phone Seat Leon 5D 2005 COMMUNICATION SYSTEM

Communication
14Commands for operating the hands-free system
Speech commands for operating the internal telephone book:Control commands
The control commands are used to carry out functions that have already be en chosen or enteredThe control commands are used during or at the end of a dialogue to carry out
certain functions.Speech command
Effect
ENTER PIN CODE
a)
a)Only available when the telephone is in the adapter .
After this command the PIN code for the telephone ca n be specified
DIAL NUMBER
After this command you can specify a telephone number and e stablish a con-
nection
REDIAL
After this command the last dialled telephone number will be redialled
Speech command
Effect
SELECT NAME
After this command you can call a number that has been r ecorded in the
phone book under a name.
STORE NAME
After this command you can store a name with a telephone numbe r in the
phone book
DELETE NAME
After this command you can delete a name from the ph one book.
PLAY PHONE BOOK
After this command you can listen to the names stored i n the phone book
DELETE PHONE BOOK
After this command you can choose to delete the entire phone book or just a
single name
Comunica ingles Seite 14 Montag, 23. Mai 2005 1 :49 13

Communication15
Operating instructionsPossible commands
PIN code input
A PIN code must be entered before you can use the telephone system.– Press the talk button .
– After the acoustic tone give the command
ENTER PIN.You can specify your PIN code after giving the command.
It is only possible to enter the PIN code when:•
the ignition and
•
the mobile phone are switched on.
•
the phone is in the mobile phone adapter. You can specify the digits from
zero to nine . After each block of digits you
specify (separated by a brief pause) the system will repe at the digits.
The system can only recognise single digi ts (two, three, etc.), and not combi-
nations of digits (e.g. twenty-three).Speech command
Effect
DIAL
Telephone number already entered is dialled.
STORE
The name and telephone number will be stored in the int ernal phone book or
the entered PIN code will be stored.
CANCEL
Cancels a running dialogue.
REPEAT
The specified name or all of the digits specified up to this point will be
repeated. The system will then give the cue <Please proceed> so that you can
specify additional digits or commands.
CORRECTION
The specified name or the last entered block of digits will be deleted. The sys-
tem will then give the cue <Please proceed> so that you can specify additional
digits or commands.
ERASE
All specified digits will be deleted. The system will th en give the cue <The
number is deleted. The number, please?> so that you can specify new digits or
commands.

Comunica ingles Seite 15 Montag, 23. Mai 2005 1 :49 13

Communication
16Example for entering a PIN code
A running dialogue can be cancelled at any time w ith a press of the talk
button .
Note
•
If the PIN code is more than 8 digits long, the system w ill decline and give
the cue <The PIN is too long> .
•
If the specified PIN code is incorrect, the system will decline and give the
cue <The PIN is incorrect> .
•
If the wrong PIN code is entered three times, the SIM c ard will be blocked.
The SIM card can be unblocked with the PUK (persona l unblock key). The
personal unblock key (PUK) can only be entered via the phone keypad and
not via the speech control system .Speech command
Condition
System cue
Effect
ENTER PIN CODE
The SIM card is installed, the tele-
phone is on and fitted to the adapter.
<The PIN, please?>
Dialogue
for example, ZERO, ONE, TWO, THREE
<Zero, one, two, three>
Dialogue
If no command is specified, the system responds afte r about 5 seconds with the next cue.No command
<Possible commands: Store, repeat,
back, delete, or specify additional
digits>
Dialogue
STORE
<The PIN is saved.>
DialogueEnd of dialogue

Comunica ingles Seite 16 Montag, 23. Mai 2005 1:49 13

Communication17
Operating instructions
Dial number
A telephone number can be vocally specified to the system and then dialle d.– Press the talk button . Activation of the system is confirmed
with by a tone.
– After the tone, say the command DIAL NUMBER .After this command the system will then request that y ou specify a telephone
number. A connection will then be established to t he specified number. The
telephone number can be specified all at once, i n blocks of digits (separated
by a brief pause), or as single digi ts. You can specify the digits from zero to nine
. After each block of digits you specify (separated by a brief pause) the
system will repeat the digits. The system can only reco gnise single digits
(two, three, etc.), and not combinat ions of digits (e.g. twenty-three).
Notes on specifying telephone numbers:
•
If the telephone number has more than 20 digits, the s ystem will decline
and give the cue <The number is too long> .
•
A Plus (+) can also be placed ahead of the 20 digits.
Example for entering a telephone number:
A running dialogue can be cancelled at any time with a p ress of the talk
button .

