engine TOYOTA CAMRY 1997 Repair Manual

201
NOTICE
Never recharge the battery while the
engine is running. Also, be sure all
accessories are turned off.
If the headlights or other electrical
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
See Fuse locationsº in Chapter 7-1 for
locations of the fuses.
Turn the ignition switch and inopera-
tive component off. Pull a suspected
fuse straight out and check it.
Determine which fuse may be causing the
problem. The lid of the fuse box shows the
name of the circuit for each fuse. See Part
8 of this manual for the functions con-
trolled by each circuit.
Checking and replacing fuses
ProCarManuals.com

202Type A fuses can be pulled out by using
the pull-out tool. The location of the pull-
out tool is shown in the illustration.
If you are not sure whether the fuse has
blown, try replacing the suspected fuse
with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the MIR
HTRº, DOMEº or A/Cº fuse, which may
be dispensable for normal driving, and
use it if its amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close as
possible to the rating. If the amperage is
lower than that specified, the fuse might
blow out again but this does not indicate
anything wrong. Be sure to get the correct
fuse as soon as possible and return the
substitute to its original clip.
It is a good idea to purchase a set of spare
fuses and keep them in your vehicle for
emergencies.If the new fuse immediately blows out,
there is a problem with the electrical sys-
tem. Have your Toyota dealer correct it as
soon as possible.
Never use a fuse with a higher am-
perage rating, or any other object,
in place of a fuse. This may cause
extensive damage and possibly a
fire.CAUTION
!
If any washer does not work or low
windshield washer fluid level warning
light comes on, the washer tank may
be empty. Add washer fluid.
You may use plain water as washer fluid.
However, in cold areas where tempera-
tures range below freezing point, use
washer fluid containing antifreeze. This
product is available at your Toyota dealer
and most auto parts stores. Follow the
manufacturer 's directions for how much
to mix with water.
NOTICE
Do not use engine antifreeze or any
other substitute because ti may
damage your vehicle's paint.
Adding washer fluid
ProCarManuals.com

mm (in.)
Part 8Dimensions and weight
211
SPECIFICATIONS
Dimensions and weight
Engine
Fuel
Service specifications
Tires
FusesP195/70R 14 tire
Overall length 4783 (188.3)
Overall width 1780 (70.1)
Overall height 1416 (55.7)*


Wheelbase 2670 (105.1)
Front tread 1547 (61.0)
Rear tread 1520 (59.8)P205/65R 15 tire
4783 (188.3)
1780 (70.1)
1419 (55.9)*


2670 (105.1)
1547 (61.0)
1520 (59.8)
Vehicle capacity weight
(occupants + luggage)
kg(lb): 410 (900)
*1: Unladen vehicle
ProCarManuals.com

212
Model:
5S-FE and 1MZ-FE
Type:
5S-FE engine
4 cylinder in line, 4 cycle, gasoline
1MZ-FE engine
6 cylinder V type 4 cycle, gasoline
Bore and stroke, mm (in.):
5S-FE engine
87.0 X 91.0 (3.43 X 3.58)
1MZ-FE engine
87.5 X 83.0 (3.44 X 3.27)
Displacement, cm
3 (cu. in):
5S-FE engine
2164(132.0)
1MZ-FE engine
2995(182.8)Fuel type:
5S-FE engine
Unleaded gasoline, Research Oc-
tane Number 91 (Octane Rating 87)
or higher
1MZ-FE engine
Unleaded gasoline, Research Oc-
tane Number 91 (Octane Rating 87)
or higher.
For improved vehicle performance,
the use of premium unleaded gaso-
line with a Research Octane Number
of 96 (Octane Rating 91) or higher is
recommended.
Fuel tank capacity, L (gal., Imp. gal.):
70(18.5, 15.4)ENGINE
Valve clearance (engine cold), mm (in.)
5S-FE engine
Intake 0.19'0.29 (0.007'0.011)
Exhaust 0.28'0.38 (0.011'0.015)
1MZ-FE engine
Intake 0.15'0.25 (0.006'0.010)
Exhaust 0.25'0.35 (0.010'0.014)
Spark plug type:
DENSO PK20TR11
NGK BKR6EKPB11
Spark plug gap, mm (in.):
1.1 (0.043)
Drive belt tension measured with Bor-
oughs drive belt tension gauge No.
BT-33-73F (used belt), Ibf:
5S-FE engine
With air conditioning
Generator belt 130 + 10
Power steering pump belt 80 + 20
Without air conditioning
Generator belt 95 + 20
Power steering pump belt 80 + 20
1MZ-FE engine 115 + 20
Engine Fuel Service specifications
ProCarManuals.com

