remote start SUBARU FORESTER 2000 SF / 1.G Owners Manual

Doors and locks1-9
–
CONTINUED –

System operation
Keyless entry func tions d o not op erate when vehic le ig nition is “ON ”.
HS1000BB
n Locking the doors
Press the “LOCK ” b utton to loc k all d oors and the rear g ate. The p a rk-
ing lig hts will flash one time. n Unlocking the doors
To unloc k the d river ’s d oor only, p ress and release the “UNLOCK ” b ut-
ton.
To unloc k all d oors and the rear g ate, p ress and ho ld the “UNLOCK ”
b utton.
The p arking lig hts will flash one time.
The vehic le ’s interior (c ourtesy) lig ht will illuminate for 60 sec ond s or
until vehic le is started . NOTE
1. Parking lights will flash when the vehicle ’s battery is discon-
nected and reconnected.
To stop lights from flashing, either: Press remote transmitter “UNLOCK” button once.
Turn the ignition switch to the “ON” position and press pro-
gramming button for one second (see location below).
2. The vehicle interior (courtesy) light and door open warninglight (DOOR AJAR indicator) will illuminate for 60 seconds when
the ignition is turned off, or until the doors are locked with the

1-12
HS1003BB
HS1002BA
1. Remove the p hillip s sc rew on the b ac k of the remo te transmitter
c ase. Use a small c oin to sep arate the c ase halves and exp ose the
b attery.
2. Remove the old b attery and rep lac e with typ e GP-2 3A or eq uiva-
lent.
3. Close the transmitter c ase and rep lac e the sc rew.
Security system (if equipped) How the security system protects your vehicle
n Starter interrupt
The vehic le ’s starter is d isab led when the system is armed with your
remote transmitter. n Passive starter interrupt (if selected)
The vehic le starter is automatic ally d isab led one m inute after the ig ni-
tion is turned off, even if the system has not been armed with your
remote transmitter . (This op tion may b e ac tivated b y your SUBARU
d ealer for an ad d itional c harg e.) NOTE
If the Passive Starter Interrupt Option is enabled on your system, pay special attention to the “Starter interrupt ” section.

Doors and locks1-13
–
CONTINUED –
n
All entrances protected
Op ening any d oor or entranc e p rotec ted b y the sec ur ity system trig -
g ers the alarm ’s 125 d b siren and flashes the vehic le ’s p arking lig hts.
n Shock Sensor
The shoc k sensor d etec ts any imp ac t to the vehic le. Lig ht imp ac t will
c ause the siren to emit a warning “c hirp ”; heavier b lows will trig g er
the alarm. (Shoc k sensor sensitivity has b een p rese t, b ut may b e
ad justed b y your SUBARU d ealer.) n Personal protection (Panic) feature
Pressing b oth b uttons on the remote transmitter ac t ivates the Panic
feature, sound ing the siren and flashing the vehic l e’s p arking lig hts.
n Interior status indicator
The b rig ht-red warning lig ht p rovid es a visual d ete rrent to a would -b e
thief.n Emergency override button
Ensures that you will b e ab le to d isarm your alarm system and start
your vehic le if your remote transmitter is lost or b roken. See “The
emerg enc y overrid e/p rog ramming b utton ” Sec tion.
Security system components
n The remote Transmitter
The remote transmitter c ontrols the features and op tions of the sec u-
rity system.
HS1000CB

1-20
The siren will emit a numb er of c hirp s. Refer to th e c hart (b elow) to
id entify the violated zone.

Chirps
Triggered Zone


1



Shock Sensor

2
Ignition turned on

4
Door or Rear gate
n
Starter interrupt
Starter interrup t is an automatic p roc ed ure. The st arter is d isab led
any time the system is armed , or if the Passive starter interrup t fea-
ture is enab led and the p assive arm time is exp ired . The vehic le also
will not start if p ower is d isc onnec ted from the al arm mod ule.
How starter interrupt works
The alarm system interrup ts the sig nal from the ig n ition key to the
vehic le ’s starter when Starter interrup t is ac tivated . If y ou attemp t to
start the vehic le, the d ash ind ic ator will turn on as usual, b ut the
starter will not “c rank ”, or turn over.
Passive starter interrupt
If the Passive Starter Interrup t op tion has b een ac tivated b y you r
SUBARU d ealer, the starter will b e automatic ally d i sab led one minute
after you turn off the vehic le ig nition, whether or not you arm the sec u-
rity system with your remote transmitter.
Possible situations with starter interrupt or Passive starter inter-
rupt
Passive Starter Interrupt
If you leave the vehic le for a short amount of time , to refuel or g o to
the c ar wash for examp le, always eng ag e the Valet M od e b efore exit-
ing your vehic le. If you forg et to eng ag e Valet Mod e, the Passive
Starter Interrup t will eng ag e and the vehic le will not start when you
return. To enable the vehicle to start, simply press “UNLOCK” on

Doors and locks1-21
–
CONTINUED –
your remote transmitter, or turn the vehicle ignition to the
“ON”
position and press the Emergency Override/programming button in and release .
If your remote transmitter is lost or b roken and th e Passive Starter
Interrup t has automatic ally eng ag ed , enter the vehi c le, turn the ig ni-
tion to the “ON ” p osition, and p ress the Emerg enc y Overrid e/p ro-
g ramming b utton. This will enab le the vehic le to st art.
In the unlikely event of an alarm system malfunc tio n, your vehic le
may not start. To enab le the vehic le to start, press and hold the
Emergency Override/programming button, and attempt to startthe vehicle while holding the button in .
System maintenance
Your sec urity system d oes not req uire any sp ec ific maintenanc e
exc ep t for oc c asionally c hang ing the transmitter b a ttery. However, it is
sug g ested that the system b e armed and all p rotec te d zones b e
c hec ked ab out onc e a month to make sure that they t rig g er an alarm
c yc le.
To c hang e the remote transmitter b attery, refer to “System mainte-
nanc e ” sec tion und er the head ing of “Keyless entry system ”.
Trouble shooting guide
n If you experience any of the following situations...
Your remote transmitter is lost or broken and your alarm sys-
tem is armed. You attempt to start your vehicle after pressing “UNLOCK” on
your remote transmitter and it does not “crank”.
Perform the following procedure:
1. Use your keys to enter the vehicle. (Depending on your situa-
tion, the alarm may sound when you open the door.)
2. Insert your key into the ignition and turn to the “ON” position.
3. Press and release the Emergency Override Button. The alarm
system will disarm and you will be able to start your vehicle.
4. If your vehicle still will not start, press and HOLD the Emer-gency Override Button in while attempting to start your vehicle.