navigation system TOYOTA AVALON 2007 XX30 / 3.G Navigation Manual

liii
When your vehicle is not receiving signals
from the satellites, the “GPS” mark does
not appear at the screen.
The GPS signal may be physically ob-
structed, leading to inaccurate vehicle
position on the map display. Tunnels, tall
buildings, trucks, or even the placement of
objects on the instrument panel may ob-
struct the GPS signals.
The GPS satellites may not send signals
due to repairs or improvements being
made to them.
Even when the navigation system is re-
ceiving good GPS signals, the vehicle
position may not be shown accurately or
inappropriate route guidance may occur in
some cases.
NOTICE
The installation of window tinting may
obstruct the GPS signals. Most win-
dow tinting contains some metallic
content that will interfere with GPS
signal reception. We advise against
the use of window tinting on vehicles
equipped with navigation systems.
When driving on a small angled Y−
shaped road.
When driving on a spiral road.
When driving on a slippery road such
as in sand, gravel, snow, etc.
When driving on a long straight road.
When freeway and surface streets run
in parallel.
After moving by ferry or vehicle carrier.
When a long route is searched during
high speed driving.
When driving without setting the current
position calibration correctly.
After repeating a change of directions
by going forward and backward, or
turning on a turntable in the parking
lot.
When leaving a covered parking lot or
parking garage.
When a roof carrier is installed.
When driving with the tire chains
installed.
When the tires are worn.
After replacing a tire or tires.
(a) Accurate current vehicle
position may not be shown in
the following cases:

liv
When using tires that are smaller or
larger than the factory specifications.
When the tire pressure in any of the
four tires is not correct.
INFORMATION
If your vehicle cannot receive GPS
signals, you can correct the current
position manually. For the information
on setting the current position cal-
ibration, see page xc.
When turning at a wrong intersection
off the designated route guidance.
If you are heading for a destination
without passing through a set preferred
road, automatic rerouting may display
a route returning to the set preferred
road.
When turning at an intersection for
which there is no route guidance.
When passing through an intersection
for which there is no route guidance.
During automatic rerouting, the route
guidance may not be available for the
next turn to the right or left.
It may take a long time to operate
automatic rerouting during high speed
driving. In automatic rerouting, a detour
route may be shown.
During automatic rerouting, the route
may not be changed.
The route in a U−turn may be shown
or announced.
A location may have multiple names
and the system will announce one or
more.
Some routes may not be searched.
If the route to your destination includes
gravel, unpaved roads or alleys, the
route guidance may not be shown.
Your destination point might be shown
on the opposite side of the street.
When a portion of the route has regu-
lations prohibiting the entry of the ve-
hicle that vary by time or season or
other reasons.
The road and map data stored in your
navigation system may not be complete
or may not be the latest release.
After replacing the tire, implement the
operation described in the “Current
position calibration”. (For details, see
page xc.)
This navigation system uses tire turning
data and is designed to work with factory−
specified tires for your Toyota. Installing
tires that are larger or smaller than the
originally equipped diameter may cause
inaccurate display of the vehicle’s posi-
tion. The tire pressure also affects the
diameter of the tires so please make sure
the tire pressure of all four tires is cor-
rect.
(b) Inappropriate route
guidance may occur in the
following cases:

lvi
TERMS AND CONDITIONS
Personal Use Only. You agree to use
this Data together with the navigation
system for the solely personal, non−
commercial purposes for which you
were licensed, and not for service bu-
reau, time−sharing or other similar
purposes. Accordingly, but subject to
the restrictions set forth in the follow-
ing paragraphs, you may copy this
Data only as necessary for your per-
sonal use to (i) view it, and (ii) save
it, provided that you do not remove
any copyright notices that appear and
do not modify the Data in any way.
You agree not to otherwise reproduce,
copy, modify, decompile, disassemble
or reverse engineer any portion of this
Data, and may not transfer or distrib-
ute it in any form, for any purpose,
except to the extent permitted by
mandatory laws. Data provided in
multi−disc sets may not be transferred
or sold on a divided or single disc
basis.Restrictions.
Except where you have
been specifically licensed to do so by
[CLIENT], and without limiting the pre-
ceding paragraph, you may not (a)
use this Data with any products, sys-
tems, or applications installed or
otherwise connected to or in commu-
nication with vehicles, capable of ve-
hicle navigation, positioning, dispatch,
real time route guidance, fleet man-
agement or similar applications; or (b)
with or in communication with any
positioning devices or any mobile or
wireless−connected electronic or com-
puter devices, including without limita-
tion cellular phones, palmtop and
handheld computers, pagers, and per-
sonal digital assistants or PDAs.
Warning
. The Data may contain inac-
curate or incomplete information due
to the passage of time, changing cir-
cumstances, sources used and the
nature of collecting comprehensive
geographic data, any of which may
lead to incorrect results.
No Warranty. This Data is provided
to you “as is,” and you agree to use
it at your own risk. [CLIENT] and its
licensors (and their licensors and sup-
pliers) make no guarantees, represen-
tations or warranties of any kind, ex-
press or implied, arising by law or
otherwise, including but not limited to,
content, quality, accuracy, complete-
ness, effectiveness, reliability, fitness
for a particular purpose, usefulness,
use or results to be obtained from
this Data, or that the Data or server
will be uninterrupted or error−free.
Disclaimer of Warranty:
[CLIENT] AND
ITS LICENSORS (INCLUDING THEIR
LICENSORS AND SUPPLIERS) DIS-
CLAIM ANY WARRANTIES, EXPRESS
OR IMPLIED, OF QUALITY, PER-
FORMANCE, MERCHANTABILITY, FIT-
NESS FOR A PARTICULAR PUR-
POSE OR NON−INFRINGEMENT.
Some States, Territories and Countries
do not allow certain warranty exclu-
sions, so to that extent the above
exclusion may not apply to you.

