SKODA OCTAVIA 1999 1.G / (1U) 1.9TDi 66kw Engine Manual PDF
Page 71 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 72 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 73 of 140
Downloaded from www.Manualslib.com manuals search engine
Edition 08.96
Cylinder Head, Valve Gear15
Removing
- Remove camshaft page 15-16.
- Remove bucket tappets (do not mix up) and place down with running surface facing down.
- Move piston of the relevant cylinder into top dead centre (TDC).
- Insert assembly device MP 1-213 and set
mounting at height of stud bolt.
- Use assembly lever and thrust piece MP 1-211 to remove valve springs.
Note:
The valves are supported on the piston crownwhen carrying out this step.
- Use MP 1-206 to pull off valve stem seals. Installing
- Fit plastic sleeve -A- onto the valve stem in
order to avoid damaging the new valve stem seals.
- Oil valve stem seal -B-, insert into the fitting tool MP 1-306 and carefully push onto the valve guide.
Notes:
Wait about 30 minutes before starting the
engine after installing the camshaft. The
hydraulic compensating elements have tosettle (otherwise valves will strike the piston).
Page 74 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 75 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 76 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 77 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 78 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 79 of 140
Downloaded from www.Manualslib.com manuals search engine
Page 80 of 140
Downloaded from www.Manualslib.com manuals search engine