alarm SUBARU OUTBACK 2001 3.G Owners Manual

Keys and doors2-7
–
CONTINUED –
Keyless entry system (if equipped)
CAUTION
Do not expose the transmitter to severe shocks, such as those
experienced as a result of dropping or throwing. Do not take the transmitter apart except when replacing the
battery. Do not get the transmitter wet. If it gets wet, wipe it dry with a
cloth immediately. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the followingtwo conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received,including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user ’s authority to
operate the equipment.
Two transmitters are p rovid ed for your vehic le.
The keyless entry system has the following func tion s.
Loc king and unloc king the d oors (and rear g ate on t he station wag on)
without a key Sound ing a p anic alarm
Arming and d isarming the sec urity system (if your v ehic le is eq uip p ed
with an op tional sec urity system). See the next sec tion “Sec urity system
(if eq uip p ed ) ” for d etailed information.
The op erab le d istanc e of the keyless entry system i s ap p roximately 30
feet (10 meters). However, this d istanc e will vary d ep end ing on environ-
mental c ond itions. Rang e may b e red uc ed near sourc e s of RF interfer-
enc e suc h as p ower p lants and rad io/television b roa d c asting towers.
The keyless entry system d oes not op erate when the key is inserted in
the ig nition switc h.

2-8
HB1000BB
1. Press once to Unlock
driver’s door.
2. Press a second time to Unlockall doors.
Press to Lock all doors. Press and Hold to activate panic alarm.
LED
Locking the doors
Briefly p ress the “LOCK/ARM ” b utton (for less than two sec ond s) to
loc k all d oors (and rear g ate on the station wag on) . The horn will
sound one time.
If any of the d oors (or the rear g ate) is not fully c losed , the horn will
sound three times to alert you that the d oors (or t he rear g ate) are not
p rop erly c losed . When you c lose the d oor, it will a utomatic ally loc k.
Unlocking the doors
Briefly p ress the “UNLOCK/DISARM ” b utton (for less than two
sec ond s) to unloc k the d river ’s d oor. The horn will sound two times. To
unloc k all d oors (and rear g ate on the station wag o n), b riefly p ress the
“ UNLOCK/DISARM ” b utton a sec ond time.
Illuminated entry
The interior (d ome) lig ht will illuminate when the “UNLOCK/DISARM ”
b utton is p ressed . The lig ht will illuminate for ap p roximately 30
sec ond s or until the key is inserted in the ig nitio n switc h or until the
“ LOCK/ARM ” b utton is p ressed . Onc e any of the d oors (or the r ear
g ate on the station wag on) is op ened , this func tion will b e c anc eled .
The interior lig ht must b e set to the middle position in ord er for this
func tion to op erate. Sounding a panic alarm
To ac tivate the alarm, keep the “LOCK/ARM ” b utton p ressed for more
than two seconds .
To d eac tivate it, p ress the “LOCK/ARM ” b utton or “UNLOCK/DISARM ”

Keys and doors2-9
–
CONTINUED –
b utton. Unless a b utton on the remote is p ressed , t
he alarm will b e
d eac tivated after ap p roximately 30 sec ond s. Selecting audible signal operation
Using the horn, the system will g ive you an aud ib le sig nal when the
d oors loc k and unloc k. If d esired , you may turn the aud ib le sig nal off.
To turn the aud ib le sig nal off, simultaneously d ep r ess “LOCK/ARM ”
and “UNLOCK/DISARM ” b uttons for more than two sec ond s. The horn
will sound two times to inform you that the aud ib le sig nal has b een
turned off.
To turn the aud ib le sig nal on, simultaneously d ep re ss “LOCK/ARM ”
and “UNLOCK/DISARM ” b uttons for more than two sec ond s. The horn
will sound one time to inform you that the aud ib le sig nal has b een
turned on. Replacing the battery
CAUTION
Do not let dust, oil or water get on or in the transmitter when
replacing the battery.
When the transmitter b attery b eg ins to g et weak, tr ansmitter rang e will
b eg in to d ec rease and the LED will not illuminate. Rep lac e the b attery
as soon as p ossib le.
HB1002BB
HB1001BA
Positive (+) side facing up
To rep lac e the b attery:
1. Remove the two sc rews on the b ac k of the transmit ter c ase b y

Keys and doors2-13
–
CONTINUED –
Security system (if equipped)
The sec urity system help s to p rotec t your vehic le a
nd valuab les from
theft. The horn sound s and the p arking lig hts flash if someone attemp ts
to b reak into your vehic le. The starter motor is al so interrup ted to p revent
starting the vehic le without a key.
The system c an b e armed and d isarmed with the remot e transmitter.
The system d oes not op erate when the key is inserte d into the ig nition
switc h.
System operation
The sec urity system will g ive the following alarm i nd ic ations when trig -
g ered : The p arking lig hts will flash and the horn will sou nd intermittently.
In ad d ition, the starter motor will not op erate. The alarm automatic ally resets after 30 sec ond s; ho wever, the
alarm will reac tivate if the vehic le is tamp ered wi th ag ain. The alarm
will c ontinue for twelve times if any sensor c ontin ues to b e ac tivated .
The alarm is trig g ered b y: Op ening a d oor, the rear g ate or trunk lid .
Ap p lic ation of p hysic al shoc k to the vehic le (e.g . b reaking g lass or
forc ed entry). Note that there are two alarm levels for shoc k: warning
and alarm. In warning mod e, the alarm d etec ts lower level vib rations
and trig g ers 2 warning c hirp s on the horn and two f lashes on the
lig hts as a d eterrent to would b e vand als. In alarm mod e, hig her lev-
els of shoc k are d etec ted and the system will g o in to full alarm.
Ig nition switc h b eing turned on while in armed stat e.

