Seat Toledo 2018 Owner's manual

Page 121 of 300

Opening and closing
Controls for the windows Oper ation of the el
ectric windo
wsFig. 128
Detail of the driver door: controls for
the windo ws. Read the additional information carefully

Page 122 of 300

Operation
If an obstacle is present, the closing mecha-
nism will st op and the windo
w will r
oll back a
few centimetres.
If an obstacle prevents closing for the next 10
seconds, the closing mechanism will once
again stop and the window will roll back an-
other few centimetres.
If in the next 10 seconds you attempt to close
the window after it has rolled back the sec-
ond time, only the closing mechanism will be
stopped even if the obstacle is still present.
The roll-back function is still connected.
The roll-back function will only be disconnec-
ted if you once again attempt to close the
window in the following 10 seconds. In this
case, the window will close at full force.
If you wait for a further 10 seconds, the roll-
back function will be once again connected. Lights and visibility
Lights Intr oduction Read the additional information carefully

Page 123 of 300

Lights and visibility

It lights up
Main beam on or flasher on

Page 124 of 300

Operation


Page 125 of 300

Lights and visibility
long as you hold the lever, e.g. when chang-
ing l anes.
Conv enience t
urn signals
For the convenience turn signals, move the
lever as far as possible upwards or down-
wards and release the lever. The turn signal
will flash three times.
The convenience turn signals are activated
and deactivated in the Easy Connect system
via the  button and the
SETTINGS function
butt on

Page 126 of 300

Operation
Fog lights* Fig. 132
Instrument panel: light panel. Switching on front fog lights

Page 127 of 300

Lights and visibility
The light is adjusted according to the data re-
cor ded by the light sensor that is inst
all
ed be-
tween the windscreen and the inside rear
view mirror.
The function automatically turns on the side
lights and headlights, the lighting for the en-
try area on the exterior mirrors and the num-
ber plate light.
“Coming Home” function
The light is automatically switched on when
the driver door is opened (for 60 seconds af-
ter the ignition is switched off).
The light is switched off when all the doors
and the rear lid are closed.
If a door or the rear lid remains open, the light
will switch off after 60 seconds.
“Leaving Home” function
The light is automatically switched on when
the vehicle is unlocked using the remote con-
trol.
The light is switched off after 10 seconds or
when the vehicle is locked. Hazard warning lights switch
Fig. 133
Instrument panel: switch for hazard
w arning lights.

Page 128 of 300

Operation
When a car that is manufactured in a country
that driv es on the right tr
av
els to a country
that drives on the left (or vice versa), it is nor-
mally necessary to cover part of the head-
light bulbs with stickers or to change the ad-
justment of the headlights to avoid dazzling
other drivers.
In such cases, the regulations specify certain
light values that must be complied with for
designated points of the light distribution. This
is known as “Tourist light”.
The light distribution of the halogen and full-
LED headlights allows the specific “tourist
light” values to be met without the need for
stickers or changes in the settings. Note
“Tourist light” is only allowed temporarily. If
you are pl anning a l

ong stay in a country
that drives on the other side, you should
take the vehicle to an Authorised Technical
Service to change the headlights. Interior lights
Int erior lighting Fig. 134
Interior lighting

Page 129 of 300

Lights and visibility
Press the button

Page 130 of 300

Operation
Sun visors Fig. 138
Driver

Page:   < prev 1-10 ... 81-90 91-100 101-110 111-120 121-130 131-140 141-150 151-160 161-170 ... 300 next >