spark plugs SKODA OCTAVIA 1997 1.G / (1U) 1.8 92kw Engine Workshop Manual

Downloaded from www.Manualslib.com manuals search engine Cylinder Head, Valve Gear15
Edition 08.96



 
Valve depressor MP 1-229
Thrust piece MP 1-229/1
Puller MP 1-230
Fitting tool MP 1-233
Spark plug wrench
Removing
- Remove camshafts page 15-16.
- Remove bucket tappets (do not mix up) and place down with the running surface facing down.
- Use spark plug wrench to remove spark plugs.
- Position piston of the relevant cylinder to „bottom dead centre“.
Exhaust side
- Insert assembly device MP 1-213 and set
bearing to height of stud bolt.
Note:
The rear stud bolts on the exhaust side shouldbe unscrewed in order to install the assembly
device MP 1-213 on the exhaust side.
- Screw pressure hose MP 1-210 into the spark plug thread and apply a constantpressure at least 0.6 MPa
- Use assembly lever and thrust piece MP 1-211 to remove valve springs.
Note:
If valve collets are tight, detach with light blowsfrom a hammer on the assembly lever.
- Use puller MP 1-230 to pull off valve stem
seals.