213
ENGINE LUBRICATION
Oil capacity (drain and refill), L (qt., Imp.
qt.):
5S-FE engine
With filter 3.6 (3.8, 3.2)
Without filter 3.4 (3.6, 3.0)
1MZ-FE engine
With filter 4.7 (5.0, 4.1)
Without filter 4.5 (4.8, 4.0)
Oil grade:
API SH, Energy-Conserving IIº multi-
grade engine oil or ILSAC multigrade
engine oil is recommended.
Recommended oil viscosity (SAE):
Temperature range anticipated before next oil
change.
L70010
COOLING SYSTEM
Total capacity, L (qt., Imp.):
5S-FE engine 6.9 (7.3, 6.1)
1MZ-FE engine 9.1 (9.6, 8.4)
Coolant type:
With ethylene-glycol antifreeze
(Do not use alcohol type.)
BATTERY
Open voltage* at 20 C (68 F):
12.7 V Fully charged
12.3 V Half charged
11.9 V Discharged
*: Voltage that is checked 20 minutes af-
ter the key is removed with all the lights
turned off
Charging rates: 5 A max.CLUTCH
Pedal freeplay, mm (in.):
5'15 (0.2'0.6)
Fluid type:
SAE J1703 or FMVSS No. 116 DOT 3
MANUAL TRANSAXLE
Oil capacity, L (qt., Imp. qt.):
5S-FE engine 2.6 (2.7, 2.3)
1MZ-FE engine 4.2 (4.9, 4.0)
Oil type:
Multipurpose gear oil API GL-4 or GL-5
Recommended oil viscosity:
SAE 75W-90
AUTOMATIC TRANSAXLE
Automatic transmission
Fluid capacity (drain and refill),
L (qt., Imp. qt.):
5S-FE engine Up to 2.5 (2.6, 2.2)
1MZ-FE engineUp to 3.5 (3.7, 3.1)
Fluid type:
Automatic transmission fluid D-II or
DEXRON
[III (DEXRON[II)
ProCarManuals.com

214
Differential
Fluid capacity, L (qt., Imp. qt.):
5S-FE engine 1.6 (1.7, 1.4)
1MZ-FE engine 0.85 (0.9, 0.7)
Fluid type:
Automatic transmission fluid D-II or
DEXRON
[III (DEXRON[II)
BRAKES
Minimum pedal clearance when de-
pressed with the pressure of 490 N (50
kgf, 110 lbf) with the engine running, mm
(in.):
70 (2.8)
Pedal freeplay, mm (in.):
1'6 (0.04'0.24)
Pad wear limit, mm (in.):
1.0 (0.04)
Lining wear limit, mm (in.):
1.0 (0.04)
Parking brake adjustment when pulled
with the force of 196 N (20 kgf, 44 lbf):
6'9 clicks
Fluid type:
SAE J1703 or FMVSS No. 116 DOT 3STEERING
Wheel freeplay:
Less than 30 mm (1.2 in.)
Power steering fluid type:
Automatic transmission fluid DEX-
RON
[II or III
ProCarManuals.com

216
Engine compartment
Engine compartment (Canada)
Fuses (type A)
1. A/C 10 A: Air conditioning system
2. 10 A: Spare fuse
3. 15 A: Spare fuse
4. 30 A: Spare fuse
5. ALT-S 5 A: Charging system
6. HEAD (RH-HI) 15 A: Right-hand
headlight
7. EFI 15 A: Multiport fuel injection sys-
tem/sequential multiport fuel injection
system
8. HORN 10 A: Horn, theft deterrent sys-
temEngine compartment
9. HAZ 10 A: Emergency flasher
1 0 . A M 2 30 A: Gauge and meter, SRS air-
bag system, Multiport fuel injection
system/sequential multiport fuel injec-
tion system, IGNº and STº fuses
11. TEL 5 A: No circuit
12. HEAD (LH-HI) 15 A: Left-hand head-
light
13. RAD NO.1 20 A: Audio system
Fuses
ProCarManuals.com