lix
LIMITED RIGHTS NOTICE
(JUN 1987)
These data are submitted with limit-
ed rights under Government Con-
tract No. _____ (and subcontract
______, if appropriate). These data
may be reproduced and used by the
Government with the express limita-
tion that they will not, without writ-
ten permission of the Contractor, be
used for purposes of manufacture
nor disclosed outside the Govern-
ment; except that the Government
may disclose these data outside the
Government for the following pur-
poses, if any, provided that the
Government makes such disclosure
subject to prohibition against further
use and disclosure: There are no
additional purposes permitting dis-
closure of such Data.
The manufacturer/supplier of the
Data is NAVTEQ, 222 Merchandise
Mart Plaza, Suite 900, Chicago, Illi-
nois 60654.If the Contracting Officer refuses to
use either of the licenses provided in
(i) or (ii), herein, the Contracting Offi-
cer must notify NAVTEQ North Ameri-
ca, LLC prior to seeking additional or
alternative rights in the NAVTEQ Data.
END USER LICENSE AGREEMENT
PLEASE READ THIS AGREEMENT
CAREFULLY BEFORE USING THE
NAVIGATION SYSTEM
THIS IS A LICENSE AGREEMENT
FOR YOUR COPY OF THE SPATIAL
MAP DATABASE, INCLUDING LOCA-
TION CODES AND RELATED PROD-
UCTS (COLLECTIVELY, THE “DATA-
BASE”), USED IN THE NAVIGATION
SYSTEM. BY USING THE NAVIGA-
TION SYSTEM AND THE DATABASE,
YOU ACCEPT AND AGREE TO BE
BOUND BY ALL TERMS AND CON-
DITIONS SET FORTH BELOW.LICENSE GRANT
Denso Corporation (“Denso”), as a li-
censed distributor of the DATABASE,
grants to you a non−exclusive, non−
perpetual license to use your copy of
the DATABASE for your personal use
or for your use in your business’ in-
ternal operations and not for any other
purpose. This license does not in-
clude the right to grant sub−licenses.
OWNERSHIP
The DATABASE and the copyrights
and intellectual property and neighbor-
ing rights therein are owned by Tele
Atlas North America, Inc. (“TANA”)
and its licensors. This Agreement
does not transfer any title or interest
in the DATABASE, except for the li-
cense to use the DATABASE accord-
ing and subject to the terms and con-
ditions of this Agreement. You shall
not alter, obscure or remove any
copyright notices, trademark notices
or other restrictive legends relating to
the DATABASE.

