ESP SEAT TOLEDO 2019 Owners Manual

Introduction
Thank you f or your trust choosing a SEAT v
e-
hicl
e.
With your new SEAT, you will be able to enjoy
a vehicle with state-of-the-art technology
and top quality features.
We recommend reading this Instruction Man-
ual carefully to learn more about your vehicle
so you can enjoy all its benefits in your daily
driving.
Information about handling is complemented
with instructions regarding the operation and
maintenance of the vehicle in order to ensure
its safety and maintain its value. Moreover, we
want to give you valuable advice and tips to
drive your vehicle efficiently and respecting
the environment.
We wish you safe and enjoyable motoring.
SEAT, S.A.
WARNING
Read and always observe safety infor-
mation concerning the passenger

Seat belts
Head-on collisions and the laws of
physics Fig. 77
A driver not wearing a seat belt is
thr own f
orward violently. Fig. 78
The unbelted passenger in the rear
seat is thr own f

orward violently, hitting the driv-
er wearing a seat belt The effects of the laws of physics in the case
of a head-on collision ar
e easy t
o e

xplain: the
moment a vehicle starts moving, a type of en- ergy called “kinetic energy” starts acting on
both the vehicle and its passengers.
The amount of “kinetic ener

gy” depends on
the speed of the vehicle and on the weight of
the vehicle and of its passengers. The higher
the speed and the greater the weight, the
more energy there is to be “absorbed” in an
accident.
The most significant factor, however, is the
speed of the vehicle. If the speed doubles
from 25 km/h (15 mph) to 50 km/h (30 mph),
for example, the corresponding kinetic ener-
gy is multiplied by four.
Because the vehicle occupants in our exam-
ple are not restrained by seat belts, in the
event of crashing against a wall, all of the oc-
cupants

Operation
object. The most significant factor, however,
is the speed of the v ehicl
e
.
Example: An object weighing 4.5 kg is lying
unsecured in the vehicle. During a frontal col-
lision at a speed of 50 km/h (31 mph), this ob-
ject generates a force corresponding to 20
times its weight. That means that the effective
weight of the object increases to approxi-
mately 90 kg. You can imagine the severity of
the injuries which might be sustained if this
“object” strikes an occupant as it flies through
the interior of the vehicle. This increased risk
of injury will be further increased if a loose
object is struck by an inflating airbag. WARNING

Operating modes
by the Infotainment system via their corre-
sponding driv es or audio input sock
ets (int
er-
nal CD drive, memory card slot, AUX-IN multi-
media socket etc.).
Copyright
Audio and video files on data storage devices
are usually protected by intellectual property
rights, as per the corresponding national and
international laws. Be aware of the current le-
gal provisions! Note

Infotainment System
Messages and symbols on the Media main
menu Display: Meaning
A Displays information about the artist
name, album name and song titl
e (CD
t
ext  , ID3 tag on compressed audio
files).
Audio CD: displays track information. If
no data is avail
able, it only displays
Track and the number corresponding to
the position it occupies on the data stor-
age device.
B Album cover display: If there are various
cov
ers within the same f

older/album, the
system only displays one of them.
It prioritizes displaying the covers in the
following manner:
1. Cover embedded in the file(s).
2. Image in file folder.
3. Default icon of the connected device.
C The playing time so far and time remain-
ing in minutes and seconds. In the case
of audio fil
es with v

ariable bit rates (VBR)
the remaining time may vary.
TP a) The TP function is active and can be
used: sel
ect
Radio ! Settings !
Traffic programme (TP) .
 a) Ther

e are no traffic stations available:
select Radio ! Settings ! Traf-
fic programme (TP). a)
Depends on the market and unit in question. Note

Operating modes
Vehicle status
Pr ess the
Vehicle status butt
on to access
information on the Vehicle status mes-
sages and Start-Stop system . The Vehicle
status messages are displayed, in addition to
being specified on the corresponding button.
Telephone General information Fig. 206
Related video The Telephone functions described below
can be used thr
ough the Inf
ot

ainment system
if there is a mobile telephone connected to it
via Bluetooth

Driving
pollutant emissions are also especially high
during this initial w arm-up phase
. It is ther
e-
fore best to drive off immediately after start-
ing the engine. Avoid running the engine at
high speed.
Periodic maintenance
Periodic maintenance work guarantees that,
before beginning a journey, you will not con-
sume more than the required amount of fuel.
A well-serviced engine gives you the benefit
of improved fuel efficiency as well as maxi-
mum reliability and an enhanced resale val-
ue.
A badly serviced engine can consume up to
10% more fuel than necessary.
Avoid short journeys
To reduce the consumption and emission of
polluting exhaust gases, the engine and the
exhaust gas filtration systems should reach
the optimum operating temperature.
With the engine cold, fuel consumption is pro-
portionally higher. The engine does not warm
up and fuel consumption does not normalise
until having driven approximately four kilome-
tres (2.5 miles). This is why we recommend
avoiding short trips whenever possible.
Maintain the correct tyre pressures
Bear in mind that keeping the tyres at an ade-
quate pressure saves fuel. If the tyre pressure is just one bar (14.5 psi/100 kPa) too low, fuel
consumption can increase by as much as 5%.
Due to the gr
eater rolling resistance, under-
inflation also increases tyre wear wear and
impairs handling.
The tyre pressures should always be checked
when the tyres are cold.
Do not use winter tyres all year round as
they increase fuel consumption by up to 10%.
Avoid unnecessary weight
Given that every kilo of extra weight will in-
crease the fuel consumption, it is advisable to
always check the luggage compartment to
make sure that no unnecessary loads are be-
ing transported.
A roof rack is often left in place for the sake of
convenience, even when it is no longer nee-
ded. At a speed of 100 km/h (62 mph) and
120 km/h (75 mph) your vehicle will use about
12% more fuel as a result of the extra wind re-
sistance caused by the roof rack even when it
is not in use.
Save electricity
The engine activates the alternator, which
produces electricity. With the need for elec-
tricity, fuel consumption also increases. Be-
cause of this, always turn off electrical devi-
ces when you do not need them. Examples of
devices that use a lot of electricity are: the fan at high speeds, the rear window heating
and the seat heaters*. Note

