seat adjustment SUBARU LEGACY 2004 4.G Owners Manual

1-1
1
Seat, seatbelt and SRS airbags
Front seats .................................................... 1-2 Fore and aft adjustment ................................... 1-3
Seat cushion angle and height adjustment (Power seat only) ........................................... 1-4
Reclining the seatback ..................................... 1-5
Head restraint adjustment ................................ 1-7
Lumbar support (if equipped) .......................... 1-8
Seat heater (if equipped) .............................. 1-9
Rear seats ..................................................... 1-10 Armrest (if equipped) ........................................ 1-11
Headrest adjustment – Rear center seating position on Station wagon ............................ 1-13
Folding down the rear seat – Station wagon .. 1-14
Seatbelts ....................................................... 1-18 Seatbelt safety tips ........................................... 1-18
Emergency Locking Retractor (ELR) .............. 1-19
Automatic/Emergency Locking Retractor (A/ELR) ............................................................ 1-20
Seatbelt warning light and chime ................... 1-20
Fastening the seatbelt ...................................... 1-20
Seatbelt maintenance ....................................... 1-31
Seatbelt extender ......................................... 1-32
Front seatbelt pretensioners ....................... 1-34 System monitors ............................................... 1-35
System servicing .............................................. 1-36
Precautions against vehicle modification ...... 1-37
Child restraint systems ................................ 1-37 Where to place a child restraint system ......... 1-39
Choosing a child restraint system .................. 1-41 Installing child restraint systems with A/ELR
seatbelt ............................................................ 1-41
Installing a booster seat ................................... 1-46
Installation of child restraint systems by use
of lower and tether anchorages (LATCH) .... 1-48
Top tether anchorages ..................................... 1-52
*SRS airbag (Supplemental Restraint System airbag) ........................................... 1-57Vehicle with driver’s and front passenger’s SRS airbags and lap/shoulder restraints ..... 1-57
SRS frontal airbag ............................................ 1-62
SRS side airbag (if equipped) .......................... 1-70
SRS airbag system monitors ........................... 1-78
SRS airbag system servicing .......................... 1-79
Precautions against vehicle modification ...... 1-80

1-3
Seat, seatbelt and SRS airbags
– CONTINUED –
restrained or improperly restrained. Because
children are lighter and weaker than adults,
their risk of being injured from deployment is
greater. For that reason, we strongly recom-
mend that ALL children (including those in
child seats and those that have outgrown child
restraint devices) sit in the REAR seat properly
restrained at all times in a child restraint device
or in a seatbelt, whichever is appropriate for the
child’s age, height and weight.
Secure ALL types of child restraint devices (in-
cluding forward facing child seat) in the REAR
seats at all times.
NEVER INSTALL A REARWARD FACING CHILDSEAT IN THE FRONT SEAT. DOING SO RISKS
SERIOUS INJURY OR DEATH TO THE CHILD
BY PLACING THE CHILD’S HEAD TOO CLOSE
TO THE SRS AIRBAG.
According to accident statistics, children are
safer when properly restrained in the rear seat-
ing positions than in the front seating posi-
tions. For instructions and precautions con-
cerning child restraint systems, see the “Child
restraint systems” section in this chapter. „
Fore and aft adjustment
T Manual type
Pull the lever upward and slide the seat to the desired
position. Then release the lever and move the seat-
back and forth to make sure that it is securely locked
into place.
UB1058BA

1-7
Seat, seatbelt and SRS airbags
– CONTINUED –
„Head restraint adjustment
To raise the head restraint, pull it up. To lower it, push
the head restraint down while pressing the release
button on the top of the seatback.
The head restraint should be adjusted so that the cen-
ter of the head restraint is closest to the top of the oc-
cupant’s ears.
Never drive the vehicle with the head restraints
removed because they are designed to reduce
the risk of serious neck injury in the event that
the vehicle is struck from the rear.
NOTE
If the seatback is reclined rearward to the same
level as the rear seat cushion with the head re-
straint removed, a wide flat bed is made available.
y Never drive your car with the seats converted
in a flat bed position. If you do so, occupants
will have a greater chance of being injured even
during simple deceleration, acceleration and
cornering since no firm restraint will be avail-
able for them. y Before you lie on the flat bed to take a rest,
read the description “Parking your vehicle” in
Chapter 7 carefully and follow the instructions.
UB1016BA

