tow bar SUBARU OUTBACK 2012 5.G Quick Reference Guide
Page 5 of 33
3
Getting
StartedInstrument
PanelGaugesPersonalize Controls While
OperatingSafety / In Case
of EmergencyAdditional
Information
3
Getting
Started
Seating
10-Way Power Driver’s Seat
(if equipped)
1. Forward/Backward, Angle and Height
Move the switch toward the front or rear to move
the seat forward or backward. Pull the switch up
or push down on the front of the switch to adjust
the angle of the seat cushion. Pulling the switch
straight up or pushing the switch straight down
will adjust the height of the entire seat cushion.
2. Seatback
Move the switch in the corresponding direction
to adjust the angle of the seatback.
3. Lumbar Support
Press the front part of the switch to increase
lumbar support; press the rear part of the switch
to decrease lumbar support.
Heated Seats
(if equipped)
Press the switch in the
corresponding direction for
the desired seat temperature.
To turn off the seat heater,
slightly press in the opposite
direction of the current position.
Folding the
Rear Seat
Pull up on the release lever on
the seat side that you want
to fold down. To return the
seatback to its original position,
raise the seatback until it locks
into place making sure that it is
securely locked.
InsItrument
Panel
GauG
ges
PerP
son
alilize
ConC
trotlsl
WhiWhi
le l
Operatin
g
SafSf
etyt / /In ICasC
e
of Emergenc
y
AddAdd
itiiional l
Informatio
n
33
Get
ting
Get
ting
Starte
d
Started
ove
up
just
ch
wn
n.
on
tch
Getting
Started
3
2
1
939416_12a_Subaru_Outback_QRG_082211b.indd 38/22/11 4:32 PM
Page 13 of 33
11
Getting
StartedInstrument
PanelGaugesPersonalize Controls While
OperatingSafety / In Case
of EmergencyAdditional
Information
11
GetGt
tintig
Starte
d
InsItrument
Panel
GauG
ges
PerP
son
alilize
Con
trols
WhiWhi
le l
Operatin
g
SafSf
etyt / /In ICasC
e
of Emergenc
y
AddAdd
itiiional l
Informatio
n
Controls
Windshield Wipers
To turn on the wipers, press the wiper control lever down
one level for intermittent, two levels for low, or three levels for
I J H I T Q F F E 3 F U V S O U I F M F W F S U P U I F i 0 ' ' w Q P T J U J P O U P T U P Q
the wipers. For a single wipe, move the lever up. To spray
washer fluid, pull and hold the lever toward you.
To operate the rear wiper, rotate the end of the knob upward
to the intermittent, continuous, or wash position. When the
rear wiper is off, rotate the knob downward to wash and
wipe the rear window.
Daytime Running Lights
Daytime running lights are standard on your vehicle. Only a
reduced brightness high beam will be automatically turned
on when the engine has started and the parking brake is
G V M M Z S F M F B T F E B O E U I F M J H I U T X J U D I J T J O U I F i 0 ' ' w P S i
w
position. The brightness of the illumination of the high beam
headlights is reduced by the daytime running light system.
You must always switch on your headlights when it’s dark
outside by turning the light switch to the
position.
1
2
3
INT.
LOW
HIGHOFF
939416_12a_Subaru_Outback_QRG_082211b.indd 118/22/11 4:33 PM
Page 24 of 33
2222
While Operating
Electronic Parking Brake
To apply, push the brake pedal and press the parking brake switch
firmly. The brake system warning light on the instrument panel and the
indicator light on the parking brake switch will illuminate.
To release, make sure all doors are closed and your seatbelt is fastened,
then gently push the accelerator pedal. Or, while the ignition switch is in
<00550049004600010030002f0001005100500054004a0055004a0050004f00010042004f004500010055004900460001004300530042004c004600010051004600450042004d00010042004f0045000100550049004600010044004d005600550044004900
010051004600450042004d00010009002e00350001004e0050>