reverse light SUBARU IMPREZA 2000 2.G Owners Manual

Seat, seat belt and SRS airbag2-13
–
CONTINUED –

Automatic Locking Retractor (ALR) function (except
driver’ s and 2-point type seatbelt)
When sec uring a c hild restraint system on the p asse ng ers’ seats, the
seatb elt must b e c hang ed over to the Automatic Loc k ing Retrac tor (ALR)
mod e.
When the c hild restraint system is removed , make su re that the retrac tor
op erates as an Emerg enc y Loc king Retrac tor (ELR).
For instruc tions on how to c onvert the retrac tor to the ALR mod e and re-
store it to the ELR mod e, see the “Child restraint systems ” sec tion in this
c hap ter. Seatbelt warning light and chime
Your vehic le is eq uip p ed with a seatb elt warning d e vic e at the d river’s
seat.
This d evic e c auses the seatb elt warning lig ht on th e instrument p anel to
lig ht up for ab out six sec ond s when the ig nition sw itc h is turned to the
“ ON ” p osition to remind the d river to wear the seatb elt . If the d river’s
seatb elt is not fastened , a warning c hime sound s at the same time.
Fastening the seatbelt
WARNING
Never use a belt that is twisted or reversed. In an accident, this
can increase the risk or severity of injury. Keep the lap belt as low as possible on your hips. In a colli-
sion, this spreads the force of the lap belt over stronger hipbones instead of across the weaker abdomen. Seatbelts provide maximum restraint when the occupant sits
well back and upright in the seat. To reduce the risk of sliding un-der the seatbelt in a collision, the front seatbacks should be al-ways used in the upright position while the vehicle is running. Ifthe front seatbacks are not used in the upright position in a colli-
sion, the risk of sliding under the lap belt and of the lap belt slid-ing up over the abdomen will increase, and both can result in se-

Maintenance and service10-53
–
CONTINUED –

Front turn signal light Type A
HGA011BB
1. Remove the b olt sec uring the front turn sig nal li g ht assemb ly.
2. Remove the front turn sig nal lig ht assemb ly from the front b ump er
and remove the b ulb soc ket b y turning it c ounterc lo c kwise.
3. Remove the b ulb from the soc ket b y p ushing it in and turning
c loc kwise, then install a new b ulb .
4. Install the removed p arts in the reverse ord er of removal.
Type B
HG0194
1. Remove the front turn sig nal lig ht assemb ly mount ing sc rews using
the p hillip s sc rewd river.
2. Remove the lens from the front turn sig nal lig ht assemb ly.