km/h (18 mph). When appropriate, the
driver may increase or decrease the speed
within the limit by pressing the accelerator or
the brake. At this point the function is interrup-
ted and, if necessary, it is then reactivated.
Even so, it is imperative that the surface guar-
antees sufficient adhesion. For this reason,
the Hill Descent Control will not fulfil its func-
tion when, for example, descending a slope
with a frozen or slippery surface.
Hill Descent Control is available when the
dash panel display shows the message k.
Hill Descent Control automatically intervenes
if the following conditions are met:

Driver assistance systems
After detecting that the vehicle is stationary
and the br ak
e pedal has been r
eleased, the
Auto Hold function holds the vehicle. The driv-
er can lift their foot off the brake pedal.
When the driver touches the accelerator
pedal or accelerates slightly to continue driv-
ing, the Auto Hold function releases the brake.
The vehicle moves according to the slope of
the road.
If the vehicle is stationary and one of the con-
ditions required by the Auto Hold function is
impaired, it disconnects itself and the button

Driving

Driver assistance systems

Driving
The speed limiter is switched off. The total
mil eage is displ
ayed. WARNING
After use, always switch off the speed limit-
er to pr e
vent the speed being regulated
against your wishes.

Driver assistance systems
Operate the speed limiter Fig. 252
On the left of the steering column:
control and butt ons t
o operate the speed limit-
er. Fig. 253
On the left of the steering column:
third l e
ver for operating the speed limiter. Function
Position of the turn signal lever

Driving
Function
Position of the turn signal lever