battery SKODA OCTAVIA 2008 2.G / (1Z) Columbus Navigation System Manual
Page 11 of 75
General information9
Input masks for digit entry– Press   to accept an indicated character sequence or press  , to 
delete the characters in the entry line from right to left.
– Press one of the   to   function ke ys in the input mask to accept the 
corresponding digit into the entry line.
– Press   when the correct number is indicated in the entry line. By  pressing   the input mask will be  closed without the entries being 
accepted.Special functions*Parking aid
If your vehicle is equipped wi th “parking aid” and after it is activated, the distance 
to the obstacle is shown on the screen.
Climatronic
If your vehicle is equipped with climatroni c, a feedback is received on the screen 
when changing the settings. Display of time
You can switch the display of the time on or off in the menu 
System set-ups.
Switching the system on and off– The system is switched on or off by turning / pressing the rotary / push 
knob .The last active audio source before  switching off will be repeated.
If the key is pulled out of the ignition lo ck with the unit switched on, the unit wil 
switch off automatically.
You can then switch the unit on again. When  the ignition is switched off, the unit 
switches off automatically after approx.  one hour (discharge protection of the 
vehicle battery). This process can be  repeated as often as necessary.Anti-theft protectionThe anti-theft coding of your navigation system prevents an operation of 
the system after a voltage interruption, e.g. during a vehicle repair or after 
theft. After disconnecting the batt ery, disconnecting the navigation 
system from the on-board voltage of the vehicle and after a fuse failure, 
the code must be entered before the vehicle can be used again.
Enter code
– If a keypad appears after switching on with the command to enter the  code, the unit can be unlocked by entering the correct four-digit code 
number. The number of the possible attempts is shown in the second 
touch-screen line.
– Press a digit from   to   on the digit block displayed on the touch- screen. The digit is accepted in the entry line.
Fig. 4  Input masks for digit 
entry
OK
0
9
OK
A1
0
9
s2u4.6.book  Page 9  Wednesday, August 13, 2008  7:57 AM