battery SMART FORTWO COUPE 2008 User Guide

Useful features
>> Controls.
165
The auxiliary power outlet is located in the
lower center console.1
Auxiliary power outlet
>Turn the key in the starter switch to
position1 (

page 91).
!
Please observe the safety instructions
given in the respective operating instruc

tions.Please note that:
• if using the auxiliary power outlet the max

imum current drawn does not exceed 5 A,
• the electric air pump can be connected to
the auxiliary power outlet for the time it
takes to inflate the tire without any prob

lem,
• the vehicle battery will discharge when
current is drawn.
Wheel trim cap*1
Wheel trim cap aperture
2
Valve> Mounting: Position wheel trim cap aperture
1 so the valve
2 fits through.
>Push the wheel trim cap evenly onto the
wheel rim with both hands.
>Check that the wheel trim cap is fixed se

curely to the wheel rim.
>Removing: Carefully remove the wheel trim
cap from the wheel rim with both hands. P68.00
4797
31

Tires and wheels
>> Operation
205
DOT (D
epartment o
f T
ransportation)
A tire branding symbol which denotes the tire
meets requirements of the U.S. Department of
Transportation
GAWR (G
ross A
xle W
eight R
ating)
The GAWR is the maximum permissible axle
weight. The gross vehicle weight on each axle
must never exceed the GAWR for the front and
rear axle indicated on the certification label
located on the driver’s door B
pillar.
GVW (G
ross V
ehicle W
eight)
The GVW comprises the weight of the vehicle
including fuel, tools, installed accessories,
passengers and cargo. The GVW must never
exceed the GVWR indicated on the certifi

cation label located on the driver’s door
B
pillar.GVWR (G
ross V
ehicle W
eight R
ating)
This is the maximum permissible vehicle
weight of the fully loaded vehicle (weight of
the vehicle including all options, passengers,
fuel, and cargo. It is indicated on certification
label located on the driver’s door B
pillar.
Kilopascal (kPa)
The metric unit for air pressure. There are
6.9 kPa to 1 psi; another metric unit for air
pressure is bars. There are 100 kilopascals
(kPa) to 1 bar.
Maximum load rating
The maximum load in kilograms and pounds
that can be carried by the tire.
Maximum loaded vehicle weight
The sum of curb weight, accessory weight,
total load limit and production options weight.Maximum permissible tire inflation pressure
This number is the greatest amount of air
pressure that should ever be put in the tire.
Normal occupant weight
The number of occupants the vehicle is
designed to seat, multiplied by 68 kilograms
(150 lbs).
Occupant distribution
The distribution of occupants in a vehicle at
their designated seating positions.
Production options weight
The combined weight of those installed regu

lar production options weighing over 5 lbs
(2.3 kilograms) in excess of those standard
items which they replace, not previously con

sidered in curb weight or accessory weight,
including heavy duty brakes, ride levelers,
roof rack, heavy duty battery, and special
trim.

Winter driving
208
>> Operation Before the onset of winter, have your vehicle
winterized at an authorized smart center. This
service includes:
>Check of anticorrosion and antifreeze
concentration.
• Addition of washer concentrate to the water
of the windshield/rear window.
Use a windshield washer concentrate la

beled for winter which is formulated for
temperatures below freezing point
(
page 308).
• Battery test. Battery capacity drops with
decreasing ambient temperature. A well
charged battery helps to make sure that the
engine can be started, even at low ambient
temperatures.
• Tire change.
Winter tiresAlways use winter tires at temperatures
below 45°F (7°C) and whenever wintry road
conditions prevail. Not all M+S rated tires
provide special winter performance. Make
sure the tires you use show the mountain/
snowflake marking.on the tire sidewall.
These tires meet specific snow traction
performance requirements of the Rubber
Manufacturers Association (RMA) and the
Rubber Association of Canada (RAC) and have
been designed specifically for use in snow
conditions. Use of winter tires is the only way
to achieve the maximum effectiveness of the
ABS and ESP
® in winter operation.
For safe handling, make sure that all mounted
winter tires are of the same make and have the
same tread design.Always observe the speed rating of the winter
tires installed on your vehicle. If the maximum
speed for which your tires are rated is below
the speed rating of your vehicle, you must
place a notice to this effect where it will be
seen by the driver. Such notices are available
at your tire dealer or any authorized smart
center.
G
Warning!
Winter tires with a tread depth of less
than
1/6 in (4 mm) must be replaced. They
are no longer suitable for winter opera

tion.