Speech command
Condition
System cue
Effect
DIAL NUMBER
Phone switched on
<The number, please?>
Dialogue
for example, ZERO, SEVEN, THREE,
ONE
<Zero, seven, three, one>
Dialogue
If no command is specified, the system responds afte r about 5 seconds with the next cue.No command
<Possible commands: dial, repeat,
correct or specify additional digits>
Dialogue
THREE, NINE, TWO
<Three, nine, two>
Dialogue
DIAL
<The number is being dialled.>
Dialogue -The telephone number
0731492 will be dialledEnd of dialogue

Comunica ingles Seite 17 Montag, 23. Mai 2005 1:49 13

Communication
18Redial– Press the talk button .
– After the tone, say the command REDIAL.
After giving the command the last number dialled via th e hands-free system
will be dialled again.
Example for the REDIAL command:
A running dialogue can be cancelled at any time wit h a press of the talk
button .
To record names in the phone book
You can store names along with a telephone number in the internal telephone book.– Press the talk button . The beep tone indicates that the
system is ready.
– After the tone, say the command STORE NAME.After giving the command the system will request you to specify a name and
telephone number to store in the internal telephone book. The telephone book has enough memory for 50 names and numbers. Y
ou can specify the
digits from zero to nine .
The telephone number can be specified all at once, in bloc ks of digits (sepa-
rated by a brief pause), or as single digits. After each block of digits you
specify (separated by a brief pause) the system will r epeat the digits. The
system can only recognise single digits (two, three, etc.) , and not combina-
tions of digits (e.g. twenty-three).
Say STORE to store the entry into the telephone book.

Speech command
Condition
System cue
Effect
REDIAL
Phone switched on
<The number is being dialled.>
DialogueEnd of dialogue


Speech command
Condition
System cue
Effect
STORE NAME
Telephone book is not full
<The name, please?>
Dialogue
COMPANY XYZ
<Please repeat the name>
Dialogue
Comunica ingles Seite 18 Montag, 23. Mai 2005 1 :49 13

Communication19
Operating instructionsA running dialogue can be cancelled at any time with
a press of the talk
button .
Note
•
If the telephone number has more than 20 digits, the sy stem will decline
and give the cue <The number is too long> .
•
A Plus (+) can also be placed ahead of the 20 digits.
•
Say the command Delete or Back to delete or correct the corresponding
block of digits.
•
Say Repeat to have all the digits that have been recognised up to that
point repeated.
•
If two or more names sound alike, it is better to save the n ames including
the first name or some other distinguishing entry .
•
A running dialogue can be cancelled at any time with a press of the talk
button .
•
The telephone book works only in conjunction with the h ands-free speech
control system; the entries are not stored on the phone 's SIM card.COMPANY XYZ
<The number, please?>
Dialogue
ZERO, ONE, TWO, THREE
<Zero, one, two, three>
Dialogue
FOUR, FIVE, SIX
<Four, five, six>
Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.No command
<Possible commands: Store, repeat,
back, delete, or specify additional
digits>
Dialogue
STORE
<The name is saved.>
Dialogue - The name COMPANY XYZ
with the telephone number 0123456
will be storedEnd of dialogue

Comunica ingles Seite 19 Montag, 23. Mai 2005 1:49 13

Communication
20Calling a name in the phone book– Press the talk button
– After the tone, say the command SELECT NAME
After the system has recognised this command, you m ay select a stored entry
from the telephone book to call the required number . The system best recog-
nises names spoken by the person who stored the name.
Example for selecting a name from the internal telep hone book
A running dialogue can be cancelled at any time wi th a press of the talk
button .

