Seat Ibiza 2020 Owner's manual

Start and driving
WARNING
If the gear is changed down inappropriate-
ly by sel ecting a gear that is t
oo low, you
may lose control of the vehicle, causing an
accident and serious injuries. CAUTION
When travelling at high speeds or at high
engine speeds, sel ecting a gear that is t

oo
low can cause considerable damage to the
clutch and the gearbox. This can also oc-
cur if the clutch pedal is pressed and held
and it does not engage. CAUTION
To prevent damage and avoid premature
w ear

, please observe the following:

Driving
To put the lever in P or t ak
e it out of P , the
locking button must be pressed and held and
the brake pedal pressed simultaneously.
 – Reverse gear
Reverse gear must be engaged only when
the vehicle is stationary and the engine is
idling ››› .
T o mo

ve the lever to position R, the lock but-
ton must be pressed and held while pressing
the brake pedal at the same time. The reverse
lights come on when the lever is in the R posi-
tion with the ignition on.
 – Neutral
With the lever in this position, the gear is in
neutral.
Press the brake pedal to move the lever from
N to D/S when the vehicle is stationary or at
speeds below 3 km/h (2 mph) ››› .
 – P
ermanent f

orward drive position
The lever in the D/S position enables the
gears to be operated in normal mode (D) or
sport mode (S). To select Sport mode S,
move the lever backwards. Pushing the lever
again will select normal mode D. The selec-
ted driving mode is shown on the instrument
panel display.
In normal mode (D), the gearbox selects the
best gear ratio. This depends on the engine load, the road speed and the dynamic gear
control pr

ogramme (DCP).
Sport mode (S) should be selected for a
sporty driving style. This setting makes use of
the engine's maximum power output. When
accelerating the gear shifts will be noticea-
ble.
Under certain circumstances (e.g. on moun-
tain roads) it can be advantageous to switch
tiptronic mode ››› page 201
, to adapt the
gears to suit the road conditions.
Selector lever lock
In P or N, the lever lock prevents a gear range
from being engaged, and prevents the vehi-
cle from moving off accidentally.
To release the gear lever lock, press and hold
the brake pedal with the ignition on. At the
same time, press the lever lock in the direc-
tion of the arrow ››› Fig. 141
.
As a reminder to the driver, when the lever is
in positions P or N the following indication will
be shown on the screen: When stationary, apply footbrake
while selecting a gear.
The lever is not locked if it is moved quickly
through position N (e.g. when shifting from R
to D). This makes it possible, for instance, to
“rock the vehicle backwards and forwards” if
it is stuck in snow or mud. The lever lock en-
gages automatically if the brake pedal is not pressed and the lever is in position N for mor
e
than about one second at a speed of less
than 5 km/h (3 mph).
Safety interlock for ignition key
Once the ignition has been turned off, the key
may be removed only if the gear selector is in
position P. While the key is not in the ignition,
the selector lever is locked in position P. WARNING

Start and driving
Note

Driving

Start and driving

Driving
for fuel) facilitates improved fuel consumption
and emission bal ance
.
If the vehicle has SEAT Drive Profile
››› page 207, the inertia mode can be activa-
ted in the Normal, Eco and Individual pro-
files. In the Eco profile, it is activated whenev-
er the operating conditions are met, regard-
less of how smoothly you remove your foot
from the accelerator. WARNING

Start and driving
Manual release of the selector lev-
er Fig. 144
Gear selector lever: manual release
fr om the parking position. In the event of a power failure when starting
(e
.g. dischar
ged battery), the lever will remain
locked in position P. To move it to position N to
move the vehicle, there is an emergency re-
lease device under the centre console, on the
right side. Releasing the selector lever re-
quires a certain degree of practical skill.
Removing the cover from the selector lev-
er

