AUX SKODA OCTAVIA 1997 1.G / (1U) 1.8 92kw Engine Workshop Manual

Downloaded from www.Manualslib.com manuals search engine Removing and Installing Engine10
Edition 11.96


The two rear jacking points are located at the rear of both side members at the level of the marking on the sill.
- Remove noise insulation panel -arrow-.
- Open cap of coolant expansion tank.
- Place drip tray (e.g. V.A.G 1306) below the
engine.
- Turn drain plug -arrow- at the radiator to the
left; fit auxiliary hose onto connection if ne-
cessary.

Downloaded from www.Manualslib.com manuals search engine
20Fuel Supply System




Edition 08.96

If the fuel pump does not run:
- Unbolt cover (below the rear seat).
- Release 4-pin connector form the flange at
the fuel tank and unplug.
- Connect hand-held multimeter (e.g. V.A.G
1526) with auxiliary cables (e.g. from V.A.G
1594) to the outer contacts of the connector.
- Operate remote control. Specification: about battery voltage
If the specification is not achieved:
- Determine open circuit in the wiring on the basis of the current flow diagram and rectify:
⇒ Current Flow Diagrams, Electrical Fault Finding and Fitting Locations binder
If the specification is achieved:
- Use MP 1-227 to unscrew union nut.
- Check whether the electric cables between flange and fuel pump are connected and test
for continuity.
If no open circuit in the wiring can be found:
Fuel pump faulty.
- Replace fuel delivery unit ⇒ page 20-5.
Testing delivery of the fuel pump
Special tools, testers and aids required♦ Adapter V.A.G 1318/17
♦ Measuring vessel
Test conditions
Battery voltage at least 12 V
Voltage supply o.k.
Fuel filter o.k.

Downloaded from www.Manualslib.com manuals search engine Fuel Supply System20
Edition 08.96



 
Test procedure
- Switch off ignition.
- Connect remote control V.A.G 1348/3A with
adapter cable V.A.G 1348/3-2 ⇒ page 20-8.
- Remove cap from the fuel filler neck.
Important! Fuel system is pressurised! Place cleaning ragsaround the connection point before opening the
system. Then, release pressure by carefullyloosening the connection point.
- Disconnect fuel return flow pipe -2- (press
release buttons).
- Connect auxiliary hose to adapter V.A.G 1318/17 and fit onto the fuel return flow pipe of the engine and hold in a measuring vessel.
- Operate remote control for 15 seconds (press button and hold).
- Compare quantity of fuel supplied with spe-
cification.
*)Minimum delivery cm3/15 s
**)Voltage at fuel pump when engine switched
off and pump running (about 2 V less than battery voltage).