reset SUBARU FORESTER 2007 SG / 2.G Owners Manual

16 „Combination meter
T U.S.-spec. models
V AT vehicles
XT
000248
123 4 5
86 7
1) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip
meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)
8) Select lever position indicator (page
3-15)

17
–
CONTINUED –
X, XS, L.L.Bean
123 4
5
7
86
000227
1) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip
meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)
8) Select lever position indicator (page
3-15)

18 VMT vehicles
XT
123 4 5
76
000126 1) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip
meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)

19
–
CONTINUED –
X, XS, L.L.Bean
123 4
76 5
000228
1) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)

20 TCanada-spec. models
V AT vehicles
XT
000247
123 4 5
86 7
1) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip
meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)
8) Select lever position indicator (page
3-15)

21
–
CONTINUED –
X, XS, L.L.Bean
123 4
7
86 5
0001291) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip
meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)
8) Select lever position indicator (page
3-15)

22 VMT vehicles
XT
123 4 765
0001301) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip
meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)

23
–
CONTINUED –
X, XS, L.L.Bean
1
76 5
23 4
000131 1) Fuel gauge (page 3-7)
2) Temperature gauge (page 3-8)
3) Speedometer (page 3-6)
4) Tachometer (page 3-7)
5) Trip meter A/B selection and trip
meter reset knob (page 3-6)
6) Odometer and trip meter (page 3-6)
7) Outside temperature indicator (page
3-8)

3-16 Instruments and controls
„Cruise control set indica-
tor light
The cruise control set indicator light
comes on when the ignition switch is
turned to the “ON” position and goes out
after approximately three seconds.
This light comes on when vehicle speed
has been set.Clock
To adjust the clock, open the small article
storage compartment in the dashboard
with the vehicle parked in a safe place. To set the hour, press the “H” button. To
set the minutes, press the “M” button. To
reset the minutes to “00” with a radio time
signal, push the “Reset” button.
NOTE
The clock uses a liquid-crystal display.
You will find time indications hard to
see if you wear polarized glasses.
300578
HMRESET
300579 To ensure safety, do not attempt to
set the time while driving, as an ac-
cident from inadequate attention to
the road could result.

Instruments and controls 3-27
– CONTINUED –
V
Compass zone adjustment
Compass calibration zones
1. The zone setting is factory preset to
Zone 8. Refer to the “Compass calibration
zone” map shown above or one attached
to the end of this manual to verify that the
compass zone setting is correct for your
geographical location.
2. Press and hold the right button for 3
seconds then release, and the word
“ZONE” will briefly appear and then the
zone number will be displayed.
3. Press the right-hand button repeatedly
to cycle the display through all possible
zone settings. Stop cycling when the cor-
rect zone setting for your location is dis-
played.
4. Releasing the button for 3 seconds will exit the zone setting mode.
„ Outside mirrors
T Convex mirror (passenger side)
T Remote control mirror switch
1) Selection switch
2) Direction control switch
The remote control mirrors operate only
when the ignition switch is in the “ON” or
“ACC” position.
1. Press either end of the selection
switch, “L” for the left, “R” for the right.
2. Move the direction control switch in the
direction you want to move the mirror.
3. Return the selection switch to the neu-
tral position to prevent unintentional oper-
ation.
The mirrors can also be adjusted manual-
ly.
10
9
8
7
6
5
4
3
1112
13
300580
Objects look smaller in a convex
mirror and farther away than when
viewed in a flat mirror. Do not use
the convex mirror to judge the dis-
tance of vehicles behind you when
changing lanes. Use the inside mir-
ror (or glance backwards) to deter-
mine the actual size and distance of
objects that you view in convex mir- ror.
300146
1
2
300581