change wheel TOYOTA 4RUNNER 1998 Owners Manual

Page 65 of 350

4RUNNER (1998)
NOTICE
Do not perform any of the follow-
ing changes without consultingyourToyota dealer. Such changes can
interfere with proper operation ofthe SRS airbag system in somecases.
Installation of electronic itemssuch as a mobile two- way ra- dio, cassette tape player or
compact disc player
Modification of the suspensionsystem
Modification of the front endstructure
Attachment of a grille guard(bull bar, kangaroo bar, etc.),
snowplow, winches or any otherequipment to the front end
Repairs made on or near thefront end structure, console, steering column, steering wheel
or dashboard near the frontpassenger airbag

Page 101 of 350

4RUNNER (1998)
To change the steering wheel angle,
hold the steering wheel, pull up the
lock release lever, tilt the steering
wheel to the desired angle and re-
lease the lever.
When the steering wheel is in a low
position, it will spring up as you re-
lease the lock release lever.
CAUTION
Do not adjust the steering
wheel while the vehicle is mov-
ing.
After adjusting the steering
wheel, try moving it up and
down to make sure it is locked
in position.
Outside rear view mirrorsÐ

Page 242 of 350

4RUNNER (1998)
When driving your vehicle off- road,
please observe the following precau-
tions to ensure your driving enjoyment
and to help prevent the closure of
areas to off- road vehicles.
a. Drive your vehicle only in areas
where off- road vehicles are permitted
to travel.
b. Respect private property. Get own-
er's permission before entering private
property.
c. Do not enter areas that are closed.
Honor gates, barriers and signs that
restrict travel.
d. Stay on established roads. When
conditions are wet, driving techniques
should be changed or travel delayed
to prevent damage to roads.
For owners in U.S. mainland, Hawaii
and Puerto Rico:
To obtain additional information per-
taining to driving your vehicle off-
road, consult the following organiza-
tions. State and Local Parks and Recre-
ation Departments
State Motor Vehicle Bureau
Recreational Vehicle Clubs
U.S. Forest Service and Bureau of
Land Management
CAUTION
Always observe the following pre-
cautions to minimize the risk of
serious personal injury or damage
to your vehicle: Drive carefully when off the
road. Do not take unnecessary
risks by driving in dangerous
places.
Do not grip the steering wheel
spokes when driving off- road. A
bad bump could jerk the wheel
and injure your hands. Keep
both hands and especially your
thumbs on the outside of the
rim.
Always check your brakes for
effectiveness immediately after
driving in sand, mud, water or
snow.
After driving through tall grass,
mud, rock, sand, rivers, etc.,
check that there is no grass,
bush, paper, rags, stone, sand,
etc. adhering or trapped on the
underbody. Clear off any such
matter from the underbody. If
the vehicle is used with these
materials trapped or adhering to
the underbody, a breakdown or
fire could occur.Off- road driving precaution

Page 262 of 350

4RUNNER (1998)
Stop the vehicle on a level firm
ground, firmly set the parking
brake and put the transmission
in ºPº (automatic) or reverse
(manual). Block the wheel diag-
onally opposite to the one be-
ing changed if necessary.
Make sure to set the jack prop-
erly in the jack point. Raising
the vehicle with jack improperly
positioned will damage the ve-
hicle or may allow the vehicle
to fall off the jack and cause
personal injury.
Never get under the vehicle
when the vehicle is supported
by the jack alone.
Use the jack only for lifting
your vehicle during wheel
changing.
Do not raise the vehicle with
someone in the vehicle.
When raising the vehicle, do
not put an object on or under
the jack.
Raise the vehicle only high
enough to remove and change
the tire.NOTICE
Do not continue driving with a
deflated tire. Driving even a shortdistance can damage a tire be-yond repair.
ÐRequired tools and spare
tire

Page 270 of 350

4RUNNER (1998)
6. After making sure that no one is
in the vehicle, raise it high
enough so that the spare tire
can be installed.
Remember you will need more ground
clearance when putting on the spare
tire than when removing the flat tire.
To raise the vehicle, insert the jack
handle extension in to the jack (it is
a loose fit) and turn it clockwise with
the handle, making sure the handle
remains firmly fitted onto the jack
handle extension. As the jack touches
the vehicle and begins to fit, double-
check that it is properly positioned.
CAUTION
Never get under the vehicle when
the vehicle is supported by the
jack alone.
ÐChanging wheels
7. Remove the wheel nuts and change tires.
Lift the flat tire straight off and put it
aside.