Driving
Note
The recommended gear indication turns off
when the clut ch pedal is pr
essed or when
the lever is removed from the tiptronic posi-
tion. Steering
Inf ormation r

elating to different ve-
hicle processes. Electro-mechanical power steering adapts
el
ectr

onically to the speed of the car, torque
and steering angle.
Even if the power steering fails or the engine
is stopped, it is possible to continue to rotate
the steering wheel as long as the key remains
in the ignition lock, but more force must be
applied.
Steering assist
This help assists the driver in critical situa-
tions. It recommends turning the steering
wheel to perform a corrective manoeuvre
(counter-steering), turning slightly to avoid
skidding ››› . WARNING
Steering assist helps the driver in critical
sit uations. The driv

er is the person who has
to control the vehicle's steering at all times. Control lamp
v
It lights up red
Faulty steering.
Do not continue driving, st op the v

ehicle as soon as
possible and in a safe manner.
Take the vehicle to a specialised workshop and have
the fault repaired as soon as possible. v
It lights up yellow
Limited steering operation.
Driv e car

efully to a specialised workshop to have the
steering checked.
If the warning light does not come on again after re-
starting the engine and driving a short distance, it is
not necessary to check the steering.
OR: The 12-v olt batt
ery was disconnected and re-
connected.
Drive a short distance at 15-20 km / h (9-12 mph). v
It flashes yellow
The steering column is jammed.
When st opped, t

urn the steering wheel in both direc-
tions.
OR: The st eering column does not unlock or lock.
R
emove the key from the ignition switch and recon-
nect it. Consider the messages shown on the instru-
ment panel display.
Do not continue driving if the steering column re-
mains locked after switching on the ignition. Seek
specialist assistance. The control lamp should light up for a few
seconds when the ignition is s
wit

ched on. It
should go out once the engine is started. WARNING
Never ignore the warning lamps or messag-
es.

Start and driving
SEAT Drive Profiles* Intr oduction The SEAT Drive Profile enables the driver to
choose betw
een the Eco, Normal, Sport and
,ndividual pr
ofiles, which modify the be-
haviour of several vehicle functions, providing
different driving experiences.
The ,ndividual profile can be configured
according to personal preferences. The other
profiles have a fixed configuration.
Description Depending on the equipment fitted in the ve-
hicl
e

, SEAT Drive Profile can operate on the
following functions:
Engine
Depending on the profile selected, the engine
responds more quickly or smoothly to the ac-
celerator being pressed. When the Eco profile
is selected, the Start-stop function is activa-
ted.
In vehicles with automatic transmission, the
gear change timing is changed to put the
changes at higher or lower revolutions. The
Eco profile activates the Inertia function,
thereby reducing consumption. The rest of
the driving profiles will activate the inertia use function when the selector lever is not in the S
position, depending on how the accel

erator
pedal is released ››› page 203
. When the ve-
hicle is turned on again, the function is activa-
ted by default to reduce consumption.
With manual transmission, the Eco profile
changes the gear change recommendations
to facilitate more efficient driving.
“Dual Ride” suspension*
The “Dual Ride” suspension sets the suspen-
sion to comfortable in the Eco and Normal
profiles, and to sport in the Sport profile. In
the ,ndividual profile the suspension can
be switched between Normal or Sport, de-
pending on personal preference.
In the event of a fault in the “Dual Ride” sus-
pension, the following message is displayed
on the instrument panel screen Fault
shock absorber regulation .
Steering
Power steering becomes harder in the Sport profile to enable a sportier driving style.
Air conditioning
In vehicles with Climatronic, this can operate
in the Eco profile, especially restricting fuel
consumption. Adaptive Cruise Control (ACC)*
The ACC’s accel
eration and braking mode
varies according to the driving profile
››› page 222.
Setting the driving profile Fig. 145
Next to the gear lever: MODE button. You can select from Normal
, Sport, Eco and
,ndividual .
Y ou can sel

ect the required profile either by
repeatedly pressing the selection button
››› Fig. 145, or by using the touch screen, in
the menu that opens when the aforemen-
tioned button is pressed.
An icon on the touch screen provides infor-
mation about the active profile.
The illumination of the button

Driving
Driving pro-
file Char
acteristics
 Places the vehicle in a low state
of consumption, f
acilit

ating a
fuel-saving driving style that is
respectful to the environment.