radio SUZUKI SWIFT 2017 5.G Owner's Manual

Page 215 of 336

7-24
INSPECTION AND MAINTENANCE
74LH0-74E
81A283
Bulb Replacement
(16) – Blank
(17) 15 A Horn
(18) 10 A Stop light
(19) 10 A Air bag
(20) 10 A Back-up light
(21) 15 A Rear wiper / Washer
(22) 25 A Front wiper
(23) 7.5 A Dome light
(24) – Blank
(25) 7.5 A RR fog lamp
(26) – Blank
(27) 7.5 A Ignition-1 signal
(28) 15 A Radio 2
(29) – Blank
(30) 15 A Radio
(31) 10 A Tail lamp
(32) 20 A D/L
(33) – Blank
(34) 10 A Meter
(35) 7.5 A Ignition-2 signal
(36) – Blank
WA R N I N G
Always be sure to replace a blown
fuse with a fuse of the correct amper-
age. Never use a substitute such as
aluminum foil or wire to replace a
blown fuse. If you replace a fuse and
the new one blows in a short period
of time, you may have a major electri-
cal problem. Have your vehicle
inspected immediately by your MAR-
UTI SUZUKI dealer.
OK
BLOWN
WA R N I N G
Light bulbs can be hot enough to
burn your finger right after being
turned off. This is true especially
for halogen headlight bulbs.
Replace the bulbs after they
become cool enough.
The headlight bulbs are filled with
pressurized halogen gas. They can
burst and injure you if they are hit
or dropped. Handle them carefully.
NOTICE
The oils from your skin may cause a
halogen bulb to overheat and burst
when the lights are on. Grasp a new
bulb with a clean cloth.
NOTICE
Frequent replacement of a bulb indi-
cates the need for an inspection of
the electrical system. This should be
carried out by your MARUTI SUZUKI
dealer.
Battery: 9
Fuses: 7

Page 239 of 336

GENERAL INFORMATION
GENERAL INFORMATIONVehicle Identification .......................................................... 10-1
Radio frequency identification (RFID) tag ........................ 10-2
10
74LH0-74E

Page 241 of 336

10-2
GENERAL INFORMATION
74LH0-74E
Radio frequency identification
(RFID) tag As per Ministry of Road Transport and
Highways, the Radio frequency identifica-
tion (RFID) tag (1) is mandatory for each
vehicle for the purpose of electronic toll
collection or any other purpose as may be
defined by the Government of India.
In case of any damage to RFID tag or
replacement of front windscreen, please
contact your nearest MARUTI SUZUKI
Authorized workshop.
74LHM1001
As seen from inside of the vehicle
74LHM1002
NOTE:
The picture shown is for indicative purpose
only. Internal structure of actual device
mounted on vehicle may be different.
As seen from outside of the vehicle
74LHM1003
NOTE:
The picture shown is for indicative purpose
only. Internal structure of actual device
mounted on vehicle may be different.
NOTE:
RFID tag needs to be registered by gov-
ernment authorized agency (if applica-
ble).
Any attempt to remove the tag from the
windscreen will result in permanent dam-
age to the tag.
Use of chemical cleaners to clean the
windscreen area where the tag is
mounted can damage the tag.
Use of any sharp objects on the tag can
damage the tag.
(1)
EXAMPLE
EXAMPLE
EXAMPLE

Page:   < prev 1-10 11-20 21-30