Page 294 of 350

4RUNNER (1998)
Tire surface and wheel nuts
Check the tires carefully for cuts,
damage or excessive wear. See Chap-
ter 7- 2 for additional information.
When checking the tires, make sure
no nuts are missing, and check the
nuts for looseness. Tighten them if
necessary.
Tire rotation
Rotate the tires every 12000 km (7500
miles). See Chapter 7- 2 for additional
information.
Fluid leaks
Check underneath for leaking fuel, oil,
water or other fluid after the vehicle
has been parked for a while. If you
smell fuel fumes or notice any leak,
have the cause found and corrected
immediately.
Doors and engine hood
Check that all doors including back
door operate smoothly and all latches
lock securely. Make sure the engine
hood secondary latch secures the
hood from opening when the primary
latch is released. INSIDE THE VEHICLE
Items listed below should be
checked regularly, e.g. while per-
forming periodic services, cleaning
the vehicle, etc.
Lights
Make sure the headlights, stop lights,
tail lights, turn signal lights, and other
lights are all working. Check headlight
aim.
Service reminder indicators and
warning buzzers
Check that all service reminder indica-
tors and warning buzzers function
properly.
Steering wheel
Check that it has the specified free-
play. Be alert for changes in steering
condition, such as hard steering or
strange noise.
Seats
Check that all seat controls such as
seat adjusters, seatback recliner, etc.
operate smoothly and that all latches
lock securely in any position. Check
that the head restraint move up and
down smoothly and that the locks hold
securely in any latched position. For
folding- down rear seatbacks, swing- up
rear seat cushions and detachable
temporary third seat, check that the
latches lock securely.Seat belts
Check that the seat belt system such
as buckles, retractors and anchors op-
erate properly and smoothly. Make
sure the belt webbing is not cut,
frayed, worn or damaged.
Accelerator pedal
Check the pedal for smooth operation
and uneven pedal effort or catching.
Clutch pedal
Check the pedal for smooth operation.
Brake pedal
Check the pedal for smooth operation
and that the pedal has the proper
clearance. Check the brake booster
function.
Brakes
At a safe place, check that the brakes
do not pull to one side when applied.
Parking brake
Check that the lever has the proper
travel and that, on a safe incline, your
vehicle is held securely with only the
parking brake applied.

Page 316 of 350

4RUNNER (1998)
CAUTION
Do not mix radial, bias belted,
or bias- ply tires on your ve-
hicle. It can cause dangerous
handling characteristics, result-
ing in loss of control.
Do not use tires or wheels oth-
er than the manufacture's rec-
ommended size.
Toyota recommends all four tires,
or at least both of the front or rear
tires be replaced at a time as a set.
See ºIf you have a flat tireº in Part
4 for tire change procedure.
When a tire is replaced, the wheel
should always be balanced.
An unbalanced wheel may affect ve-
hicle handling and tire life. Wheels
can get out of balance with regular
use and should therefore be balanced
occasionally.
When replacing a tubeless tire, the
air valve should also be replaced
with a new one. Rotating tires

Page 317 of 350

4RUNNER (1998)
To equalize tire wear and help ex-
tend tire life, Toyota recommends
that you rotate your tires approxi-
mately every 12000 km (7500 miles).
However, the most appropriate tim-
ing for tire rotation may vary ac-
cording to your driving habits and
road surface conditions.
See ºIf you have a flat tireº in Part
4 for tire change procedure.
When rotating tires, check for uneven
wear and damage. Abnormal wear is
usually caused by incorrect tire pres-
sure, improper wheel alignment, out-
of- balance wheels, or severe braking. WHEN TO USE SNOW TIRES OR
CHAINS
Snow tires or chains are recom-
mended when driving on snow or
ice.
On wet or dry roads, conventional
tires provide better traction than snow
tires.
SNOW TIRE SELECTION
If you need snow tires, select the
same size, construction and load
capacity as the original tires on
your Toyota.
Do not use tires other than those
mentioned above. Do not install
studded tires without first checking lo-
cal regulations for possible restric-
tions.SNOW TIRE INSTALLATION
Snow tires should be installed on
all wheels.
Installing snow tires on the front
wheels only can lead to an excessive
difference in road grip capab
ility be-
tween the front and rear tires which
could cause loss of vehicle control.
When storing removed tires, you
should store them in a cool dry place.
Mark the direction of rotation and be
sure to install them in the same direc-
tion when replacing.
Installing snow tires
and chains

Page 319 of 350

4RUNNER (1998)
Replacement with used wheels is not
recommended as they may have been
subjected to rough treatment or high
mileage and could fail without warning.
Also, bent wheels which have been
straightened may have structural dam-
age and therefore should not be used.
Never use an inner tube in a leaking
wheel which is designed for a tube-
less tire. Aluminum wheel precautions
After driving your vehicle the first
1600 km (1000 miles), check that
the wheel nuts are tight.
If you have rotated, repaired or
changed your tires, check that the
wheel nuts are still tight after driv-
ing 1600 km (1000 miles).
When using tire chains, be careful
not to damage the aluminum
wheels.
Use only the Toyota wheel nuts
and wrench designed for your alu-
minum wheels.
When balancing your wheels, use
only Toyota balance weights or
equivalent and a plastic or rubber
hammer.
As with any wheel, periodically
check your aluminum wheels for
damage. If damaged, replace im-
mediately.