Seat Leon 2020 Owner's manual

Page 231 of 399

Start and driving
WARNING
When the engine is running, the vehicle will
st ar
t to move as soon as a gear is engaged
and the clutch released. This also happens
if the electronic parking brake is switched
on.


Page 232 of 399

Driving
 – P
arking l ock
When the P button is pressed, the drive
wheels are locked. Only press P when the ve-
hicle is stationary ››› .
T o pr

ess the P button you must press the
brake pedal simultaneously.
 – Reverse gear
Reverse gear must be engaged only when
the vehicle is stationary and the engine is
idling ››› .
T o engage r

everse gear R, you must press the
brake pedal simultaneously. The reverse
lights switch on when the reverse gear R is
selected and the ignition is on.
 – Neutral
In this position, the gear is in neutral.
Press the brake pedal to move the lever from
N to D/S when the vehicle is stationary or at
speeds below 3 km/h (2 mph) ››› .
 – P
ermanent f

orward drive position
The D/S position enables the gears to be op-
erated in normal mode (D) or sport mode (S).
To select Sport mode S, move the lever back-
wards. Pushing the lever again will select nor-
mal mode D. The selected driving mode is
displayed on the instrument panel screen.
In normal mode (D), the gearbox selects the
best gear ratio. This depends on the engine load, the road speed and the dynamic gear
control pr

ogramme (DCP).
Sport mode (S) should be selected for a
sporty driving style. This setting makes use of
the engine's maximum power output. When
accelerating the gear shifts will be noticea-
ble.
Under certain circumstances (e.g. on moun-
tain roads) it can be advantageous to switch
tiptronic mode ››› page 231
, to adapt the
gears to suit the road conditions.
Selector lever lock
In N, the lever lock prevents a gear range
from being engaged, and prevents the vehi-
cle from moving off accidentally.
Press and hold the brake pedal with your left
foot with the engine running.
As a reminder to the driver, when the lever is
in position N the following indication will be
shown on the screen:
When stationary, apply footbrake
while selecting a gear.
The lever is not locked if it is moved quickly
through position N (e.g. when shifting from R
to D). This makes it possible, for instance, to
“rock the vehicle backwards and forwards” if
it is stuck in snow or mud. The lever lock en-
gages automatically if the brake pedal is not
pressed and the lever is in position N for more than about one second at a speed of less
than 5 km/h (3 mph). WARNING


Page 233 of 399

Start and driving
possible to move the lever. If this should
happen the manual r
el
ease can be used. In
this case, you should seek professional as-
sistance. Note


Page 234 of 399

Driving
Driving down hills
Under cert ain cir
cumstances it may be ad-
vantageous to use the Tiptronic mode to se-
lect the gear manually according to driving
conditions ››› .
St op/P

ark
To park on flat ground, just press the P button
››› Fig. 165. On slopes the parking brake
should first be applied and then press the P
button.
If the driver door is opened and the P button
has not been activated, the vehicle could
move. The following warning is displayed on
the instrument panel:

Page 235 of 399

Start and driving
automatic gearbox will be damaged by
l
ack of lubrication.


Page 236 of 399

Driving
Downhill speed control is deactivated as
soon as the r oad l
evels out again or you press
the accelerator pedal.
On vehicles with cruise control system*
››› page 245, downhill speed control is acti-
vated when you set a cruising speed. WARNING
The downhill speed control cannot defy the
l aws of physics. Ther

efore, speed cannot
be maintained constant in all situations. Al-
ways be prepared to use the brakes! Inertia mode
The inertia mode allows you to travel certain
dist
ances without using the accel

erator,
which saves fuel. Plan ahead and use the in-
ertia mode to “let” the vehicle “roll”.
Activation of the inertia mode
Condition: lever in position D, slopes of less
than 12% and speeds between 20 and 130
km / h (12 and 80 mph).