>> Practical hints.Where will I find ...? . . . . . . . . . . . . . . . . . . . . . . . . . . 234
Display messages . . . . . . . . . . . . . . . . . . . . . . . . . . . 236
What to do if ... . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 237
Unlocking/locking manually . . . . . . . . . . . . . . . . . . . 250
Replacing transmitter battery . . . . . . . . . . . . . . . . . 252
Replacing bulbs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 254
Replacing wiper blades . . . . . . . . . . . . . . . . . . . . . . . 262
Flat tire . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 265
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 271
Jump starting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 276
Towing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 278
Fuses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282

What to do if ...
238
>> Practical hints. Battery indicator lamp
Illuminates:
• when the ignition is switched on.
The indicator lamp goes out if the engine is
running.
If the Battery indicator lamp illuminates while
driving or does not go out after the engine is
started, the battery is no longer charged.
Possible causes:
• Alternator malfunctioning
• Broken poly
V
belt>Stop the vehicle immediately in a safe
location.
>Do not continue to drive.
>Turn off the engine.
>Set the parking brake when leaving the
vehicle.
>Contact Roadside Assistance or an autho

rized smart center.
!
Among other possible causes, the
poly
V
belt could be broken. Do not continue
to drive. Otherwise, the engine will overheat
due to an inoperative water pump which may
result in damage to the engine.Brake warning lamp (USA only)
Brake warning lamp (Canada only)
Illuminates:
• when the ignition is switched on.
Goes out:
• at least after 10 seconds
or
• after starting the engine.

What to do if ...
248
>> Practical hints. Flashes at double frequency:
• if one of the turn signals is malfunctioning.
>Replace the bulb as soon as possible
(
page 254).
or
>Have the turn signal checked at an autho

rized smart center as soon as possible.
EngineThe engine does not start:
>Check if
• the gear selector lever is in park
positionP,
• the brake pedal has been depressed,
• the transmission position indicator is on

or
.
The engine does not start within 4 seconds:
>Wait for a few seconds.
>Repeat the starting procedure.
Remember that extended starting attempts
can drain the vehicle battery.
The engine does not start after several
starting attempts:
>Set the parking brake when leaving the
vehicle.
>Contact Roadside Assistance or an autho

rized smart center.
Loss of keyIf you lose a key, you should do the following:
>Have the key deactivated at an authorized
smart center.
>Report the loss of the key to your car
insurance company immediately.
>If necessary have the mechanical lock
replaced.
Your authorized smart center will be glad to
supply you with a replacement following an
identity check.

Unlocking/locking manually
250
>> Practical hints.
Unlocking the vehicleYou can unlock the driver’s door and the fuel
filler flap by unlocking the driver’s door using
the key. The lock cylinder is fitted with a cap.
>Press button
©
on the key.
The anti
theft warning system* is disarmed.
i
If the transmitter battery in the key is
discharged, the anti
theft warning system*
can no longer be disarmed with button
©
on
the key. For replacing the transmitter battery
(

page 253).
Unlocking the vehicle with the key and opening
a door or the tailgate will trigger the anti

theft warning system* (

page 77).
To cancel the alarm:
>Insert the key in the starter switch.
>Turn starter switch in Position 1
(

page 91).
1
Cap
2
Lock cylinder
>Remove cap
1 from lock cylinder
2.
>Unlock the driver’s door.
The driver’s door and the fuel filler flap are
unlocked.
i
To unlock the vehicle centrally press the
central unlocking switch in the upper center
console (

page 38).
Locking the vehicleIf you can no longer lock the vehicle using the
remote control and you do not have a spare
transmitter battery at hand, please proceed
as follows:
>Open the driver's door.
>Press the central locking switch
(

page 84).
The indicator lamp on central locking
switch
1 comes on, when the starter switch
is in position 1.
The indicator lamp on central locking
switch1 flashes, when the starter switch is
in Position 0.
>Remove the key from the starter switch,
take it with you, and close all doors.
The vehicle is now locked and the anti
theft
warning system* is armed. P72.10
3348
31

