09952-06020 SUZUKI SWIFT 2000 1.G Transmission Service Workshop Manual

AUTOMATIC TRANSMISSION (4 A/T) 7B-127
36) Inspect reverse brake (B2) piston stroke and clearance by
blowing compressed air into hole (4) shown in figure.
Make sure that the obtained piston stroke and clearance sat-
isfy the standard value.
Set dial gauge (1) to the top of reverse brake (B2) flange and
blow compressed air into the hole shown in figure.
Reverse brake disc clearance
Standard : 0.79 – 1.69 mm (0.031 – 0.067 in.)
Set special tool (B) on the tip of dial gauge and place the
other end of special tool on the claw of reverse brake (B2)
piston. Blow compressed air into the hole (4) shown in figure
and measure the value for piston stroke.
Reverse brake piston stroke
Standard : 1.77 – 2.59 mm (0.070 – 0.102 in.)
Special tool
(B) : 09952-06020
37) Apply grease to thrust washers (1) and install them to follow
shaft (2).
“A” : Grease 99000-25030 NOTE:
If clearance and/or piston stroke is out of specification,
disassemble reverse brake (B2) discs and plates, rein-
stall them to satisfy the measured values to standard
value.
2. Tip of dial gauge on the top of B2 brake flange
3. Air gun
[A] : Clearance
[B] : Piston Stroke
NOTE:
When installing thrust washers, make sure that the pro-
trusions of thrust washer do not interfere with the ones
of the other side.

7B-138 AUTOMATIC TRANSMISSION (4 A/T)
09926-96030 09926-96040 09930-30102 09931-76030
Clutch spring compressor
No.7Clutch spring compressor
No.8Sliding shaft 16/14 pin DLC adapter
09931-76011 09941-64511 09944-68510 09951-16060
Tech 1A kit
See NOTE below.Bearing remover Bearing installer Bush remover
09952-06010 09952-06020 09926-26050
Dial gauge plate No.1 Dial gauge plate No.2 Mass storage cartridge Air installer No.3
09940-53111
Oil seal install tool