Halogen TOYOTA AVALON 2015 XX40 / 4.G Owners Manual

Page 174 of 500

1744-3. Operating the lights and wipers
AVALON (U)_(OM41456U)
■Daytime running light system
●Vehicles with halogen headlights: To make your vehicle more visible to other
drivers, the headlight high beam turn on automatically (at a decreased inten-
sity) whenever the engine is started and the parking brake is released. Day-
time running lights are not designed for use at night.
Vehicles with discharge headlights: To make your vehicle more visible to
other drivers, the parking lights turn on automatically (at an increased inten-
sity) whenever the engine is started and the parking brake is released. Day-
time running lights are not designed for use at night.
Type A: Daytime running lights can be turned off by operating the switch.
● Compared to turning on the headlights, the daytime running light system
offers greater durability and consumes less electricity, so it can help improve
fuel economy.
■ Headlight control sensor
■ Automatic light off system
●When the headlights are on: The headlights and tail lights turn off 30 sec-
onds after the engine switch is turned off and a door is opened and all of the
doors and trunk are closed. (The lights turn off immediately if on the
key is pressed twice after all the doors are closed.)
● When only the tail lights are on: The tail lights turn off automatically if the
engine switch is turned off and the driver’s door is opened.
To turn the lights on again, turn the engine switch to IGNITION ON mode, or
turn the light switch off once and then back to or .
If any of the doors or trunk lid is kept open, the lights automatically turn off
after 20 minutes.
■ Light reminder buzzer
A buzzer sounds when the engine switch is turned off or turned to ACCES-
SORY mode and the driver’s door is opened while the lights are turned on. The sensor may not function properly if an
object is placed on the sensor, or anything
that blocks the sensor is affixed to the
windshield.
Doing so interferes with the sensor
detecting the level of ambient light and
may cause the automatic headlight sys-
tem to malfunction.

Page 356 of 500

3566-3. Do-it-yourself maintenance
AVALON (U)_(OM41456U)
*1:Vehicles with discharge headlight low beam
*2:Vehicles with halogen headlight low beam
27 EFI-MAIN NO.1 30 A EFI NO.2, EFI NO.3, A/F sensor
28 SMART 5 A No circuit
29 ETCS 10 A Electronic throttle control system
30 TOWING 20 A No circuit
31 EFI NO.1 7.5 A
Multiport fuel injection system/sequential
multiport fuel injection system, electronic
controlled transmission
32 A/F 20 A A/F sensor
33 AM2 7.5 A Smart key system
34 RADIO-B 20 A Audio system, navigation system
35 DOME 7.5 A Vanity lights, personal/interior lights,
trunk light, door courtesy lights, illumi-
nated entry system,
ambient light
36 ECU-B NO.1 10 AMultiplex communication system, smart
key system, gauge and meters, starter
system, steering sensor, air conditioning
system, outside rear view mirror, front
power seats
37 SPARE 25 A Spare fuse
38SPARE30 ASpare fuse
FuseAmpereCircuit

Page 362 of 500

3626-3. Do-it-yourself maintenance
AVALON (U)_(OM41456U)■
Front
Bulb locations
Headlight low beam (halogen bulb)
Headlight high beam and daytime
running light (vehicles with
halogen bulbs for low beams)
Headlight high beam (vehicles with discharge bulbs for low
beams)
Fog light (if equipped)
Front turn signal/parking light1
2
3
4

Page 364 of 500

3646-3. Do-it-yourself maintenance
AVALON (U)_(OM41456U)■
Headlight low beam (halogen bulb)
Unplug the connector while
pressing the lock release.
Turn the bulb base counter-
clockwise.
Set the new light bulb.
Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn it clockwise to set.
Set the connector.
After installing the connector,
shake the bulb base gently to
check that it is not loose, turn
the headlights on once and visu-
ally confirm that no light is leak-
ing through the mounting.
Replacing light bulbs
1
2
3
4

Page 365 of 500

3656-3. Do-it-yourself maintenance
6
Maintenance and care
AVALON (U)_(OM41456U)■
Headlight high beam and daytim
e running light (vehicles with
halogen bulbs for low beams)/Headlight high beam (vehicles
with discharge bulbs for low beams)
Unplug the connector while
pressing the lock release.
Turn the bulb base counter-
clockwise.
Set the new light bulb.
Align the 3 tabs on the light bulb
with the mounting, and insert.
Turn it clockwise to set.
Set the connector.
After installing the connector,
shake the bulb base gently to
check that it is not loose, turn
the headlights on once and visu-
ally confirm that no light is leak-
ing through the mounting.
1
2
3
4

Page 438 of 500

4388-1. Specifications
AVALON (U)_(OM41456U)A: D4S discharge bulbs
B: HB3L+ halogen bulbs
C: HB3 halogen bulbs
D: H11 halogen bulbs E: Wedge base bulbs (amber) F: Wedge base bulbs (clear)
G: Double end bulbs
*: If equipped
Light bulbs
Light bulbsBulb No.WTy p e
Exterior
Headlights Low beam (discharge bulbs)
Low beam (halogen bulbs)
High beam

9005
900535
60
60A
B
C
Fog lights*55D
Front turn signal/parking lights 7444NA28/8E
Side marker lights W5W5F
Side turn signal lightsWY5W5E
Rear turn signal lights92116F
Back-up lights92116F
License plate lights W5W5F
InteriorInterior/front personal lights W6W 6 F
Interior/rear personal lights
8FVanity lights70651.4G
Door courtesy lights1685F
Trunk light1943.8F