SUBARU FORESTER 2003 SG / 2.G Owners Manual

11 - 6 0
Maintenance and service
5. Pull the headlight assembly slightly toward you,
then hold down the lock release tabs on the connec-
tors for the front turn signal light, parking light, and
front side marker light and pull out the headlight as-
sembly completely.
6. Remove the bulb socket from the headlight assem-
bly by turning it counterclockwise.
HSB079BAHSB073CA

11 -6 1
Maintenance and service
–CONTINUED –
7. Pull the bulb out of the socket. Install a new bulb.
8. Set the bulb socket into the headlight assembly and
turn it clockwise until it locks.
9. Reinstall all the removed parts by following the re-
moval sequence in reverse. Front fog light
It may be difficult to replace the bulbs. Have your
SUBARU dealer replace the bulbs if necessary. Rear combination lights
1. Remove the upper and lower screws. Then, slide
the rear combination lamp assembly to the rear and remove it from the vehicle.
HSB080BA
HSB085BA

11 - 6 2
Maintenance and service
1) Tail/stop light
2) Rear turn signal light
3) Backup light
4) Tail/stop light
2. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
3. Pull the bulb from the holder. Install a new bulb.
4. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
5. Reinstall the rear combination light assembly.
License plate light
0
1. Remove the mounting screws using a phillipsscrewdriver.
2. Remove the cover and lens.
3. Pull the bulb out of the socket. Install a new bulb.
4. Reinstall the lens and cover.
5. Tighten the mounting screws.
3
2
1
4
HSB086BB
HSB087BA

11 -6 3
Maintenance and service
–CONTINUED –
Dome light, map light and cargo area light
1. Remove the lens by prying the edge of the lens with
HSB088BA
HSB089BA
HSB090BA

11 - 6 4
Maintenance and service
a regular screwdriver.
2. Pull the bulb out of the socket. Install a new bulb.
3. Reinstall the lens.
High mount stop light
0
1. Remove the mounting screw covers by prying the
edge with a screwdriver.
2. Remove the mounting screws using a phillips
screwdriver and then remove the high mount stop lightcover.
3. Pull the bulb from the socket. Install a new bulb.
4. Reinstall the cover.
5. Tighten the mounting screws then reinstall the cov- ers.
NOTE
Other bulbs may be difficult to replace. Have your
SUBARU dealer replace these bulbs if necessary.
HSB091BA

12-1
12
Specifications
Specifications ............................................... 12-2 Dimensions ..................................................... 12-2
Engine .............................................................. 12-3
Electrical system ............................................ 12-3
Capacities ........................................................ 12-4
Tires ................................................................. 12-4
Wheel alignment ............................................. 12-5
Fuses and circuits ....................................... 12-6 Fuse panel located behind the coin tray ...... 12-6
Fuse panel located in the engine compartment 12-8
Bulb chart ..................................................... 12-9
Vehicle identification ................................... 12-10

12-2
Specifications
Specifications
Specifications
These specifications are subject to change without notice.
Dimensions
in (mm)
*1: Measured with vehicle empty
Item2.5-liter
XXS
Drive systemAWD
Transmission typeAutomatic
transmissionManual
transmissionAutomatic
transmissionManual
transmission
Overall length175.2 (4450)
Overall width68.3 (1735)
Overall height62.6 (1590)
Wheel base99.4 (2525)
TreadFront58.9 (1495)
Rear58.5 (1485)
Ground clearance* 17.5 (190)

12-3
Specifications
– CONTINUED –
Engine
Electrical system
Engine modelEJ251 (2.5-liter, SOHC)
Engine typeHorizontally opposed, liquid cooled 4 cylinder, 4-stroke gasoline engine
Displacement cu in. (cc)150 (2,457)
Bore

12-4
Specifications
Capacities
Tires
Fuel tank15.9 US gal (60 liters, 13.2 Imp gal)
Engine oil4.2 US qt (4.0 liters, 3.5 Imp qt)
Transmission oilManual transmission3.7 US qt (3.5 liters, 3.1 Imp qt)
Automatic transmission9.8 US qt (9.3 liters, 8.2 Imp qt)
AT differential gear oil1.3 US qt (1.2 liter, 1.1 Imp qt)
Rear differential0.8 US qt (0.8 liter, 0.7 Imp qt)
Power steering gear fluid0.7 US qt (0.7 liter, 0.6 Imp qt)
Engine coolantManual transmission7.3 US qt (6.9 liters, 6.1 Imp qt)
Automatic transmission7.2 US qt (6.8 liters, 6.0 Imp qt)
Tire sizeP215/60R16 94H
Wheel size16 x 6 1
/2 JJ
PressureFrontLight load29 psi (200 kPa, 2.0 kg/cm 2
)
Full load29 psi (200 kPa, 2.0 kg/cm 2
)
RearLight load28 psi (190 kPa, 1.9 kg/cm 2
)
Full load36 psi (250 kPa, 2.5 kg/cm 2
)
Trailer towing41 psi (280 kPa, 2.8 kg/cm 2
)

12-5
Specifications
– CONTINUED –
Wheel alignment
ItemXXS
Drive systemAWD
ToeFront0±0.12 in (0 ±3 mm)
Rear0.08 ±0.12 in (2 ±3 mm)
CamberFront–0 °25’ ±45’
Rear–0 °50’ ±45’