tailgate SMART FORTWO COUPE 2008 Owner's Manual
Page 174 of 314
Engine compartment
>> Operation
173
Checking engine oil level!
Check the engine oil level at regular
intervals.
When checking the engine oil level
• the vehicle must be parked on level ground
• the vehicle must have been stationary for at
least five minutes with the engine turned off
>Turn off the engine.
>Set the parking brake.
>Open the tailgate.
>Open the engine compartment cover
(page 172).The oil dipstick is located in the engine
compartment on the passenger side.
1
Oil dipstick
2
Upper mark
3
Lower mark>Pull out oil dipstick
1.
>Wipe oil dipstick
1 clean with a clean cloth.
>Fully insert oil dipstick
1 into the dipstick
guide tube.
>Pull out oil dipstick
1 again after approxi
mately one minute to obtain accurate read
ing.
The oil level is correct when it is between
lower mark
3 (minimum) and upper mark
2
(maximum) on both sides of oil dipstick
1.
>Fully insert oil dipstick
1 into the dipstick
guide tube again.
>If necessary, add engine oil.
i
The filling quantity between the upper and
lower marks on the oil dipstick is approxi
mately 1.1 US qt (1.0 l). P01.00285131
Page 250 of 314
What to do if ...
>> Practical hints.
249 Acoustic warning signals
Door warning
A warning signal sounds if the door is opened
while a gear is engaged with the engine run
ning and neither the brake nor accelerator
pedals are depressed.
In addition a warning signal sounds if you
open the driver’s door with the key in the
starter switch position 0 to remind you not to
leave the key in the vehicle.Antitheft warning system*
Once the antitheft warning system has been
armed, a visual and audible alarm is triggered
when someone opens
• a door or the tailgate,
• when the vehicle's interior is entered,
• if there is motion inside the vehicle,
• if the vehicle is raised.
The alarm is also triggered if the passenger
door is unlocked with the key (
page 250).
To cancel the alarm:
>Insert the key in the starter switch.
>Turn starter switch in Position 1
(
page 91).
or
>Press button
©
or
ª
on the key.Seat belt reminder system
If seat belts are not fastened when the engine
is started, a warning chime will sound, for de
tails see seat belt telltale (
page 245).
Mechanical/acoustic brake pad indicator
The vehicle is equipped with a mechanical/
acoustic brake pad indicator. If you can hear
a continuous noise from the front axle when
braking, have the brake pads checked at an
authorized smart center.
Page 251 of 314
Unlocking/locking manually
250
>> Practical hints.
Unlocking the vehicleYou can unlock the driver’s door and the fuel
filler flap by unlocking the driver’s door using
the key. The lock cylinder is fitted with a cap.
>Press button
©
on the key.
The antitheft warning system* is disarmed.
i
If the transmitter battery in the key is
discharged, the antitheft warning system*
can no longer be disarmed with button
©
on
the key. For replacing the transmitter battery
(
page 253).
Unlocking the vehicle with the key and opening
a door or the tailgate will trigger the anti
theft warning system* (
page 77).
To cancel the alarm:
>Insert the key in the starter switch.
>Turn starter switch in Position 1
(
page 91).
1
Cap
2
Lock cylinder
>Remove cap
1 from lock cylinder
2.
>Unlock the driver’s door.
The driver’s door and the fuel filler flap are
unlocked.
i
To unlock the vehicle centrally press the
central unlocking switch in the upper center
console (
page 38).
Locking the vehicleIf you can no longer lock the vehicle using the
remote control and you do not have a spare
transmitter battery at hand, please proceed
as follows:
>Open the driver's door.
>Press the central locking switch
(
page 84).
The indicator lamp on central locking
switch
1 comes on, when the starter switch
is in position 1.
The indicator lamp on central locking
switch1 flashes, when the starter switch is
in Position 0.
>Remove the key from the starter switch,
take it with you, and close all doors.
The vehicle is now locked and the antitheft
warning system* is armed. P72.10334831
Page 259 of 314
Replacing bulbs
258
>> Practical hints. Side turn signal lamp bulb
>Removing: Open the door on the corre
sponding side.
1
Retaining lug
>Press on retaining lug
1 in the direction of
the arrow until the side turn signal lamp
housing disengages.
>Use a suitable tool to loosen the side turn
signal lamp housing from the fender.
>Turn the bulb socket counterclockwise and
pull it out out of the side turn signal lamp
housing.
>Pull the bulb out of the bulb socket.>Installing: Insert the new bulb into the bulb
socket.
>Insert the bulb socket into the side turn
signal lamp housing and turn the bulb
socket clockwise.
>Fit the side turn signal lamp housing onto
the fender.
>Press gently onto the side turn signal lamp
housing.
The side turn signal lamp housing must
audibly engage.
Replacing bulbs for rear lampsBefore you start to replace a bulb for a rear
lamp, do the following first:
>Turn exterior lamp switch to positionM
(
page 101).
>Switch off the ignition.
Tail lamp unit
>Removing:
Coupé:
>Open the upper tailgate.
>Open the lower tailgate.
Cabrio:
>Open the lower tailgate
>Open the rear soft top (
page 89)
>Remove the side cover in the cargo
compartment on the corresponding side.
>Fold the damping material forward, if
necessary.
P82.10455631