Replacing transmitter battery
252
>> Practical hints.
NotesThe remote control's transmitter battery is
almost spent when the turn signals flash
rapidly nine times in a row when locking the
vehicle.i
If you do not replace the transmitter
battery, after about 100 more times you will no
longer be able to lock or unlock the vehicle
using the remote control.>Replace the transmitter battery.
or
>Have the transmitter battery replaced at an
smart center.
Batteries contain materials that can harm the
environment if disposed of improperly.
Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries for
recycling.
G
Warning!
Batteries contain poisonous and corro

sive substances. Therefore keep the
batteries out of reach of children.
If a battery is swallowed, seek medical
help immediately.

Replacing transmitter battery
>> Practical hints.
253 Replacing transmitter battery
Replacement battery: CR 2016 button cell!
Replace the remote control's transmitter
battery every two years at the latest. Other

wise there is a danger of leakage. The remote
control could be damaged.
1
Key housing top half>Insert a suitable object such as a coin into
the slot at the eyelet of the key housing.
>Carefully turn the coin until key housing top
half
1 is unlatched.
>Open key housing top half
1 to the side.
2
Transmitter battery
>Remove transmitter battery
2 from the
board.
!
Check the polarity when inserting the new
transmitter battery. You could otherwise
damage parts of the electrical system. When
inserting the batteries, make sure they are
clean and free of lint.
>Insert the new transmitter battery.
>Press both halves of the key housing
together again.
>Check the operation of the remote control.
P80.35
2289
31

Flat tire
268
>> Practical hints. >Unscrew the valve cap from the tire valve of
the damaged tire.
>Pull off the stopper of filler hose
4.
>Screw the end of filler hose
4
onto the tire
valve.
>Insert electrical plug
6
into the auxiliary
power outlet (

page 164).
>Insert the key in the starter switch and turn
it to position1.
i
The vehicle's battery is drained by use of
the electric air pump. You should therefore
keep the engine running
in the open air

while inflating the tire.
>PressI on electric air pump switch
7.
The electric air pump is switched on and
inflates the tire.
i
First, the sealant is pumped into the tire.
The pressure may briefly increase to a high
value. This is normal and not an indication of a
malfunction. Do not switch off the electric air
pump.>Let the electric air pump inflate the tire for
a maximum of ten minutes.
Pressure gauge
2 must display at least
26 psi (1.8 bar) is reached. The filler hose
can become hot during inflation.
Please exercise appropriate caution.
!
Do not operate the electric air pump
longer than ten minutes without interruption.
Otherwise it may overheat.
You may operate the electrical air pump again
after it has cooled off.
>If the tire inflation pressure of at least
26 psi (1.8 bar) is not attained, turn off the
electric air pump by pressing0 on electric
air pump switch
7.
>Unscrew the end of filler hose
4
from the
tire valve.
>After clearing the area around the vehicle
of people and obstacles, drive vehicle back
or forth very slowly approximately 30 ft
(10 m).
This serves to better distribute the tire
sealant material inside the tire.>Screw the end of filler hose
4 onto the tire
valve.
>Inflate the tire again.
>After attaining a tire inflation pressure of
26 psi (1.8 bar), press0 on electric air
pump switch
7.
The electric air pump is switched off.
>Turn the key in the starter switch to
position0.
G
Warning!
If a tire inflation pressure of 26 psi
(1.8 bar) is not attained, the tire is too
severely damaged for the tire sealant to
provide a reliable tire repair.
In this case, the tire sealant cannot
properly seal the tire.
Do not drive the vehicle.
Contact the nearest smart center for as

sistance or call Roadside Assistance.