SUBARU OUTBACK 2001 3.G Owners Manual

Audio5-5
–
CONTINUED –

McIntosh audio set
HB5045AA
Rad io op eration: refer to p ag e 5-39
Cassette p layer op eration: refer to p ag e 5-44
CD p layer op eration: refer to p ag e 5-46
CD c hang er c ontrol: refer to p ag e 5-49
CD player 1 (Optional audio unit — if equipped)
HB5039AA
Inserting and removing a d isc : refer to p ag e 5-52

5-6
CD player 2 (Optional audio unit — if equipped)
HB5044AA
CD (c omp ac t d isc ) p layer op eration: refer to p ag e 5 -54
In-dash 6 CD auto changer (Optional audio unit — if equipped)
HB5040AA
Inserting and removing a d isc or all d isc s: refer t o p ag e 5-57

Audio5-7
–
CONTINUED –
Type A and B audio set (if equipped)
Typ e A: Without weather b and
Typ e B: With weather b and
The aud io set will op erate only when the ig nition s
witc h is in the “ACC ” or
“ ON ” p osition.
Radio operation
HB5041BB
1 Power switc h/Volume, Tone,
Balanc e, Fad er c ontrol d ial
2 AUDIO b utton
3 BAND b utton 4
Tuning b uttons
5 Preset b uttons
6 SCAN b utton
Power switch and volume/bass/treble/fader/balance control
n Power switch and volume control (PWR/VOL)
The d ial 1 is used for b oth p ower (ON/OFF) and volume c ontrol . The
rad io is turned ON and OFF b y p ushing the d ial and the volume is
c ontrolled b y turning the d ial.

5-8n
Tone and balance control (AUDIO)
The volume c ontrol d ial 1 normally func tions as a volume c ontrol.
This d ial b ec omes a c ontrol for Bass, Treb le, Fad er or Balanc e when
you selec t the ap p rop riate tone and b alanc e c ontrol mod e.
Choose d esired volume level for eac h mod e b y turnin g the volume
c ontrol d ial. The c ontrol func tion returns to volum e c ontrol mod e after
ab out 5 sec ond s.
To change control modes: Eac h b rief p ress of the “AUDIO ” b utton
2 c hang es c ontrol mod es in the following seq uenc e st arting from vol-
ume c ontrol mod e. (When the rad io is first turned o n, the c ontrol mod e
is in the volume c ontrol.)
Volume Bass Treb le Fad er Balanc e
The “AUDIO ” b utton 2 is used for selec ting the following c ontrol
mod es:
Display
Control mode
HB5036BA
Turn counterclockwiseTurn clockwise
BASBass controlFor less bassFor more bass
TRETreble controlFor less trebleFor more treble
FA dFader controlTo increase rear speaker
volume and decrease front
speaker volumeTo increase front speaker
volume and decrease rear
speaker volume
BALBalance controlTo increase left speaker
volume and decrease right
speaker volumeTo increase right speakervolume and decrease left
speaker volume
VOLVolume controlFor less volumeFor more volume

Audio5-9
–
CONTINUED –

Waveband selection
n FM/AM selection (P119 type audio set)
Push the “BAND ” b utton 3 to selec t FM1, FM2 or AM rec ep tion. The
d isp lay ind ic ates whic h one is c urrently selec ted . n FM/AM/Weather band selection (P120 type audio set)
Push the “BAND ” b utton 3 to selec t FM1, FM2, AM or Weather b and
(WB) rec ep tion. The d isp lay ind ic ates whic h is c urr ently selec ted .
Stereo indicator
The stereo ind ic ator “ST ” will c ome on when an FM stereo b road c ast
is rec eived . Tuning (TUNE)
n Manual tuning (TUNE)
Press the tuning b utton 4 marked “ ” to inc rease the tuning freq uen-
c y and p ress the tuning b utton marked “ ” to d ec rease it.
Eac h time the b utton is p ressed , the freq uenc y inte rval c an b e
c hang ed b etween 10 kHz in the AM mod e and 0.2 MHz i n the FM
mod e.
Constant p ressure on the b utton c auses a c ontinuous c hang e in the
freq uenc y. n Manual tuning for weather band
When weather b and mod e is selec ted , p ress the tunin g b utton
4
marked “ ” to c hang e the WB c hannel up and p ress the tuning b ut-
ton marked “ ” to c hang e the WB c hannel d own. Eac h time the b ut-
ton is p ressed , the WB c hannel c hang es to the next c hannel.
Constant p ressure on the b utton c auses a c ontinuous c hang e in the
freq uenc y. n Automatic tuning (SCAN)
Press the “SCAN ” b utton
6 to c hang e the rad io to the SCAN mod e. In
this mod e, the rad io sc ans throug h the rad io b and u ntil a station is
found . The rad io will stop at the station for five sec ond s while d isp lay-
ing the freq uenc y, after whic h sc anning will c ontin ue until the entire
b and has b een sc anned from the low end to the hig h end .

