heater SUBARU LEGACY 2004 4.G Owners Manual

1-1
1
Seat, seatbelt and SRS airbags
Front seats .................................................... 1-2 Fore and aft adjustment ................................... 1-3
Seat cushion angle and height adjustment (Power seat only) ........................................... 1-4
Reclining the seatback ..................................... 1-5
Head restraint adjustment ................................ 1-7
Lumbar support (if equipped) .......................... 1-8
Seat heater (if equipped) .............................. 1-9
Rear seats ..................................................... 1-10 Armrest (if equipped) ........................................ 1-11
Headrest adjustment – Rear center seating position on Station wagon ............................ 1-13
Folding down the rear seat – Station wagon .. 1-14
Seatbelts ....................................................... 1-18 Seatbelt safety tips ........................................... 1-18
Emergency Locking Retractor (ELR) .............. 1-19
Automatic/Emergency Locking Retractor (A/ELR) ............................................................ 1-20
Seatbelt warning light and chime ................... 1-20
Fastening the seatbelt ...................................... 1-20
Seatbelt maintenance ....................................... 1-31
Seatbelt extender ......................................... 1-32
Front seatbelt pretensioners ....................... 1-34 System monitors ............................................... 1-35
System servicing .............................................. 1-36
Precautions against vehicle modification ...... 1-37
Child restraint systems ................................ 1-37 Where to place a child restraint system ......... 1-39
Choosing a child restraint system .................. 1-41 Installing child restraint systems with A/ELR
seatbelt ............................................................ 1-41
Installing a booster seat ................................... 1-46
Installation of child restraint systems by use
of lower and tether anchorages (LATCH) .... 1-48
Top tether anchorages ..................................... 1-52
*SRS airbag (Supplemental Restraint System airbag) ........................................... 1-57Vehicle with driver’s and front passenger’s SRS airbags and lap/shoulder restraints ..... 1-57
SRS frontal airbag ............................................ 1-62
SRS side airbag (if equipped) .......................... 1-70
SRS airbag system monitors ........................... 1-78
SRS airbag system servicing .......................... 1-79
Precautions against vehicle modification ...... 1-80

1-9
Seat, seatbelt and SRS airbags
– CONTINUED –
Seat heater (if equipped)
1) Heating element
The seat heater operates when the ignition switch is
either in the “ACC” or “ON” position. 1) Indicator light
To turn on the seat heater, push the “LO” or “HI” posi-
tion on the switch, as desired, depending on the tem-
perature. Selecting the “HI” position will cause the seat
to heat up quicker.
LO: Normal heating
HI: Rapid heating
The indicator located on the switch comes on when
the seat heater is in operation. When the vehicle’s in-
terior is warmed enough or before you leave the vehi-
cle, be sure to turn the switch off.
1
UB1073BB
1 LO
HI
UB1093BB

1-10
Seat, seatbelt and SRS airbags
y
There is a possibility that people with delicate
skin may suffer slight burns even at low tem-
peratures if he/she uses the seat heater for a
long period of time. When using the heater, al-
ways be sure to warn the persons concerned. y Do not put anything on the seat which insu-
lates against heat, such as a blanket, cushion,
or similar items. This may cause the seat heater
to overheat.
NOTE y Use of the seat heater for a long period of time
while the engine is not running can cause battery
discharge. y When cleaning the seat, do not use benzine,
paint thinner, or any similar materials.
Rear seats
Seatbelts provide maximum restraint when the
occupant sits well back and upright in the seat.
Do not put cushions or any other materials be-
tween occupants and seatbacks or seat cush-
ions. If you do so, the risk of sliding under the
lap belt and of the lap belt sliding up over the
abdomen will increase, and both can result in
serious internal injury or death.
UB0302

3-32
Instruments and controls
dicator light (green) located to the right of the button
will illuminate.y
By pressing and releasing the right button, the com-
pass display is toggled on or off. When the compass is
on, an illuminated compass reading will appear in the
lower part of the mirror.
Even with the mirror in anti-glare mode, the mirror sur-
face turns bright if the transmission is shifted into re-
verse. This is to ensure good rearward visibility during reversing. T Photosensors
The mirror has a photosensor attached on both the
front and back sides. If the glare from the headlights of vehicles behind you strikes the mirror, these sensors
detect it and make the reflection surface of the mirror
dimmer to help prevent you from being blinded. For
this reason, use care not to cover the sensors with
stickers, or other similar items. Periodically wipe the
sensors clean using a piece of dry soft cotton cloth or
an applicator. T
Compass calibration
1. For optimum calibration, switch off all nonessential
electrical accessories (rear window defogger, heater/
air conditioning system, spotlight, etc.) and ensure all
doors are shut.
2. Drive to an open, level area away from large metal-
lic objects or structures and make certain the ignition
switch is in the “ON” position.
3. Press and hold the left button for 3 seconds then re-
lease, and the compass will enter the calibration
mode. “CAL” and direction will be displayed.
4. Drive slowly in a circle until “CAL” disappears from
the display (about two or three circles). The compass
is now calibrated.
5. Further calibration may be necessary should out-
side influences cause the mirror to read inaccurately.
You will know that this has occurred if your compass
begins to read in only limited directions. Should you
encounter this situation, return to step one of the
above procedure and recalibrate the mirror.
HS3038BA

3-35
Instruments and controls
– CONTINUED –
The indicator light located on the switch will come on
when the outside mirror defogger heater in operation.
To turn it off, push the switch again.Tilt steering wheel
Do not adjust the steering wheel tilt position
while driving. This may cause loss of vehicle
control and result in personal injury.
1. Adjust the seat position. Refer to the “Front seats”
section (chapter 1).
2. Pull the tilt lock lever down.
3. Move the steering wheel to the desired level.
4. Push the lever up to lock the steering wheel in
HS3043BA