Checking and refilling levels
Diesel with biodiesel (“B” st ands f
or Bio-
diesel). The number indicates the per-
centage of biodiesel in the diesel. “B7”
means, for example, a proportion of bio-
diesel of max. 7%.
Natural gas: “CNG” means Compressed
Natural Gas.
Type of petrol  Applies to vehicles: with petrol engine
The corr ect gr

ade of petrol is listed inside the
fuel tank flap.
The vehicle is equipped with a catalytic con-
verter and must only be run on unleaded
petrol. The petrol must comply with the
standard EN 228 and be sulphur-free. Fuels
with a 10% ethanol ratio can be refuelled
(E10) 1)
. The types of petrol are differentiated
by using the octane numbers (RON) or via
the anti-knock index (AKI).
The following pieces of text show the infor-
mation included in the corresponding stickers
on the tank lid (examples): 2 3 Super unleaded petrol 95 octane petrol or
normal 91 oct
ane petr
ol at l

east
We recommend refuelling with super 95 oc-
tane petrol (91 AKI). If not available: normal 91
octane petrol (87 AKI) (with a slight power
loss).
Super unleaded petrol, 95 octanes at
least
You should use super 95 octane petrol (91
AKI) at least.
If super is not available, if necessary, use nor-
mal 91 octane petrol (87 AKI). In this case only
use moderate engine speeds and a light
throttle. Refuel with super as soon as possi-
ble.
Unleaded super plus 98 octane petrol or
super 95 octane petrol at least
We recommend refuelling with super plus 98
octane petrol (93 AKI). If not available: super
95 octane petrol (91 AKI) (with a slight power
loss).
If super is not available, if necessary, use nor-
mal 91 octane petrol (87 AKI). In this case only
use moderate engine speeds and a light
throttle. Refuel with super as soon as possi-
ble. CAUTION

Practical tips
CAUTION
Follow the instructions given on the tempo-
rary spar e wheel l
abel.Note
The tyre pressure of the spare wheel must
alw ays corr

espond to the highest pressure
prescribed for the model of vehicle in ques-
tion. Tyre monitoring system
Contr ol l
amp 
It lights up
The tyre pressure of a wheel is much lower than the
value set by the driv er

Maintenance
Decoration slides Problem Solution
Dirt Soft sponge with neutral soap
solutiona) a)
Neutral soap solution: two tablespoons maximum in
1 litre of w at
er
Interior cleaning Windows
Problem Solution
Dirt Apply windscreen cleaner and
then dry with a clothCovers / Trims
Problem Solution
Dirt Neutral soap solutiona)a)
Neutral soap solution: two tablespoons maximum in
1 litr e of w
at

er
Plastic parts Problem Solution
Dirt Damp cloth
Encrusted dirt Neutral soap solution a)
, if pos-
sible solv
ent-free plastic clean-
er a)
Neutral soap solution: two tablespoons maximum in
1 litr e of w
at

er Displays/instrument panel Problem Solution
Dirt Soft cloth with a liquid crystal
display cleaner Control panels
Problem Solution
Dirt Soft brush, then soft cloth with
neutral soap solutiona) a)
Neutral soap solution: two tablespoons maximum in
1 litre of w at

er
Seat belts Problem Solution
Dirt Neutral soap solutiona)
, al-
l o

wed to dry before retracting a)
Neutral soap solution: two tablespoons maximum in
1 litr e of w
at

er
Fabrics, artificial, Alcantara leather Problem Solution
Dirt particles ad-
hered t o the sur

-
face Vacuum cleaner
Water-based dirt,
e.g. coff ee

, tea,
blood etc. Absorbent cloth and neutral
soap solution
a) Problem Solution
Grease-based
dirt, e.g. oil , mak

e-
up, etc. Apply a neutral soap solution
a)
.
Absorb the dissolved gr ease
and paint particles drying with
an absorbent cloth, in case you
must treat it with water after-
wards
Special dirt, e.g.
pens, nail polish,
dispersion paint,
shoe cream et c.Special st

ain remove: dry with
an absorbent cloth, if applica-
ble
, apply neutral soap solution
afterwards a) a)
Neutral soap solution: two tablespoons maximum in
1 litr e of w
at

er
Natural leather Problem Solution
Recent dirt Cotton cloth with neutral soap solutiona)
Water-based dirt,
e.g. coffee
, tea,
blood etc. Recent stains: absorbent cloth
Dry stains: leather cl
eaner
Grease-based
dirt, e.g. oil , mak

e-
up, etc. Recent stains: absorbent cloth
and leather cleaner
Dry st
ains: grease dissolving
spray
Special dirt, e.g.
pens, nail polish,
dispersion paint,
shoe cream et c.St

ain remover suitable for
leather 268