2-16To unloc k all d oors (and the rear g ate on the stati
on wag on), b riefly
p ress the “UNLOCK/DISARM ” b utton a sec ond time.
n Emergency disarming
If you c annot d isarm the system using the transmitt er (i.e. the trans-
mitter is lost, b roken or the transmitter b attery i s too weak), you c an
d isarm the system without using the transmitter.
To d isarm the system:
1. Unloc k the d oor with the key and then op en the d o or.
2. The alarm will sound .
3. Insert the key into the ig nition switc h and c yc le it from the “LOCK ”
to the “ON ” p osition three (3) times within 5 seconds.
Sounding a panic alarm
To ac tivate the alarm, keep the “LOCK/ARM ” b utton p ressed for more
than two seconds .
To d eac tivate it, p ress the “LOCK/ARM ” b utton or “UNLOCK/DISARM ”
b utton.
The p arking lig hts will also flash when the alarm i s ac tivated .
Unless a b utton on the remote is p ressed , the alarm will b e d eac ti-
vated after ap p roximately 30 sec ond s. Valet mode
When you c hoose the valet mod e, the sec urity system d oes not op er-
ate. In valet mod e, the remote transmitter is used only for loc king and
unloc king the d oors (and rear g ate on the station w ag on) and p anic
ac tivation.
To enter the valet mod e, op en the d river ’s d oor and keep the
“ UNLOCK/DISARM ” b utton d ep ressed for more than two seconds .
The ind ic ator lig ht rep eated ly flashes two times wh ile the system is in
valet mod e.
To exit valet mod e, op en the d river ’s d oor and keep the “UNLOCK/
DISARM ” b utton p ressed for more than two seconds. The ind ic ator
will stop flashing .

2-18n
Arming the system CAUTION
In passive mode, the system will automatically activate the alarm
but WILL NOT automatically lock the doors. In order to lock thedoors you must either lock them as indicated in step 4 below orwith the key once they have been closed. Failure to lock thedoors manually will result in a higher security risk.
HB2024DB
HB2031BB
1. Turn the ig nition switc h to the “ON ” p osition.
2. Turn the ig nition switc h from “ON ” to “LOCK ” p osition and remove
the key from the ig nition switc h.
3. Op en the d oors and g et out of the vehic le.
4. Before c losing the d oors, loc k all d oors with the insid e d oor loc k
levers.
5. Close the d oors. The system will automatic ally ar m after one min-
ute.
In the p assive mod e, the system c an also b e armed w ith the remote
transmitter or with the p ower d oor loc king switc hes . If the remote
transmitter or p ower d oor loc k switc h is used to lo c k the vehic le, arm-
ing will take p lac e immed iately reg ard less of wheth er or not the p as-
sive mod e has b een selec ted .

Keys and doors2-19
–
CONTINUED –

Disarming the system
To d isarm the system, b riefly p ress the “UNLOCK/DISARM ” b utton on
the transmitter. Tripped sensor identification
If the horn sound s four times and the p arking lig ht s flash four times
when you d isarm the system, this ind ic ates that the alarm was trig -
g ered . The numb er of times the ind ic ator lig ht flas hes ind ic ates what
sensor c aused the alarm c ond ition.
To enter id entific ation mod e:
1. Op en the d river ’s d oor and leave it op en.
2. Turn the ig nition switc h to the “ON ” p osition two times. ( “LOCK ” 
“ ON ”  “ LOCK ”  “ ON ”  “ LOCK ”)
3. The ind ic ator lig ht will start flashing .
The ind ic ator lig ht p rovid es the following ind ic ati ons.
Flashing one time: Any d oor, the rear g ate or the trunk lid has b een
op ened .
Flashing three times: The imp ac t sensor in the system ’s unit has
b een ac tivated . This may ind ic ate that your vehic le has b een shoc ked
or tamp ered with b y some outsid e forc e and /or unaut horized p erson.
Flashing four times: The ig nition switc h has b een turned on.
To exit this mod e, c lose the d oor and turn the ig ni tion switc h to the
“ ON ” p osition.

Starting and operating7-27
–
CONTINUED –
ind ic ator lig ht will flash on and off when this sys
tem ac tivates.
NOTE Slight twitching of the brake pedal may be felt when the VDC-sys-
tem operates; a small degree of vehicle or steering wheel shaking may also be noticed in this situation. These are normal effects of
VDC operation and are no cause for alarm. When driving off immediately after starting the engine, a short-
lived operation noise may be noticed coming from the enginecompartment. This noise is generated as a result of a check beingperformed on the VDC system and is normal. Depending on the timing of activation of the brakes, certain situa-
tions may occur just after driving off where the brake pedal seemsto exhibit a jolting motion. This too is a consequence of the VDCoperational check and is normal. Activation of the VDC system will cause operation of the steering
wheel to feel slightly different compared to that for normal condi-tions. Even if the vehicle is equipped with a VDC system, it is important
that winter tires be used when driving on snow-covered or icyroads. (All four wheels should be fitted with tires of the same sizeand brand). Furthermore, if snow chains are to be used, they shouldbe fitted on the front wheels. When a vehicle is fitted with snow
chains, however, the effectiveness of the VDC system is reduced
and this should be taken into account when driving the vehicle insuch a condition. It is always important to reduce speed when approaching a cor-
ner, even if the vehicle is equipped with VDC. All four wheels should be fitted with tires of the same size, type,
and brand; furthermore, the amount of wear should be the same for
all four tires. If these precautions are not observed and non-match-ing tires are used, it is quite possible that the VDC system will beunable to operate correctly as intended. Always turn off the engine before replacing a tire as failure to do
so may render the VDC system unable to operate correctly.