change time SUBARU FORESTER 2016 SJ / 4.G Navigation Manual

ROUTE GUIDANCE
216 If a recommended route is already available, and a new
destination has been selected using the method described
in the previous section, the start new route, add a new
waypoint (midway point), and add the destination you
<00560048004f0048004600570048004700030044005600030057004b0048000300bf00510044004f00030047004800560057004c005100440057004c0052005100030045005800570057005200510056000300440055004800030047004c00560053004f00
44005c004800470011>
No. Function
Select to create a new route at the position you
selected. Previous destinations and waypoints are
deleted.
Select to add the position you selected as a new
waypoint for the current route. Other destinations for
the route are already enabled. Note: Waypoints are
set so that the optimum route is maintained between
destinations. You can use the route editing function to
set the position for waypoints on the route.
No. Function
<00360048004f004800460057000300570052000300440047004700030057004b004800030047004800560057004c005100440057004c005200510003005c00520058000300560048004f0048004600570048004700030044005600030057004b0048000300
bf00510044004f0003>
destination for the current route. Other destinations for
the route are already enabled. Up to now, the position
PDUNHGDVWKH¿QDOGHVWLQDWLRQEHFRPHVWKH¿QDO
waypoint.
SETTING A NEW STARTING POINT
In standard navigation, all routes are created from the
current position. You can turn off the GPS so that you
can study a route that is not currently being driven, run a
simulation, and check the time or distance for the route. This
way, you can set a start point for the route without using the
current GPS position.
1.Display the “Change Route (Change Route)” screen.

:3
2.SelectEdit Route (Edit Route) / Create Route
(Create Route).

”
Edit Route (Edit Route) is displayed only when
a route is set. Create Route (Create Route) is
displayed when a route is not set.

TIPS FOR THE NAVIGATION SYSTEM
230
CAUTION
OThe installation of window tinting may obstruct the GPS
signals. Most window tinting contains some metallic content
that will interfere with GPS signal reception of the antenna in
the instrument panel. We advise against the use of window
tinting on vehicles equipped with navigation systems.

”Accurate current position may not be shown in the
following cases:
‡When driving on a small angled Y-shaped road.
‡When driving on a winding road.
‡When driving on a slippery road such as in sand,
gravel, snow, etc.
‡When driving on a long straight road.
‡When freeway and surface streets run in parallel.
‡After moving by ferry or vehicle carrier.
‡When a long route is searched during high speed
driving.
‡After repeating a change of direction by going
forward and backward, or turning on a turntable in
a parking lot.
‡When leaving a covered parking lot or parking
garage.‡When a roof carrier is installed.
‡When driving with tire chains installed.
‡When the tires are worn.
‡After replacing a tire or tires.
‡When using tires that are smaller or larger than the
IDFWRU\VSHFL¿FDWLRQV
‡When the tire pressure in any of the 4 tires is not
correct.

”Inappropriate route guidance may occur in the
following cases:
‡When turning at an intersection off the designated
route guidance.
‡If you set more than 1 destination but skip any of
them, auto reroute will display a route returning to
the destination on the previous route.
‡When turning at an intersection for which there is
no route guidance.
‡When passing through an intersection for which
there is no route guidance.
‡During auto reroute, the route guidance may not be
available for the next turn to the right or left.
‡During high speed driving, it may take a long time
for auto reroute to operate. In auto reroute, a detour
route may be shown.

TIPS FOR THE NAVIGATION SYSTEM
231
NAVIGATION SYSTEM
8
‡After auto reroute, the route may not be changed.
‡If an unnecessary U-turn is shown or announced.
‡If a location has multiple names and the system
announces 1 or more of them.
‡When a route cannot be searched.
‡If the route to your destination includes gravel,
unpaved roads or alleys, the route guidance may
not be shown.
‡Your destination point might be shown on the
opposite side of the street.
‡When a portion of the route has regulations
prohibiting the entry of the vehicle that vary by time
or season or other reasons.
‡The road and map data stored in the navigation
system may not be complete or may not be the
latest version.
NOTE
OThis navigation system uses tire turning data and is designed to
ZRUN ZLWK IDFWRU\VSHFL

WHAT TO DO IF
271
APPENDIX/WHAT TO DO IF/INDEX
10
XIn other situations
Symptom Likely cause SolutionPage
Cellular
phoneThis
system
The Bluetooth connection status is
displayed at the top of the screen
each time the ignition switch is turned
to the “ACC” or “ON” position.&RQQHFWLRQFRQ¿UPDWLRQGLVSOD\RQ
this system is set to on.To turn off the display, set connection
FRQ¿UPDWLRQGLVSOD\RQWKLVV\VWHP
to off.-173
Even though all conceivable
measures have been taken, the
symptom status does not change.The cellular phone is not close
enough to this system.Bring the cellular phone closer to this
system.--
The cellular phone is the most likely
cause of the symptom.Turn the cellular phone off, remove
and reinstall the battery pack, and
then restart the cellular phone.*-
Enable the cellular phone’s Bluetooth
connection.*-
Stop the cellular phone’s security
software and close all applications.*-
Before using an application installed
on the cellular phone, carefully check
its source and how its operation
might affect this system.*-
*: For details, refer to the owner’s manual that came with the cellular phone.