5-10Press the
“SCAN ” b utton ag ain to c anc el the SCAN mod e and to stop
on any d isp layed freq uenc y.
When the “SCAN ” b utton is p ressed for automatic tuning , stations a re
sc anned in the d irec tion of low freq uenc ies to hig h freq uenc ies only.
Automatic tuning may not func tion p rop erly if the s tation rec ep tion is
weakened b y d istanc e from the station or p roximity to tall b uild ing s
and hills. Selecting preset stations
Presetting a station with a “p reset b utton ”
5 allows you to selec t that
station in a sing le op eration. Up to six WB (if eq u ip p ed ), AM, FM1 and
FM2 stations eac h may b e p reset. How to preset stations
1. Press the “BAND ” b utton 3 to selec t FM1, FM2, AM or WB (if
eq uip p ed ) rec ep tion.
2. Press the “SCAN ” b utton or tune the rad io manually until the
d esired station freq uenc y is d isp layed .
3. Press one of the p reset b uttons for more than 2 s ec ond s to store
the freq uenc y. At this time, there will momentarily b e no sound from
the rad io. If the b utton is p ressed for less than 2 sec ond s, the p rec ed -
ing selec tion will remain in memory.
NOTE If the connection between the radio and battery is broken for any
reason such as vehicle maintenance or radio removal, all stationsstored in the preset buttons are cleared. If this occurs, it is neces-sary to reset the preset buttons.

Audio5-11
–
CONTINUED –
Cassette player operation
HB5041CB
7 Cassette slot
8 Ejec t b utton
9 TAPE b utton
Q TPS (Tap e Prog ram Searc h)
W Rep eat b utton E
Fast-forward b utton
R Rewind b utton
T Dolb y B NR b utton
Y Prog ram b utton
NOTE Only use good quality cassettes (cassettes longer than C-90 are
not recommended). Put cassettes back in their boxes immediately after use to protect
them from dust and dirt and to prevent the tape from unwinding. Never expose cassettes to heat, direct sunlight or moisture.
Clean the tape head (once or twice a month) using a wet-type
cleaning cassette .
Cassette slot
Insert a c assette with the exp osed tap e sid e fac ing to the rig ht. After
insertion, p layb ac k starts. TAPE button
Press the “TAPE b utton ”
9 when the c assette left in the c assette slot
is to b e p layed b ac k ag ain.

