diagram SSANGYONG KORANDO 2012 Service Manual
Page 161 of 1082
03-26
2) Fuel System Flow Diagram
The fuel from the fuel tank is supplied to the fuel heater of fuel filter/priming pump and then low pressure
generated by the low pressure pump (built into HP pump) is transmitted to the HP pump.
The fuel pressure at the HP pump is controlled by the IMV valve, and the maximum allowed pressure is
1,800 bar. The compressed fuel at the fuel pump is delivered to the rail, and injected by the injectors
according to the injection signals. The injection method is the same with the conventional method; Fuel
return by backleak which operates the needle valve.
The major difference is that the fuel return line is connected to the fuel filter inlet port, not the HP pump
venturi.
The pressure from the high pressure pump is increased to 1,800 bar from 1,600 bar, and the pump is now
installed to the cylinder head (cylinder block for previous model). The fuel pressure is generated by the
operation of intake camshaft and gears. The specifications for the IMV valve and the fuel temperature
sensor are not changed.
Page 164 of 1082
03-290000-00
4) Flow Diagram of Fuel Supply System
Page 165 of 1082
03-30
5) Circuit Diagram
Page 175 of 1082
04-12
5. CIRCUIT DIAGRAM
Page 226 of 1082
09-14
3. CIRCUIT DIAGRAM
Page 230 of 1082
10-6
2. SYSTEM OPERATION
1) Input/Output Diagram of Glow Plug Control Unit
2) System Diagram
Page 232 of 1082
10-8
3) Circuit Diagram
Page 246 of 1082
11-10
2) Circuit Diagram
(1) With SMART key system
Page 252 of 1082
12-58530-00
2. CONFIGURATION
1) Circuit Diagram
The engine ECU detects the operating conditions of cruise control system, and monitors the braking
performance, vehicle speed, road conditions and ESP system operation. If the engine ECU determines
that there are not any problem to drive in cruise control mode, the vehicle can be operated by cruise
switch signals (decelerating, accelerating, cruising).
Page 264 of 1082
13-6
2. OPERATING PROCESS
1) Schematic Diagram