4-1
4
Climate control
Ve ntilat or .. ... ... .. ... ... ... ... .. ... ... ... ... .. ... ... ... ... .. ... 4-2
Driver’s si de ventilat ors .......... .................... ..... 4-2
Center ventilat ors .................... .................... ..... 4-2
Fro nt p assen ger’s si de ventilat ors ............ ..... 4-3
Air fl ow s electi on ..................... .................... ..... 4-4
M an u al heati ng and air co nditio nin g
sys te m ... ... ... .. ... ... ... ... .. ... ... ... ... .. ... ... ... ... .. ... 4-5
Co ntrol pan el ....... ..................... .................... ..... 4-5
Heat er o peration .. .................... .................... ..... 4-7
Air co nditio ner operation ........ .................... ..... 4-10
Aut omatic clim ate co ntr o l sy stem
( if eq uip ped) .. ... ... ... ... .. ... ... ... ... .. ... ... ... ... .. ... 4-11
Co ntrol pan el ....... ..................... .................... ..... 4-12
Te mperature se nsors .............. .................... ..... 4-18
O per atin g ti ps for heater a n d a ir
c o nd iti oner .. .. ... ... ... ... .. ... ... ... ... .. ... ... ... ... .. ... 4-19
Clea ning ventilator g rille ......... .................... ..... 4-19
Effic ient cool ing a fter parking in dir e ct
su nlig ht ............. ..................... .................... ..... 4-20
L u bricati on oil circul ation in the refrigerant
circuit ................ ..................... .................... ..... 4-20
Che cking air co nditi oni ng sy stem before
su mmer sea son ..................... .................... ..... 4-20
Co oling and de hum idif ying in high hum idi ty
and low te mperature weat her co ndition .. .... 4-20
Air co ndit io ner co mpressor s hut-o ff
w hen e ngi ne is heavily l oaded ................. ..... 4-20
Refrigerant for your climate control system .. 4-20
Air filtration system (if equipped) ................ 4-21

4-7
Climate control
– CONTINUED –
ON position (Recirculation): Interior air is recirculat-
ed inside the vehicle. Push the air inlet selection but-
ton to the ON position. The indicator light will come on.
Push the air inlet selection button to the ON position
for fast cooling with the air conditioner or when driving
on a dusty road.
OFF position (Outside Air): Outside air is drawn into
the passenger compartment. Push the air inlet selec-
tion button again to the OFF position. The indicator
light will go off.
Push the air inlet selection button to the OFF position
when the interior has cooled to a comfortable temper-
ature and the road is no longer dusty. „
Heater operation
T Defrosting or defogging the windshield
To direct warm air to the windshield and front door win-
dows:
1. Set the air flow control dial to the “ ” position.
2. Turn the temperature control dial all the way to the right.
3. Set the fan speed control dial to the highest speed.
NOTE
Warm air also comes out from the right and left air
outlets. To stop warm air flow from these outlets,
turn the corresponding thumb-wheel to the
UB5011AA

4-19
Climate control
– CONTINUED –
grille)
– In-vehicle temperature sensor (beside the tempera-ture control dial.)
– Ambient sensor (at the under side of the bumper) Operating tips for heater and air con-
ditioner „
Cleaning ventilator grille
1) Ventilator inlet grill
Always keep the front ventilator inlet grille free of
snow, leaves, or other obstructions to ensure efficient
heating and defrosting. Since the condenser is located
in front of the radiator, this area should be kept clean
because cooling performance is impaired by any ac-
cumulation of insects and leaves on the condenser.
1
UB5019BC

5-42
Audio
Precautions to observe when han-
dling a compact disc (CD)
Use only compact discs (CDs) that have the mark
shown below. CD-RWs cannot be used. Also, some
CD-Rs cannot be played. y
In cold and/or rainy weather, dew can form inside
the CD player, preventing normal operation. If this
happens, eject the CD and wait for the player to dry
out. y Skipping may occur when the CD player is subject-
ed to severe vibration (for example, when the vehicle
is driven on a rough surface). y
To remove a disc from the case, press the center of
the case and hold both edges of the disc. If the disc
surface is touched directly, contamination could cause
poor tone quality. Do not touch the disc surface. y Use a clean disc whenever possible. If there are de-
posits, wipe the disc surface from the center outward
with a dry, soft cloth. Be sure not to use a hard cloth,
thinner, benzene, alcohol, etc.y Do not use any disc that is scratched, deformed, or
cracked. Also, do not use any disc that has a non-stan-
dard shape (for example, a heart shape). Malfunctions
or problems might result. y A disc is vulnerable to heat. Never keep it either in
places exposed to direct sunlight, near heaters or in
vehicles parked in the sun or hot days.
HS5017AA

12-6
Specifications
Fuses and circuits „
Fuse panel located behind the coin tray
T 2.5 liter models
19
18
17
16
20 21
15
14
12
11
10 9
8
7
6
5
4
3
2
1
13
HBC001DB
Fuse panelFuse ratingCircuit
115Ay
Heater fan
215AyHeater fan
315AyPower door lock
y Keyless entry
420AyMirror heater
y Cigarette lighter
y Remote controlled rear
view mirrors
510AyTail light
y Parking light
615AySRS airbag
715AyFront fog light
830AyABS solenoid
915AyRadio
y Clock
1015AyTrailer
1115AyEngine ignition system
y SRS airbag