spare wheel SUBARU OUTBACK 2001 3.G Owners Manual

7-26
Whenever suspension components, steering components, or
an axle are removed from a vehicle equipped with VDC, have an authorized SUBARU dealer perform an inspection of that system. The following precautions should be observed in order to
ensure that the VDC system is operating properly:
–All four wheels should be fitted with tires of the same size,
type, and brand. Furthermore, the amount of wear should bethe same for all four tires.– Keep the tire pressure at the proper level as shown on the
label attached to the vehicle ’s door pillar.
– Use only the special temporary spare tire to replace a flat
tire.
When d riving on slip p ery road s or making sud d en tur ns to avoid
ob stac les in the vehic le ’s p ath, c ertain situations may oc c ur where the
vehic le may slip sid eways or where the rear of the vehic le may swing
outward . When the VDC system d etermines either of t hese c irc um-
stanc es is ab out to oc c ur, it c ontrols — and op erates in c onjunc tion with
— the Anti-loc k Brake System and the Trac tion Contro l System to sup -
p ress sud d en c hang es in vehic le attitud e and motion , thus imp roving
d irec tional stab ility d uring d riving .
Anti-loc k Brake System (ABS) func tion:
The ABS c ontrols the b rake system elec tronic ally. I t p revents loc king
of the wheels so that d irec tional stab ility and ste ering wheel resp on-
siveness c an b e maintained even when b raking on sli p p ery surfac es.
In the unlikely event that a malfunc tion should oc c ur in the ABS, it will
still b e p ossib le to stop the vehic le using normal b raking .
Trac tion Control System (TCS) func tion:
The TCS limits sp inning of the d rive wheels on slip p ery surfac es; in
this, it help s ensure that an ap p rop riate d eg ree of trac tion and steer-
ing are maintained . The VDC op eration ind ic ator lig ht will turn on
when the TCS ac tivates. Vehic le Dynamic s Control
To assist in maintaining d irec tional stab ility, the VDC help s sup p ress
sid eways slip p ing of the vehic le when the steering wheel is turned
sud d enly or when c ornering on a slip p ery surfac e. T he VDC op eration

9-4
HB8003BB
HG0106
Indicator location mark
Tread wear indicator bar
NOTE
[Automatic transmission vehicle not equipped with VDC (Vehicle Dy-
namics Control)] Before driving your vehicle with the temporaryspare tire, put a spare fuse inside the FWD connector located in theengine compartment and confirm that the Front-wheel drive warninglight comes on. The all wheel drive capability of the vehicle has now
been deactivated. After re-installing the conventional tire, removethe spare fuse from the FWD connector in order to reactivate allwheel drive.
Flat tires
WARNING
Do not jack up the vehicle on an incline or a loose road sur-
face. The jack can come out of the jacking point or sink into the ground and this can result in a severe accident. Use only the jack provided with your vehicle. The jack sup-
plied with the vehicle is designed only for changing a tire. Neverget under the vehicle while supporting the vehicle with this jack. Always turn the engine off before raising the flat tire off the
ground using the jack. Never swing or push the vehicle sup-ported with the jack. The jack can come out of the jacking pointdue to a jolt and this can result in a severe accident.

In case of emergency9-5
–
CONTINUED –

Do not use oil or grease on the wheel studs or nuts when the
spare tire is installed. This could cause the nuts to become loose and lead to an accident. Never place a tire or tire changing tools in the passenger
compartment after changing wheels. In a sudden stop or colli-
sions, loose equipment could strike occupants and cause injury.Store the tire and all tools in the proper place.
If you have a flat tire while d riving , never b rake sud d enly; keep d riving
straig ht ahead while g rad ually red uc ing sp eed . Then slowly p ull off the
road to a safe p lac e.
1. Park on a hard , level surfac e, whenever p ossib le, then stop the en-
g ine.
2. Set the p arking b rake sec urely and shift a manual transmission ve-
hic le in reverse or an automatic transmission vehic le in the “P ” (Park)
p osition.
3. Turn on the hazard warning flasher and have every one g et out of the
vehic le.
4. Put wheel b loc ks at the front and rear of the tir e d iag onally op p osite
the flat tire.
OM-H2259
Jacking position
Wheel blocks

9-6
5. Take out the sp are tire, jac k, and wheel nut wren
c h.
HB6008BCHB9003BB
HS0252
Temporary spare tire
HBF015CB
Jack handle
Jack
Spare tireHB8004BD
The sp are tire is stored und er the floor of the tru nk or c arg o area.
To remove the sp are tire, p roc eed as follows: Sedan: Remove the floor c over from the trunk. Remove the storag e tray.
Turn the attac hing b olt c ounterc loc kwise, then take the sp are tire out.
Station wagon: Op en the lid and hang the hook p rovid ed on the und er-

In case of emergency9-27
–
CONTINUED –
Sc rewd river
Wheel nut wrenc h
Hex-head ed wrenc h (for vehic les with moonroof)
Jack and jack handle
HB9001BA
HBF015CB
Jack handle
Jack
Spare tire
HB7008CA
HB8004BD
The jac k is stored on the left sid e of the trunk or c arg o area.
To take out the jac k, turn the jac ksc rew c ounterc lo c kwise to loosen it,
then remove the jac k.
The jac k hand le is stored und er the sp are tire c ove r.
For how to use the jac k, refer to “Flat tires ”.