lxii
If you are an agency, department, or
other entity of any State government,
the United States Government or any
other public entity or funded in whole
or in part by the United States Gov-
ernment, then you hereby agree to
protect the DATABASE from public
disclosure and to consider the DATA-
BASE exempt from any statute, law,
regulation, or code, including any Sun-
shine Act, Public Records Act, Free-
dom of Information Act, or equivalent,
which permits public access and/or re-
production or use of the Licensed
Products. In the event that such ex-
emption is challenged under any such
laws, this Agreement shall be consid-
ered breached and any and all right
to retain any copies or to use of the
DATABASE shall be terminated and
considered immediately null and void.
Any copies of the DATABASE held by
you shall immediately be destroyed.
If any court of competent jurisdiction
considers this clause void and unen-
forceable, in whole or in part, for any
reason, this Agreement shall be con-
sidered terminated and null and void,
in its entirety, and any and all copies
of the DATABASE shall immediately
be destroyed.
END USER NOTICE
PLEASE READ THIS NOTICE CARE-
FULLY BEFORE USING THIS NAV-
IGATION SYSTEM
The Point Of Interest Data (“POI”
Data) in the navigation system is in
part provided by infoUSA Inc. (“in-
foUSA”). By using the POI Data,
you accept and agree to all terms
and conditions set forth below.
1. OWNERSHIP
All rights, title and interest to the in-
foUSA POI Data shall be retained by
infoUSA.
2. LIMITATIONS ON USE
Except to the extent explicitly per-
mitted by mandatory laws, you may
not extract or reutilize any portion of
the contents of the POI Data, nor re-
produce, copy, modify, adapt, trans-
late, disassemble, decompile, or re-
verse engineer any portion of the POI
Data.

lxxxix
CHANGING THE LOCATION
Move the cursor to your desired point,
and push the
“ENTER” button of the
navigation controller.CHANGING THE AREA SIZE
Select one of the “detour gauge” on the
left side of this screen if you want to
change the area size.1. Select the
“Delete” switch of the
“Area to avoid” to display the “De-
lete area to avoid” screen.
2. Select the area you want to delete
from the list.
“Delete all”: All registered areas to avoid
in the system are deleted.
3. Messages appear depending on the
type of deletion. If you want to de-
lete, select the
“Yes” switch. To
cancel the deletion, select the
“No”
switch.
(c) Deleting area to avoid

xc
The current vehicle position mark will
be automatically corrected while driving
on reception of GPS signals. If your
vehicle cannot receive GPS signals, you
can correct the current position mark
manually.
1. Push the “MENU” button on the
navigation controller to display the
“Menu” screen, and then select the
“Setup” switch.
2. Select the “Calib.” switch on the
right side of the screen.
The next screen appears.3. Select the “Position/Direction”
switch.
INFORMATION
For additional information on current
position accuracy, see “Limitations of
the navigation system” on page lii.
Current position calibration

cii
You can set the values shown on the
“Setup” screen.
1. Select the
“MENU” button on the
navigation controller.
2. Select the “Setup” switch to dis-
play the “Setup” menu screen. Se-
lect items you want to set. Selected
items will be highlighted in green.
3. Select the “OK” switch on the
screen and then the previous screen
will be displayed.
“Default”: Select the
“Default” switch
on the right side of the screen. All of the
settings can be defaulted.
“Map color” (day or night): You can se-
lect your desired map color.
“Auto reroute”: You can set the system
will or will not automatically search for a
new route to the destination.
“Estimated travel time”: You can set to
display the time required to reach the des-
tination on the route guidance screen.
“Adjust time zone”: You can select your
desired time zone.
“Distance”: You can change
“km” or
“miles” to display your desired units.“Notify seasonal restrict”: You can se-
lect to notify or not to notify a seasonal
restrict.
“Voice guide in all modes”: You can set
the voice guide in all modes or not.
“Current street name”: You can select to
show or not to show a current street
name on the map screen.
“Operation guide on map”: Display or
non−display of the operation guide on the
display can be selected.
Setup

ciii
1. Push the “MENU” button on the
navigation controller.
2. Select the “Setup” switch.
3. Select your desired day and/or night
map color and then select the
“OK” switch to return the map
screen.
Select the
“Normal” switch to default
the map color.
Select the
“Auto” switch to select the
map color automatically.
When you select the
“Auto” switch, the
map color is changed in every three
month.When the “Auto reroute” feature is
turned on, the system will automatically
search for a new route to the destina-
tion if you leave the guidance route.
This feature does not operate while you
are driving on roads where the guid-
ance is not available.
To turn the “Auto reroute” mode on:
1. Push the
“MENU” button on the
navigation controller.
2. Select the “Setup” switch.
Map color Automatic rerouting

civ
3. Select the “On” switch of “Auto
reroute”.
Selected switch is highlighted in green.
INFORMATION
If your vehicle leaves the guidance
route, the system searches for a new
route to the destination. The new
route may or may not take you back
to the previous route depending on
how far you are off the original guid-
ance route.
When the “Estimated travel time” fea-
ture is turned on, the time estimated to
reach the destination is displayed on
the route guidance screen.
To turn the “Estimated travel time”
mode on:
1. Push the
“MENU” button on the
navigation controller.
2. Select the “Setup” switch.
3. Select the “Change speed”
switch on the “Setup” screen.
Time to destination