1-13
Seat, seatbelt and SRS airbags
– CONTINUED –
and heavier than 55 lbs (25 kg). Such objects
can interfere with the driver’s proper operation
of the car, possibly causing an accident and se-
rious injury. „
Headrest adjustment – Rear center
seating position on Station wagon
To raise the headrest, pull it up. To lower it, push the
headrest down while pressing the release button on
the top of the seatback.
When the rear center seating position is occupied,
place the headrest in its highest position. When the
rear center seating position is not occupied, lower the
headrest to improve rearward visibility.
UB1053BA
UB1099BA

7-9
Starting and operating
– CONTINUED –
in vehicle’s computer with the “ CHECK ENGINE”
warning light/MIL illuminated. y A state emission inspection may reject (not pass or
fail) a vehicle if the number of OBD system readinessmonitors “ Not Ready ” is greater than three. Under this
condition, the vehicle operator should be instructed to
drive his/her vehicle for a few days to set the monitors
and return for an emission re-inspection. y Owners of rejected or failing vehicles should contact
their SUBARU Dealer for service.Preparing to drive
You should perform the following checks and adjust-
ments every day before you start driving.
1. Check that all windows, mirrors, and lights are
clean and unobstructed.
2. Check the appearance and condition of the tires.
Also check tires for proper inflation.
3. Look under the vehicle for any sign of leaks.
4. Check that the hood, trunk and rear gate are fully
closed.
5. Check the adjustment of the seat.
6. Check the adjustment of the inside and outside mir-rors.
7. Fasten your seatbelt. Check that your passengers
have fastened their seatbelts.
8. Check the operation of the warning and indicator
lights when the ignition switch is turned to the “ON” po- sition.
9. Check the gauges, indicator and warning lights af-
ter starting the engine.
NOTE
Engine oil, engine coolant, brake fluid, washer flu-
id and other fluid levels should be checked daily,
weekly or at fuel stops.

14-5
Index
G
GAWR (Gross Axle Weight Rating)
.....................8-19
Glove box ........................................................................ 6-6
GVWR (Gross Vehicle Weight Rating ) .............8-19
H
Hazard warning flasher ............................................. 3-6
Headlights ......................................................... 3-19, 11-65
Headrest adjustment (Wagon) ..............................1-13
Head restraint adjustment (Front) .......................1-7
Heater operation .......................................................... 4-7
High beam indicator light ..........................................3-18
High mount stop light ................................................. 11-79
Horn ................................................................................... 3-36
Hose and connections ............................................... 11-18
IIgnition switch ..... ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... ... . 3-3
Illuminated entry ........................................................... 2-9
Illumination brightness control ...............................3-22
Indicator light
High beam ................................................................ 3-18
Selector lever position ......................................... 3-17
Turn signal ................................................................ 3-17
Inside mirror ................................................................... 3-31
Internal trunk lid release handle ............................2-28J
Jack and jack handle
................................................. 9-32
Jump starting ................................................................. 9-15
KKey Interlock release .................................................... 3-5
Number ...................................................................... 2-2
Reminder chime ..................................................... 3-5
Keys .................................................................................. 2-2
LLe ath er s e at materi als ... ... .. ... ... .. ... ... .. ... .. ... ... .. ... ... .. .. 10 -7
Light control switch ..................................................... 3-19
Limited slip differential (LSD) .................................7-29
Loading your vehicle .................................................. 8-17
LSD (Limited slip differential) .................................7-29
Luggage cover .............................................................. 6-22
M
Main fuse ........................................................................ 11-61
Maintenance Precautions .............................................................. 11-3
Schedule ................................................................... 11-3
Seatbelt ..................................................................... 1-31
Tools ........................................................................... 9-31