Page 237 of 399

Start and driving
Faults in the gearbox

Page 238 of 399

Driving
Steering Inf ormation r
elating to different ve-
hicle processes. Electro-mechanical power steering adapts
el
ectr

onically to the speed of the car, torque
and steering angle.
Even if the power steering fails or the engine
is stopped, it is possible to continue to rotate
the steering wheel as long as the key remains
in the ignition, but more force must be ap-
plied.
Progressive steering
Depending on the vehicle’s features, it may or
may not incorporate a progressive steering
system.
In city traffic you do not need to turn so much
on parking, manoeuvring or in very tight turns.
On the road or on the motorway, progressive
steering transmits, for example, in bends, a
sportier, more direct and noticeably more dy-
namic driving sensation. Control lamp v
It lights up red
Faulty steering.
Do not continue driving, stop the v
ehicle as soon as
possible and in a safe manner.
Take the vehicle to a specialised workshop and have
the fault repaired as soon as possible. v
It lights up yellow
Limited steering operation.
Driv e car

efully to a specialised workshop to have the
steering checked.
If the warning light does not come on again after re-
starting the engine and driving a short distance, it is
not necessary to check the steering.
OR: The 12-v olt batt
ery was disconnected and re-
connected.
Drive a short distance at 15-20 km / h (9-12 mph). v
It flashes yellow
The steering column is jammed.
When st opped, t

urn the steering wheel in both direc-
tions.
OR: The st eering column does not unlock or lock.
T
urn off the ignition and turn it on again. Consider the
messages shown on the instrument panel display.
Do not continue driving if the steering column re-
mains locked after switching on the ignition. Seek
specialist assistance. The control lamp should light up for a few
seconds when the ignition is s
wit

ched on. It
should go out once the engine is started. WARNING
Never ignore the warning lamps or messag-
es.


Page 239 of 399

Start and driving
Description Depending on the equipment fitted in the ve-
hicl
e
, SEAT Drive Profile can operate on the
following functions:
Engine
Depending on the profile selected, the engine
responds more quickly or smoothly to the ac-
celerator being pressed. When the Eco pro-
file is selected, the Start-stop function is acti-
vated.
In vehicles with automatic transmission, the
gear change timing is changed to put the
changes at higher or lower revolutions. The
Eco profile activates the Inertia function,
thereby reducing consumption. The rest of
the driving profiles will activate the inertia use
function when the selector lever is not in the S
position, depending on how the accelerator
pedal is released ››› page 234
. When the ve-
hicle is turned on again, the function is activa-
ted by default to reduce consumption.
With manual transmission, the Eco profile
changes the gear change recommendations
to facilitate more efficient driving.
Dynamic chassis control (DCC)*
The DCC continuously adapts the damping
of the suspension system to the characteris-
tics of the road surface and the driving situa-
tion (speed, acceleration and steering wheel angle) according to the selected driving pro-
fil
e

. The vehicle's dynamic behaviour is also
adapted to improve grip on curves and turn-
ing capacity. Within the Individual profile you
can also adjust the DCC level in a custom-
ised manner.
In the event of a fault in the DCC, the follow-
ing message is displayed on the instrument
screen Fault: shock absorber regula-
tion
Steering
The power steering varies its driving modes
and adapts to the profile selected, thus offer-
ing the best behaviour for each situation.
Air conditioning
The Climatronic can operate in Eco mode
with particularly limited consumption.
Adaptive Cruise Control (ACC)*
Depending on the driving profile, the perform-
ance of the ACC varies, to allow more sporty
acceleration and braking or a more respect-
ful fuel consumption.
PreCrash system
The PreCrash system adapts according to
the selected configuration. The Sport driving
profile has specific settings to adapt to driv-
ing characteristics ››› page 24
. Setting the driving profile There are several ways to select a driving
pr
ofil

e using the infotainment system:


Page 240 of 399

Driving
Driving pro-
file Char
acteristics
D
Convenience a)It permits mor

e relaxed and
comf ort

able driving, for example
for long motorway journeys. Its
main characteristic is the soft
suspension setting (DCC).

Page:   < prev 1-10 ... 191-200 201-210 211-220 221-230 231-240 241-250 251-260 261-270 271-280 ... 400 next >