remote control SUBARU IMPREZA 2005 2.G Owners Manual

2-9
Keys and doors
– CONTINUED –
Remote keyless entry system
Two transmitters are provided for your vehicle.
The remote keyless entry system has the following
functions. yLocking and unlocking the doors (and rear gate on
the Wagon) without a key y Sounding a panic alarm
y Arming and disarming the security system (if your
vehicle is equipped with an optional security system).
See the next section “Security system (if equipped)”
for detailed information.
This device complies with Part 15 of the FCC
Rules and with RSS-210 of Industry Canada. Oper-
ation is subject to the following two conditions: (1)
This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equipment.
The operable distance of the keyless entry system is
approximately 30 feet (10 meters). However, this dis-
tance will vary depending on environmental condi- tions. The system’s operable distance will be shorter
in areas near a facility or electronic equipment emitting
strong radio waves such as a power plant, broadcast
station, TV tower, or remote controller of home elec-
tronic appliances.
The remote keyless entry system does not operate
when the key is inserted in the ignition switch to pre-
vent accidental lockout.
y
Do not expose the transmitter to severe
shocks, such as those experienced as a result
of dropping or throwing. y Do not take the transmitter apart except when
replacing the battery. y Do not get the transmitter wet. If it gets wet,
wipe it dry with a cloth immediately.

2-16
Keys and doors
3. Press and release any button on the transmitter
that you wish to program into the system. The horn will
sound twice to indicate that the transmitter has been
programmed.
Any additional transmitters can also be programmed
at this time. Repeat steps 1 through 3 for an additional
transmitter.
To exit the programming mode:
1. After all of your transmitters are programmed, re-
move the key from the ignition switch.
The horn will sound three times to indicate that the
system has exited the programming mode.
2. Make sure that the keyless entry system properly
operates by operating each transmitter. T
Deleting old transmitter codes
The control unit of the keyless entry system has four
memory locations to store transmitter codes, giving it
the ability to operate with up to four transmitters. When
you lose a transmitter, the lost transmitter’s code re-
mains in the memory. For security reasons, lost trans-
mitter codes should be deleted from the memory.
To delete old transmitter codes, program four trans-mitter codes into the system. If you have only one cur-
rent transmitter, program it four times. If you have two
current transmitters, program each one twice. If you
have three current transmitters, program two of them
once and the third one twice. This process will leave
only current transmitter codes in the system’s memo-ry.
NOTE
Make sure no one else is operating their keyless
entry system within range of your vehicle when
programming transmitters. If someone else were
to operate their remote transmitter while you are
programming your transmitters, it is possible that
their transmitter code will be programmed into
your system, allowing them unauthorized access
to your vehicle.
UG2042BA

3-48
Instruments and controls
played.
4. Releasing the button for 3 seconds will exit the
zone setting mode. „
Outside mirrors
T Convex mirror (passenger side)
Objects look smaller in a convex mirror and far-
ther away than when viewed in a flat mirror. Do
not use the convex mirror to judge the distance
of vehicles behind you when changing lanes.
Use the inside mirror (or glance backwards) to determine the actual size and distance of ob-
jects that you view in convex mirror.
T Remote control mirror switch
1) Selection switch
2) Direction control switch
The remote control mirrors operate only when the ig-
nition switch is in the “ON” or “ACC” position.
1. Press either end of the selection switch, “L” for the
left, “R” for the right.
2. Move the direction control switch in the direction
you want to move the mirror.
HS3040BA
MIRROR
LR1
2
UG3048BB

12-7
Specifications
– CONTINUED –
Fuses and circuits „Fuse panel located behind the coin tray
1
23456
78 9101112
13 14 15
16 17 18 19
20 21 22 23
HSC001BB
Fuse panelFuse ratingCircuit
115AyHeater fan
215AyHeater fan
315AyPower door lock
y Remote keyless entry
420AyCigarette lighter
y Remote controlled rear
view mirrors
510AyTail light
y Parking light
615AySRS airbag
715AyFog light
820AyABS solenoid
915AyRadio
10Empty
1115AyEngine ignition system
y SRS airbag
y AT control system

14-2
Index
A
ABS (Anti-lock Brake System) ........................... 7-31
Warning light ........................................ 3-23, 7-32
Accessories .............................................. 5-3, 11-68
Accessory power outlet .............................. 6-8, 6-11
Active head restraint ............................................ 1-6
Air cleaner element ......................................... 11-24
Air conditioner operation ..................................... 4-9
Air filtration system ............................................ 4-18
Air flow selection ................................................. 4-2
All-wheel drive warning light (for AWD AT vehicles) ........................................................ 3-26
Aluminum wheels ............................................ 11-54
Antenna system .................................................. 5-2
Anti-lock Brake System (ABS) ........................... 7-31
Arming the system ............................................. 2-17
Armrest ................................................................ 1-9
Ashtray .............................................................. 6-12
AT OIL TEMPerature warning light ................... 3-22
Audio set ............................................................. 5-3
Auto-dimming mirror/compass .......................... 3-46
Automatic climate control system ...................... 4-11
Automatic transmission ..................................... 7-22
Capacities ..................................................... 12-4
Fluid ............................................................ 11-32
Selector lever ................................................ 7-23
Shift lock release .......................................... 7-27 Temperature warning light ............................ 3-22
Automatic/Emergency Locking Retractor
(A/ELR) .......................................................... 1-15
B
Battery ............................................................. 11-63 Jump starting ................................................ 9-13
Replacement (Remote keyless entry system) ...................................................... 2-11
Brake
Booster ....................................................... 11-42
Fluid ............................................................ 11-40
Pad and lining ............................................. 11-45
Pedal .......................................................... 11-43
Brake pedal
Free play .................................................... 11-43
Reserve distance ........................................ 11-43
Brake system .................................................... 7-30
Warning light ................................................ 3-24
Braking .............................................................. 7-30 Breaking-in of new brake pads and
linings ....................................................... 11-45
Tips ............................................................... 7-30
Bulb
Chart ........................................................... 12-10
Replacing ................................................... 11-69