ignition Seat Tarraco 2018 Owner's manual

The essentials
Do not pull too hard with the towing vehicle
and t ak
e car
e to avoid jerking the tow rope.
When towing on an unpaved road, there is al-
ways a risk of overloading and damaging the
anchorage points.
Switch on the ignition so that the turn signals,
windscreen wipers and windscreen washer
can work. Ensure that the steering wheel is
unlocked and moves freely.
Place the gear lever in neutral on vehicles
with a manual gearbox. With an automatic
gearbox, place the lever in N.
To brake, press the brake pedal firmly. The
brake servo does not work when the engine is
switched off.
The power steering only works when the igni-
tion is switched on and the vehicle is moving,
provided that the battery is sufficiently
charged. Otherwise, it will need more force.
Ensure that the tow rope remains taut at all
times.

The essentials
How to jump start: description Fig. 81
Diagram of connections for vehicles
without St art Stop syst
emFig. 82
Diagram of connections for vehicles
with St art Stop syst

emJump lead terminal connections
Swit
ch off the ignition of both v

ehicles

Seat belts
Rear seat belts fastened display* Fig. 88
Dashboard: left rear seat occupied
and corr esponding seat belt f ast
ened display.Depending on the model version, when the
ignition is s
wit
ched on, the seat belt st

atus
display

Transporting children safely
Airbag system control lamps T
It lights up on the combi-instru-
ment
Fault in airbag system and seat belt tensioners.
Have the system check ed immediately by a special-
ised workshop.  
It lights up on the dash panel
Front passenger front airbag disabled.
Check whether the airbag should r emain disabl

ed x
It lights up on the dash panel
Front passenger airbag enabled.
The control lamp s
witches off automatically 60 sec-
onds after the ignition is switched on Several warning and control lamps light up
f
or a f
e

w seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
If the airbag and seat belt tensioner system
control lamp T remains on or flashes, it indi-
cates a malfunction in the airbag and seat
belt tensioner system

Operation
throughout the journey, in litres/100 km;
and with the engine running and the v e-
hicl e st
opped, in litres/hour. The average
fuel consumption is displayed after driv-
ing for approximately 300 metres.
This indicates the hours
(h) and minutes (min) since the ignition
was switched on.
Approximate distance in
km that can still be travelled if the same
driving style is maintained.
Approxi-
mate distance in km that can still be
travelled with the current level of the
AdBlue

Operation
Check a service warning
With the ignition s wit
ched on, the engine off
and the v
ehicle at a standstill, the current
service notification can be read:
Check the date of the current service on the
infotainment system

Opening and closing
Unlocking and locking the vehicle
with K eyl
ess Access* Fig. 120
Keyless Access locking and ignition
syst em:
 In the pr
o
ximity of the car.  Open-
ing the rear lid with sensor-controlled opening
(Easy Open) Fig. 121
Keyless Access locking and ignition
system: door handl e

.

Operation
passenger door has been opened and the
k ey has not been r
emo
ved from the ignition.
Safety switch _* The safety switch

Lights and visibility
Several warning and control lamps light up
f or a f
e
w seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds. WARNING
Observe the safety warnings

Air conditioning
Function button: function
Departure time 1 , Departure time
2, Departure time 3 : Three differ
ent de-
parture times (hh.mm) may be programmed. If
the auxiliary heater should only be switched
on a certain day of the week, this can also be
selected.
Duration : The duration det ermines the oper
-
ating time of the auxiliary heater when switch-
ed on using the fast heating button  on the air conditioning controls. The duration is also
used to calculate the departure time for the
manual air conditioner. It can be set between
10 and 60 minutes at 10-minute intervals.
E This returns to the main menu. The programmed departure time determines
the appr
oximat

e time it should take to reach
the temperature set in the vehicle. The start of
the heating operation is determined automat-
ically depending on the outside temperature.
Checking the programming
When a departure time is activated and the
ignition is switched off the control lamp of the
fast heating button  lights up for approxi- mately 10 seconds. WARNING
Never programme the auxiliary heater so
that it swit ches itself on and is running in an
encl

osed space or an area with no ventila-
tion. The auxiliary heater exhaust fumes contain carbon monoxide, an odourless
and colourl
ess t

oxic gas. Carbon monoxide
can cause people to lose consciousness. It
can also cause death. Operating instructions
The auxiliary heater exhaust system located
belo
w the v

ehicle must be kept clear of snow,
mud and other objects. The exhaust fumes
must be able to exit freely. The emissions
generated by the auxiliary heater are re-
moved via an exhaust pipe fitted underneath
the vehicle.
On heating the vehicle interior, depending on
the outside temperature, the warm air is first
directed at the windscreen and then to the
rest of the vehicle interior through the air
vents. Directing the diffusers