5-12
Tape travel indicators
These ind ic ate the d irec tion the c assette tap e is m oving .
: Ind ic ates that the top sid e of the c assette is b eing p layed b ac k.
: Ind ic ates that the b ottom sid e of the c assette i s b eing p layed
b ac k. Program button (PROG)
When the p rog ram b utton Y is p ressed d uring p layb ac k, the tap e
travel ind ic ators will switc h and the p layer will b eg in p laying b ac k the
op p osite sid e of the tap e. The same mec hanism is au tomatic ally ac ti-
vated when the end of the tap e is reac hed . This all ows the op p osite
sid e of the tap e to p lay, p rovid ing c ontinuous p lay b ac k.
Fast-forward button (FF)
To fast-forward the tap e, p ress the “FF ” b utton
E. To stop fast-for-
ward ing , lig htly p ress the “
” 8 b utton.
Rewind button (REW)
To rewind the tap e, p ress the “REW ” b utton R. To stop rewind ing ,
lig htly p ress the “
” 8 b utton.
Eject button (
)
When “
” b utton 8 is p ressed , p layb ac k stop s and the c assette
tap e is ejec ted .
The ejec tion func tion is also ac tive when the ig nit ion switc h is in the
“ LOCK ” p osition. Always make c ertain that you remove the c assette
tap e. Repeat (RPT)
Press the “RPT ” b utton
W while a song is p laying to p lay the song
rep eated ly. The “RPT ” ind ic ator will c ome on and the song will b e
p layed c ontinuously. To c anc el the rep eat mod e, p re ss the b utton
ag ain. Then the “RPT ” ind ic ator g oes out, and normal p layb ac k mod e
is restored .

Audio5-13
–
CONTINUED –

Dolby B NR button (
)
Press the “
” b utton T when p laying tap es rec ord ed using the
Dolb y NR system*. The “
” ind ic ator will lig ht up and hig h-freq uen-
c y noise on the tap e will b e red uc ed for c learer so und rep rod uc tion.
*Noise red uc tion system manufac tured und er lic ense from Dolb y Lab oratories
Lic ensing Corp oration. “Dolb y ” and the d oub le-D Symb ol are trad e marks of
Dolb y Lab oratories Lic ensing Corp oration.
CD player control (If optional CD player is connected)
An op tional CD p layer c an b e c onnec ted to this aud i o unit. See your
SUBARU d ealer for more information. For p roc ed ures for load ing and un-
load ing CDs, refer to “CD p layer 1 ” in this c hap ter.
HB5041DB
U CD b utton
I RAND (Rand om) b utton
O RPT (Rep eat) b utton P
Trac k selec tion b uttons
A SCAN b utton
To start playback
n When CD is not in the CD player
Hold a d isc with a fing er in the c enter hole while g rip p ing the ed g e of
the d isc , then insert it in to the slot (with the l ab el sid e up ) on the CD
p layer and the p layer will automatic ally p ull the d isc into p osition.

5-14After insertion, the CD p layer mod e ind ic ator
“CD ” will c ome on and
p layb ac k will start. n When CD is in the CD player
Press the “CD ” b utton
U. The “CD ” ind ic ator will c ome on, and the
trac k numb er will ap p ear on the d isp lay and the CD p layer will start
p layb ac k. NOTE If the “CD” button is pressed during a radio broadcast, the
disc will interrupt the broadcast. After playback on the last song finishes, the player will auto-
matically return to track 1 (the first song on the disc). To select a song from its beginning
Briefly p ress the “ ❚” b utton
P to skip to the b eg inning of the next
trac k and b riefly p ress the “❚ ” b utton to skip to the b eg inning of
the c urrent trac k. Fast-forwarding and fast-reverse
Press the “ ❚” b utton
P c ontinuously for more than a half sec ond
to fast-forward the d isc .
Press the “❚ ” b utton c ontinuously for more than a half sec ond to
fast reverse the d isc .
Release the b utton to stop fast forward ing or fast reverse.
Repeat
Press the “RPT ” b utton
O while a song is p laying to p lay the song
rep eated ly. The “RPT ” ind ic ator will c ome on and the song will b e
p layed c ontinuously. To c anc el the rep eat mod e, p re ss the b utton
ag ain. Then the “RPT ” ind ic ator g oes out, and normal p layb ac k mod e
is restored . Random playback
Press the “RAND ” b utton
I while a d isc is b eing p layed b ac k to p lay
all song s on the d isc in a rand om ord er. The “RAND ” ind ic ator will
c ome on and all song s on the d isc will b e p layed in a rand om ord er.
To c anc el the rand om mod e, p ress the b utton ag ain. Then the
“ RAND ” ind ic ator g oes out, and normal p layb ac k mod e is re stored .