Speech command
Condition
System cue
Effect
SELECT NAME
Phone is switched on, telephone book
contains entries.
<The name, please?>
Dialogue
COMPANY XYZ
<Company XYZ>
Dialogue
If no command is specified, the system responds afte r about 5 seconds with the next cue.No command
<Possible commands: select, repeat,
back>
Dialogue
DIAL
<The number is being dialled.>
Dialogue - The telephone number for
Company XYZ is being dialledEnd of dialogue

Comunica ingles Seite 20 Montag, 23. Mai 2005 1:49 13

Communication21
Operating instructions
Listening to the phone book
You can have the entries stored in the internal telephone book read out to y ou.– Press the talk button . The beep tone indicates that the
system is ready.
–Say the command PLAY PHONE BOOK.
After giving the command the system will read out th e entries stored in the
phone book. Press the talk button as an entry is being read to dial the
telephone number for that entry. Once the dialogue is complete and the
system is reactivated, you can also select an entry to call by specifying the
stored name.
Example for the PLAY PHONE BOOK command:
Example for selecting an entry:
To erase names from the phone book
You can delete entries from the internal telephone book.– Press the talk button . The beep tone indicates that the system is ready.
– After the tone, say the command DELETE NAME .
After giving this command you can delete a stored entry from the internal tele-
phone book.


Speech command
Condition
System cue
Effect
PLAY PHONE BOOK
The telephone book contains entries.
The telephone book will then be read
out.End of dialogue
Speech command
Condition
System cue
Effect
PLAY PHONE BOOK
The telephone book contains entries;
the talk button is pressed as the
entry is being read out.
<The number is being dialled.>
The selected name will be repeated.
The telephone number will be dialled.End of dialogue


Comunica ingles Seite 21 Montag, 23. Mai 2005 1 :49 13

Communication
22Example for deleting single names from the internal t elephone book:
A running dialogue can be cancelled at any time with a pre ss of the talk
button .
Note
•
Say the command Repeat, if you would like to have the specified name
repeated by the system.
•
If you then say No, the system will answer with <Cancel> and the dialogue
will be ended.
To erase the phone book
You can delete the entire phone book or single entries.– Press the talk button .
– After the tone, say the command DELETE PHONE BOOK.After giving this command you can delete the entire internal phone book or
single entries as desired.Speech command
Condition
System cue
Effect
DELETE NAME
The telephone book contains entries.
<The name, please?>
Dialogue
COMPANY XYZ
<Do you want to delete the entry Com-
pany XYZ?>
Dialogue
If no command is specified, the system responds afte r about 5 seconds with the next cue.
Dialogue
No command
<Possible commands: yes, no, repeat,
back>
Dialogue
Ye s
<The name is deleted.>
DialogueEnd of dialogue


Comunica ingles Seite 22 Montag, 23. Mai 2005 1:49 13

Communication23
Operating instructionsExample for deleting the entire internal telephone bo
ok:
Example for deleting single names from the internal telephone book:
Speech command
Condition
System cue
Effect
DELETE PHONE BOOK
The telephone book contains entries.
<Would you like to delete the whole
phone book?>
Dialogue
If no command is specified, the system responds afte r about 5 seconds with the next cue.
Dialogue
No command
<Possible commands: Yes, no>
Dialogue
Ye s
<Are you sure?>
Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
Dialogue
No command
<Possible commands: Yes, no>
Dialogue
Ye s
<The phone book is deleted.>
All entries in the phone book will be
deleted.End of dialogue
Speech command
Condition
System cue
Effect
DELETE PHONE BOOK
The telephone book contains entries.
<Would you like to delete the whole
phone book?>
Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
Dialogue
No command
<Possible commands: Yes, no, back>
Dialogue
NO
The telephone book will then be read
out.
No command
Talk button pressed as the entry to
be deleted is read out.
<Do you want to delete the entry
(name)?>
Dialogue
If no command is specified, the system responds after about 5 seconds with the next cue.
Dialogue

Comunica ingles Seite 23 Montag, 23. Mai 2005 1:49 13