SUBARU LEGACY 2003 3.G Owners Manual

2
Keys and doors2-21
–
CONTINUED –
Windows
Power windows
WARNING
To avoid serious personal injury caused by entrapment, you must observe the following warnings: When operating power windows, be extremely careful to pre-
vent anyone ’s fingers, arms or head from being caught in the
window. Always lock the passengers ’ windows using the lock switch
when children are riding in the vehicle. Before leaving the vehicle, always remove the key from the
ignition switch for safety and never allow an unattended child toremain in the vehicle. Failure to follow this procedure could result
in injury to a child operating the power window.
The power windows operate only when the ignition switch is in the “ON”
position.
Driver’ s side switches
HB2008BB

2-22
HB2008DB
All door windows can be controlled by the power window switch clus-
ter at the driver side door. nOperating the driver ’s window
To open: Push the switch down lightly and hold it. The window will open as longas the switch is held.
This switch also has a one-touch auto down feature that allows thewindow to be opened fully without holding the switch.
Push the switch down until it clicks and release it, and the window will
fully open. To stop the window halfway, pull the switch up lightly.
To close: Pull the switch up lightly and hold it. The window will close as long asthe switch is held. n Operating the passengers ’ windows
To open the passengers ’ windows, push the appropriate switch down
and hold it until the window reaches the desired position. To close the
window, pull the switch up and hold it until it reaches the desired posi-tion. n Locking the passengers ’ windows
To lock the passengers ’ windows, push the lock switch. When the lock
switch is in the “LOCK” position, the passengers ’ windows cannot be
opened or closed.

2
Keys and doors2-23
–
CONTINUED –

Passengers’ side switches
HB2005BB
HB2009CB
To open the window, push the switch down and hold it until the win-
dow reaches the desired position. To close the window, pull the switch
up and hold it until the window reaches the desired position.
When the lock switch on the power window switch cluster, located on the driver ’s side door, is in the “LOCK” position, the passengers ’ win-
dows cannot be operated with the passengers ’ switches.

2-24
Trunk lid (Sedan)
WARNING
To prevent dangerous exhaust gas from entering the vehicle,
always keep the trunk lid closed while driving. Help prevent young children from locking themselves in the
trunk. When leaving the vehicle, either close all windows and lockall doors or cancel the inside trunk lid release. Also make certainthat the trunk is closed. On hot or sunny days, the temperature inthe trunk could quickly become high enough to cause death orserious heat-related injuries including brain damage, particularlyfor small children.
To open and close the trunk lid from outside
HBF013CB
To open the trunk lid from outside, insert the key and turn it clockwise.
To close the trunk lid, lightly press the trunk lid down until the latchengages.

2
Keys and doors2-25
–
CONTINUED –

To open the trunk lid from inside
HB3000CB
Pull the trunk lid release lever upward. To cancel the trunk lid release
HBF014BA
The inside trunk lid release can be cancelled to help prevent unautho-
rized entry into the trunk. To cancel the trunk lid release, set the lid
release cancel lever (located on the inside of the trunk lid, mounted tothe trunk lid latch) to the “CANCEL” position. When this lock is in the
“CANCEL” position, the trunk can be opened only with the key.

2-26

Internal trunk lid release handle
The internal trunk lid release handle is a device designed to open the
trunk lid from inside the trunk. In the event children or adults become
locked inside the trunk, the handle allows them to open the lid. The han-dle is located on the inside of the trunk lid.
WARNING
Never allow any child to get in the trunk and play with the releasehandle. If the driver starts the vehicle without knowing that achild is inside the trunk and the child opens the lid using the re-
lease handle, the child could fall out and be killed or seriously in-jured.
CAUTION
Do not close the lid while gripping the release handle. The
handle may be damaged. Do not use the handle as a hook to fasten straps or ropes to
secure your cargo in the trunk. Such use may result in damage ofthe handle. Load the trunk so that cargo can not strike the release handle.
If the cargo hits the handle while the vehicle is being driven, thehandle may be pushed down and the trunk lid may open. Thatmay cause cargo to fall out of the trunk, which could create a traf-fic safety hazard.

2
Keys and doors2-27
–
CONTINUED –
HBS070BA
To open the trunk lid from inside the trunk, press the yellow handle down-
ward as indicated by the arrow on the handle. This operation unlocks thetrunk lid. Then, push up the lid.
The handle is made of material that remains luminescent for approxi-mately an hour in the dark trunk space after it is exposed to ambient light
even for a short time.
Inspection
Perform the following steps at least twice a year to check the release
handle for correct operation.
1. Open the trunk lid.
HBS072BB
HBS071BA
2. Use a screwdriver with a thin blade. Slide the screwdriver blade
from the slit aperture of the lock assembly fully to the end until youhear a click. This places the latch in the locked position.

2-283. Move the release handle, from outside the vehicle, in the direction
of the arrow to check if the latch is released.
HG2018BA
If the latch is not released, contact your SUBARU dealer.
In that case, use the key to release the latch, then close the trunk lid.
Also, if the movements of the release handle feel restricted or not en-
tirely smooth during operation, or the handle and/or handle base is
cracked, contact your SUBARU dealer.

2
Keys and doors2-29
–
CONTINUED –
Rear gate (Station wagon)
WARNING
To prevent dangerous exhaust gas from entering the vehicle, always keep the rear gate closed while driving.
CAUTION
Do not jam a plastic bag in or place cellophane tape on the reargate stays or scratch the stays while loading or unloading cargo.That could cause leakage of gas from the stays, which may resultin their inability to hold the rear gate open.
HB2022BB
To unlock the rear gate, insert the key in the keyhole and turn it clock-
wise. To lock the rear gate, insert the key in the keyhole and turn it coun-
terclockwise. If your vehicle is equipped with power door locking
switches, the rear gate can also be locked and unlocked through use ofthe power door locking switches. Refer to “Power door locking switches ”
section in this chapter.
To open the rear gate, first unlock the rear gate lock then pull the outside
handle up. To close the rear gate, lower it slowly and push down firmly
until the latch engages.

2-30
Moonroof (if equipped)
WARNING
Never let anyone ’s hands, arms, head or any objects protrude
from the moonroof. He/she could be seriously injured if the
vehicle stops suddenly or turns sharply or if the vehicle is in-
volved in an accident.
To avoid serious personal injury caused by entrapment, you must observe the following warnings: Before closing the moonroof, make sure that no one ’s hands,
arms, head or other objects will be accidentally caught in themoonroof. Before leaving the vehicle, always remove the key from the
ignition switch for safety and never allow an unattended child toremain in the vehicle. Failure to follow this procedure could resultin injury to a child operating the moonroof.
CAUTION
Do not sit on the edge of the open moonroof.
Do not operate the moonroof if falling snow or extremely cold
conditions have caused it to freeze shut.
Tilting/sliding moonroof (Sedan)
The moonroof has both tilting and sliding functions.
The moonroof operates only when the ignition switch is in the “ON” posi-
tion.