air filter SSANGYONG MUSSO 1998 Workshop User Guide

1F3-2 OM600 ENGINE CONTROLS
FUEL SYSTEM
1 Fuel Injection Pump
2 Fuel Feed Pump
3 Overflow Valve
4 Injection Nozzle
5 Pre-filter6 Fuel Return Hose
7 Injection Line
8 Fuel Tank
9 Fuel Filter
10 Choke Orifice
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE

1F3-8 OM600 ENGINE CONTROLS
Detach line downstream of air admission filter (13).
Vacuum drops.
Faulty thermovalve
Fit the line onto air admission filter. Built up vacuum with
vacuum pump. Detach the plug from air admission line.
Vacuum drops.
Faulty filter with restriction.
Go to test step 2. YES
NO YES NO

1F3-28 OM600 ENGINE CONTROLS
Tools Required
001 589 65 09 00 Socket Wrench Insert
000 589 00 68 00 Cleaning Set
Repair Procedure
1. Clamp the nozzle holder (1) in a vice and remove the nozzle
tensioning nut (8).
Notice
Use protective jaws for clamping.
2. Disassemble the fuel injection nozzle.
Socket Wrench Insert 001 589 65 09 00
3. Clean the nozzle needle (6) and nozzle body (7) with an
abradant.
4. Clean the nozzle seat with cleaning cutter.
Cleaning Set 000 589 00 68 00
5. Immerse nozzle needle (6) and nozzle body (7) in filtered
diesel fuel. When the nozzle body is held vertical, the weight
of the nozzle needle must cause it to slide down toward the
nozzle needle seat.
6. Assemble the injection nozzle so that the tip of the thrust
(4) pin is facing toward the nozzle holder.
Tightening Torque 80 Nm
Notice
Nozzle needle (6) and nozzle body (7) should always be
replaced as a pair.

5A-122 AUTOMATIC TRANSMISSION
15. Install solenoid 6 plunger, spring and retaining pin.
16. Position the third feed ball (large nylon) in the valve body
and install the solenoid 5 filter and the solenoid 6 filter.
Refer to figures 8.5 and 8.56.
17. Check the separator plate for burrs and damage. Repair
or replace the separator plate as necessary.
18. Check the upper and lower valve body gaskets for
damage. Replace the gaskets as necessary.
19. Install the lower valve body gasket on the lower valve body.
20. Install the reverse lockout valve, spring, plug and retainer
plate. Ensure that the valve is correctly oriented. Refer to
figure 8.57.
Figure 8.57 - Reverse Lockout Valve
21. Position the five nylon ball checks in the upper valve body.
Refer to figure 8.48.
22. Fit the upper valve body gasket. Install the separator plate
over the upper valve body.